load classification 中文意思是什麼

load classification 解釋
載貨分類
  • load : n 1 裝載,擔子;負擔;工作(負荷)量。2 (車船等的)裝載量;一馱,一車,一飛機。3 【電、機】(機...
  • classification : n 1 選別;分等,分級;分選。2 【動、植】分類(法)。 〈分類級別為: phylum 【動物;動物學】及 div...
  1. The paper is based on innumerable practical heavy - load road data, deliberate heavy - load standard in detail through theoretical arithmetic, and bring heavy - load standard about cement concrete pavement and asphalt concrete pavement separately ; in the meantime, through a large quantity of cement concrete pavement stress calculation, the paper puts forward relation expression between load on concrete board and stress level under board ; meanwhile, the paper puts forward traffic classification about cement concrete pavement and asphalt concrete pavement ; through bearing board testing on each structure sheaf the paper finds the material modulus gets modified ; through comparing position equivalent rebound modulus to theoretical equivalent rebound modulus, the paper points out limitation of nomograph in course of cement concrete pavement design, whereby, puts forward modifier formulas about theoretical equivalent modulus

    本文以大量的重載道路資料為主,從實際出發,結合理論計算,對重載標準進行了詳細的討論,分別給出了水泥混凝土路面與瀝青混凝土路面的重載標準了;同時,通過大量的水泥混凝土板底應力計算,推導出了混凝土面板荷載與板底應力水平的關系式;給出了水泥混凝土路面與瀝青混凝土路面的交通分級;通過對試驗路各結構層進行承載板測試,發現現有材料模量較以前有了明顯的提高;對比現場實測的當量回彈模量與理論當量回彈模量,指出現有水泥路面設計中的諾謨圖不能完全符合現有道路材料,從而提出了對理論模量的修正公式。
  2. Windows and doors - resistance to wind load - classification

    門窗.抗風性.分類
  3. The effect factors of boiler steel frame are analyzed, loads composition and structural distribution, also the design code and special value norm for load classification are discussed, mainly including state and live loads, wind and level earthquake

    分析了電站鍋爐鋼結構的荷載影響因素,提出合理的結構布置和荷載取值及其工況組合。分析了設計標準中的荷載分類及取值約定。
  4. Adhesives for load - bearing timber structures - casein adhesives - classification and performance requirements

    承重木材結構用膠粘劑.乾酪素膠.分類和性能要求
  5. Adhesives for load - bearing timber structures - casein adhesives - classification and performance requirements ; german version en 12436 : 2001

    承重木結構用粘合劑.酪蛋白粘合劑.分類和性能要求
  6. Adhesives, phenolic and aminoplastic, for load - bearing timber structures : classification and performance requirements

    承重木結構用酚醛和氨基塑料粘合劑:分類和性能要求
  7. Industrial, commercial and garage doors and gates - resistance to wind load - classification

    工業商業和汽車庫門.抗風力.分類
  8. In this thesis, two kinds of load density forecast methods are introduced, classified - divisional load density method and classification method based on artificial neural network and fuzzy theory

    本文介紹了兩種負荷密度預測方法:分類分區預測法及基於神經網路和模糊演算法的聚類分析方法。
  9. Allowing for the factors affecting the load forecast in the practical engineering project, i compare the characteristic and their applicability of the above spatial load forecasting methods, and then get the following results. the classified - divisional load density method has tendency to be affected by human factors, but the classification method based on artificial neural network and fuzzy theory can make up with this fault

    考慮到實際工程項目中影響負荷預測的各種因素,我對上述幾種空間負荷預測方法的特點和適用范圍進行了分析比較,認為分類分區預測方法受人為因素影響太多,特別是對于缺乏歷史數據的新區進行負荷密度預測,往往不能得到滿意的結果,而基於神經網路和模糊演算法的聚類分析方法可以彌補這一缺陷。
  10. Industrial, commercial and garage doors and gates - resistance to wind load - classification ; german version en 12424 : 2000

    工業商用和車庫門和大門.抗風力載荷特性.分類
  11. Design target reliability index is used as a jumping - off point, load - capacity reduced rate regulated in specification for highway maintain and technology is used as classification measure to divide bridge sorts, evaluation criterion is setup used for secondary highway bridge and its members. scientific theory foundation is built up for formulating rational maintains and reinforced scheme

    本文以設計目標可靠指標為起點,通過調整《公路養護技術規范》 ( jtj073 - 96 )中規定的承載能力降低率作為分級尺度來劃分橋梁類別,建立二級公路橋梁結構構件的評定標準,為制訂合理的維修加固方案提供合理的理論依據。
  12. The major achievement of this dissertation is outlined in the following : 1. investigate the potential effect of switch routing on end - to - end service quality with both theoretical and experimental methods : it is found that service quality of lsp is better than that of ip routing if load on router is low or end - to - end bandwidth reservation is implemented, but lsp is more sensible to load on router. mpls must be used in company with policy based routing and packet classification to provide end - to - end qos service in internet ; 2

