line-ratio method 中文意思是什麼
line-ratio method
解釋
譜線比法-
A camera calibration method with co - line points is proposed, in which distortion center is located according to cross ratio invariability, and then distortion coefficients are calculated based on a line ' s central projection is a line
摘要提出一種用共線點列標定攝像機鏡頭畸變參數的方法，先根據交叉比不變性確定畸變中心，再利用直線的中心投影仍為直線這一性質確定畸變系數。 -
A separated - parameter method is proposed to calibrate the structure parameter. a vanishing line method is proposed to calibrate the normal vector of light plane and invariability of cross - ratio is proposed to calibrate the baseline length
並提出一種參數分離的方法對傳感器進行了標定，採用消隱線法標定激光平面的法矢量，利用交比不變原理標定激光平面的基線長度。 -
In the second part, for the purpose of poverty identification, we elaborate the poverty line and its types. by incorporating its determinants, i. e. minimum demand, income and other factors, the problem to choose poverty line is explored. we explained some popular methods to determine a poverty line, that is, shopping basket method, engle ’ s ratio method, international poverty line standard and life style method
從貧困的識別看，在定義並劃分貧困線之後，從最小需求和收入兩個基本要素出發，結合其他因素來確定貧困線，並著重分析了市場菜籃法、恩格爾系數法、國際貧困標準法、生活形態法四種主流的貧困線測量方法。 -
The use of interferometer to detect and analyze laser radiation is well known, but when the intense ratio of the laser radiation to the background natural light radiation is too small, the laser radiation cannot be detected. a novel more sensitive method for detect of wideband weak incident laser in strong background noise is introduced in this paper. the optical unit uses two wedge interferometers and two line array detectors. the incoming light radiation is divided into two beams and through the interferometers
在被動激光偵察告警中，對微弱脈沖激光信號的探測是一個難點。當探測距離相當遠或視場內接收的背景光輻射很強時，脈沖激光信號到達探測器的能量很小，會淹沒在強大的背景光信號中而探測不到。本論文提出了一種探測微弱脈沖激光信號的方法，可對強烈背景光中的激光威脅信號進行探測和告警，並給出其波長參數。 -
Measuring frequency of received signal by a spectrum line ratio method
譜線比值法測量接收信號的頻率 -
Based the humidity theory, the paper adopts the relative humidity as the character value and puts forward using 30 % rh and below 0c dew - point as the on - line monitoring critical value. it gives the method of volume ratio convert at the different temperature. with the standard value, we can conclude the result of moisture content
針對現有規程標準中控制水分的指標的缺點和局限，提出了採用相對濕度作為監測特徵量並轉換為露點以直觀表示設備絕緣狀況：採用30相對濕度及0以下露點作為監測的臨界值與允許值；同時推導出了體積比單位在不同溫度下的折算方法，以結合現有標準，綜合分析，做出判斷結論。 -
In addition, simultaneously interpenetrating polymer networks ( sin ) damping materials were originated from polysiloxane oligomer - containing different molar ratio methylphenylsiloxane and different methacrylate. applying the weight method and ftir monitor on line, the synthesis reaction procedure of polyacrylate copolymer and sin was traced. the polymerization mechanism of the functional groups with vulcanizing capability, aid - vulcanization action of bim as well as the sin structures were elucidated by 1h nmr and 13c nmr
採用稱量法和ftir在線追蹤，對合成聚丙烯酸酯共聚彈性體和sin的反應動力學進行了研究，並用~ 1hnmr和~ （ 13 ） cnmr等對硫化官能團的引入，雙馬來酰亞胺助硫化機理，和sin的結構進行了表徵。 -
During this paper, definition of the measure enter - cover - probability is given, andthree - dimension detection space are transformed to level detection circles on differentheights. aiming at the most normal situation of symmetric line, cross - to line and cross - awayline taken by the carrier, probablely - enter - cover - target - distribution are analysed in relativemovement method on the premise that targets fly perpendicular to the flying direction of thecarrier. mont - cario method is used to simulate uniformly - distributed - targets situation and getthe measure, and results are used to analyse the influence of line - landscape - orientation - ratio, line - portrait - ratio, and speed - ratio on the measure. for further research, influences of height and blind space are also discussed on base ofradar level detection range, and situations of non - uniformly - distributed targets are alsoresearched
為了分析主動探測空間動態性能，本文首先提出以「目標進入雷達覆蓋區概率」 （簡稱為「覆蓋率」 ）作為評價指標;然後將三維探測空間轉換為不同高度層對應的水平探測圓，針對載機採用雙平行航線、交叉相向航線和交叉同向航線的最一般情形，採用相對運動的方法，分析目標垂直入侵時可能進入雷達覆蓋區的目標分佈情況;再運用蒙特卡洛法進行模擬計算，分析並比較目標服從均勻分佈時航線橫比、航線縱比及速度比對性能的影響。 -
Line - ratio method
譜線比法 -
An on - line measuring method of moisture ratio in molding sand
一種型砂含水率的在線檢測方法 -
Since that the choosing line hardware for the neutral ungrounded system has just passed part of the dynamic simulative test, matlab software was chosen to do a lot of simulative tests on single phase - to - grounding fault. and the simulative sampling ratio is almost the same as the hardware ' s. because there is a low wave filter in the hardware, i choose the db15 wave - let to carry out the multidimensional decomposition on the sample by the method of one dimension discrete wavelet in order to obtain low frequency signal including the high frequency transient information on single phase - to - grounding fault
鑒于實驗室已有的小電流接地系統選線硬體的研製只通過了實驗室里的動模試驗，故選用matlab軟體對小電流接地系統進行大量的單相接地故障模擬試驗，模擬的采樣率和硬體基本一致，由於硬體中帶有低通濾波器，故在進行采樣數據的morlet小波分析時先採用db15小波對采樣進行一維離散小波的多尺度分解，使得分解得到的低頻信號剛好包括了小電流接地系統單相接地故障時的暫態高頻信息，然後對這一信息再繼續進行小波演算法分析，分析結論表明利用變換后的實部、虛部和模值能夠較準確的實現單相接地故障時的故障選線和暫態高頻分量的提取。 -
Through analyzing the ball milling process, and based on radiate basis function ( rbf ) network, a soft sensor method was presented to estimate the ball mills charge ratio of media ( crm ) on line, which couldn ' t be measured on line in the past
摘要通過對磨礦過程原理的分析，提出了基於徑向基（ rbf ）網路的軟測量方法，對以往無法在線檢測的球磨機關鍵參數介質填充率進行實時估計。 -
Two wedge interferometers are designed that the thickness of one is higher than the other. so when the incident coherent light through the interferometers can acquire two fringe patterns which having space shift, but the incident incoherent light only result in consistent intensity signal. through a differentiating amplifier, two signals subtract which can eliminate noise of background and result in higher contrast ratio fringe signals. this method largely improves the system and the ability of detection. the spacing of line fringes is a function of incident laser wavelength, by analyzing, we can extract the wavelength of incident laser. the optical unit analyzing and results also simulated with matlab
當背景光入射時，直接穿過干涉儀，僅發生強度的衰減，在兩個探測平面上產生幅度基本一致的灰度信號，通過差分放大器，相消為零，從而抑制了背景干擾。當激光信號入射，穿過干涉儀時受到調制，在探測平面上產生干涉條紋。通過所設計的存在平均厚度差的雙楔形干涉儀，兩路干涉條紋圖案出現相對移位：在兩個探測平面對應的位置上，一路出現亮紋，另一路出現暗紋。
分享友人