    使用理論分析和實驗測試相結合的方法詳細分析了交換路由對端到端傳輸質量的影響:研究表明,在鏈路輕載或預留帶寬的情況下,交換路由系統對數據流的服務質量優于傳統路由系統;只有綜合應用策略路由、數據報分類調度和標簽交換才能有效實現internet環境下對端到端服務質量的控制; 2
  13. But due to the complexity of factors influencing fatigue performance, such as wave load and pressure from cargo, the combination of different stress components, stress concentration of local structure details, mean stress and the corrosive environments, etc, there are different specifications with varying classification societies, so it will lead to the diversity of results from different fatigue assessment methods

    但是,由於影響結構疲勞性能的因素十分復雜,如波浪載荷和局部的貨物壓力,各種應力成分的組合,結構的局部細節應力集中,平均應力的影響,結構分身所處的腐蝕環境等等,所以各個船級社有關的規定也不一樣,這樣必然造成各個評估方法之間的差異。
  14. This paper introduced the composition and classification of suspendome, generalized the nonlinear finite element computing methods. analysis to suspend - dome and single layer reticulate is conducted separately to the five type suspendomes which have same span but different rise - span, including force, displacement, eigenvalue buckling, nonlinear buckling, load - displacemnt tracking and nonlinear ultimate carrying capacity, every performance of suspendome was expatiated in the paper

    通過對同一跨度、不同矢跨比的5種弦支穹頂結構和單層網殼進行的靜內力、節點位移、結構體系應變能、特徵值屈曲、非線性屈曲、非線性極限承載力、荷載-位移平衡路徑跟蹤分析和比較,闡述了弦支穹頂結構的各項性能,通過與單層網殼的比較,闡明了弦支穹頂結構的優越性。
  15. The paper attempt to applied sequential cluster method to set up the classification standard, then it regards the correlation coefficients of record values as weights and predicts the future loads by using markov chain model with weights. this method make the best of the information comprised in load series and solved the problem of obtaining weather information. not only the concrete value of the monthly sales electric energy but its range in the future is gained

    實際上,各月份的氣象、經濟因素之間具有一定的相關性,這些相關信息已經包含在負荷序列中,本文嘗試將馬爾可夫鏈理論應用於負荷預測之中,應用聚類分析的方法確定分級標準,將負荷分為不同的狀態,根據狀態之間的轉移概率來推測未來負荷的發展變化,並將觀測值之間的相關系數作為權值進行綜合預測,更加合理地利用了負荷序列中包含的信息,不僅可以預測出未來負荷的具體值,而且得到了其所屬的區間,具有一定的實用價值。
  16. The parameter sensitivity of induction motor load model is studied. a new approach based on fuzzy c - means clustering is proposed for the classification of dynamic load characters

    分析了感應電動機綜合負荷模型參數靈敏度,介紹了模糊聚類的分類方法,提出了基於模糊c均值聚類的負荷特性分類方法。
  17. This paper introduces the conception, classification, influence on organism and indication of allostatic load in modern stress theory

    摘要本文介紹了現代應激理論中「非穩態負荷」的概念、分類、對機體的影響及其意義。
  18. In this part, we apply the classification of tasks and add a load balance factor. we submit tasks to grid resource relatively idle and make the task dispatcher and load balancing effectively

    同時通過增加負載平衡因子和應用任務分類等方法,將用戶提交的任務更加合理的映射到相對空閑的網格資源上,有效地實現了任務的合理調度和負載均衡。
  19. This article presents briefly the means of long and medium power load forecasting along with its limitation, and expounds how to use fuzzy classification for imitating the experts system to forecast power load. some examples are given

    簡要地介紹了中長期電力負荷預測方法的類型及局限,詳細地闡述了如何用模糊聚類等方法模擬專家分析預測過程的新思路,並給出實例。
  20. The authors have observed the progress of deformation and destruction of coal bodies in the experiment, carried out the macroscopic and microscopic research of the destruction progress of coal samples under load by means of servo electro - hydraulic loading test and electromagnetic radiation and audio emission monitoring, analyzed the cracking rate of coal samples under different situation, investigated the formation and development of cracking by use of fracture and elasticity mechanics, and thus established a sound experimental basis for the prediction by using gray classification

    摘要進行了煤體變形破壞過程實驗,利用電液壓伺服加載試驗、電磁輻射和聲發射監測手段,從宏觀、細觀、微觀三個方面對煤樣受載破裂過程進行試驗研究,分析煤樣的裂隙發展速度及其所處的不同的狀態,並參照目前的預測方法提出了煤與瓦斯突出危險狀態灰色分類方法。
分享友人