load condition 中文意思是什麼

load condition 解釋
承載狀態
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  • condition : n 1 狀態，狀況，情形；品質。2 〈pl 〉外界狀況，周圍情形。3 地位，身分。4 條件；【語法】條件子句。...
  1. We introduce two thresholds of the packet loss ratio to divide the network load condition into three status : congest, normal, idle

    通過兩個門限值c 、 _ ，將網路的負載狀況分為擁塞、適中、空閑三種狀態，進一步減小發送速率的振蕩頻率。
  2. Then the air distribution system of the above - mentioned hotel ' s multi - function - hall was simulated with fidap, and the indoor temperature and velocity under the preliminary option was calculated. under the half - load condition of small air - supply quantity and slow velocity, finds that the problem has arisen, which the cold jets fall too fast in summer and the air distributes layer upon layer in winter

    然後應用fidap對上述旅館的多功能廳空調氣流組織初步方案進行了數值模擬計算，預測了該初步方案的室內溫度、速度分佈，發現在送風量和送風速度小的半負荷工況下，會出現夏季送風時冷射流過早下降，冬季送風時氣流分層分佈的現象。
  3. As a result of the simplified torsion moment of inertia, integral stability coefficients based on the gb50017 code increase relatively 5 % or 0. 01 ~ 0. 04 absolutely, only for hn behind hn400 150, whose calculation length goes beyond the limit of 8 meters, taking account of any load condition and any yield - point

    Gb50017梁的整體穩定系數公式的誤差是由扭轉慣性矩的簡化造成。任何荷載情況和鋼號，規格大於hn400 150的hn型鋼，當計算長度大於8米時，整體穩定系數偏高約5 ，絕對偏高量在0 . 01 0 . 04范圍。
  4. This project makes some researches with emphasis on the mv / lv distribution power supply situation under the present load condition. some results such as the calculation of line load rate, theoretical line consumption rate and electric voltage decrease are acquired by the mathematical analysis, and thus the power supply capability is evaluated comprehensively. the same has been done to the lv power network

    課題在系統搜集分析蘇州供電企業的背景資料，即企業概況、電力需求、輸電網、高壓配電網狀況基礎上，重點研究了當前負荷下的中低壓配電網供電情況，並通過數學分析得出線路的負載率的計算、理論線損率以及電壓降等各項運行指標，綜合評估得出其供電能力。
  5. For separated push rod, switch on, under no - load condition, the oil cylinder makes reciprocating movement for several times, to discharge air in the cylinder and oil pipeline, then adds load

    分體推桿，接上電源讓油缸在無負載情況下，往復動作數次使油缸和油管中空氣排出、再帶上負載。
  6. Thirdly, the structure resistance theory probability model and the load action effect theory probability model are amended according to the main - beam ' s damage and load condition of the used beam - bridge. thus the structure resistance assessment probability model and the load action effect assessment probability model of the used beam - bridge are deduced in this way and they are practical

    再次，根據在用梁橋的損傷情況和荷載狀況，對其結構抗力和荷載效應理論概率模型進行修正，得到實用的在用梁橋結構抗力和荷載效應評估概率模型。
  7. Offline control strategy refers to work under known load condition, according to the load condition calculate the instruction voltage, then store them in the datasheet, each time read the instruction voltage from the datasheet, when input dc bus voltage changes, a pi controller is used to adjust the instruction voltage thereby fix the output voltage rms

    離線型控制是指在已知負載的情況下，計算出控制用的指令電壓，存在數據表中，每次讀取表中的數據，當輸入母線電壓變化時通過pi調節調整指令電壓來控制輸出電壓。由於計算量不大，用單片dsp就可以實現指令電壓的計算和svm演算法，主要用於負載情況已知且固定的場合。
  8. The efficiency is very high, especially under low load condition, because the output voltage is regulated by skipping clock cycles as necessary

    該電荷泵採用跳周期（ skipcycles ）控制模式，具有在輕負載情況下效率高的顯著優點。
  9. In this paper, it is studied and analyzed characteristic of stress, distortion etc. of pipe liner structure combining dahuofang transport water tunnel practice project, tunnel boring machine construction, and it is considered that affects internal force of pipe liner for early stress of underground structure and digging load. in nonlinear finite element calculation model, folium cells have been simulated among pipe liner and pipe liner and wall rock. under varies load condition, it has educed that changing rule of stress, distortion and load characteristic pipe liner in kinds of wall rock tunnel by analysis and calculation

    本文結合實際工程，分析研究了大夥房水庫輸水隧道工程在採用掘進機施工方法的情況下，利用管片襯砌的結構應力、變形等受力特性，考慮地下結構初始應力和開挖荷載對襯砌內力的影響，採用薄層單元模擬襯砌管片之間、襯砌管片與圍巖之間的非線性有限元計算模型，通過分析計算得出不同荷載工況下各類典型圍巖段隧道襯砌管片受力特徵、應力和位移變化規律。
  10. Theoretical and experiment researches of transmission mechanism and control strategy of the cvt have been carried out under the project ( 59835160 ) financed by national natural science foundation which includes follow content : 1 ) the kinematic relation of the metal pushing v - belt type transmission is analyzed. the relation among oil pressure of pulley cylinder, transmission ratio and input torque under load condition is studied. optimal design method for metal pushing v - belt type continuously variable transmission is put forward

    本文在國家自然科學基金重點項目（資助號： 59835160 ）資助下，對金屬帶式無級變速傳動系統的傳動機理、匹配及控制策略等進行了系統深入的理論分析和實驗研究，具體研究內容如下： 1 ）系統地分析了金屬帶無級變速傳動的基本運動規律，研究了在負載狀態下，帶輪油缸壓力與速比和輸入轉矩的關系，提出了對金屬帶式無級變速傳動系統進行優化設計的方法。
  11. Ann is a adaptive and non - linear dynamic system made from superposition of many simple components which we call neuron. the question for computation of d _ ( cmax ) belongs to incipient motion of sediment in essence, which is the same question with two different sides, because computation of critical condition ( including critical velocity critical shear stress critical power ) for a grain size under a bed - load condition is equal to computation of a grain size during incipient motion under the bed - load condition and the water flow condition given before. and computation of gross bed - load transport rate has great relationship with standard of incipient motion

    對于d _ （ cmax ）的推求，在本質上還是泥沙的起動問題，因為尋求某種床沙條件下某級泥沙的起動條件（如起動流速、起動切應力、起動功率）和尋求某種水流和床沙條件下的起動粒徑是同一問題的兩個方面而已；而對于推移質總輸沙率推求也和泥沙起動問題中的起動標準選擇緊密相關。
  12. A study on the structural deformation of a special dam body with a comprehensive analysis method is presented, by taking section 33 of the qingtongxia dam as an example. the dam block is located at the abutment on the right bank, like an “ earth - retaining wall ”, whose cross section is “ high - heeled shoe ” sheped. because of the special structure and load condition, its deformation toward the downstream is large. deep research of its deformation law is conducted, and analysis of the special structure, the boundary condition of this dam block is performed, and the physical genesis of the large deformation of the dam block is revealed

    以青銅峽大壩33壩段為例，提出應用綜合分析法研究特殊壩體結構的變形規律.該壩段位於右岸壩頭，類似一「擋土墻」 ，斷面形狀如「高跟鞋」 .由於結構及受力條件特殊，產生了向下游的較大變形.本文應用綜合分析法（多種模型分析、結構計算等）對其變形規律進行了全面的分析研究，並重點對該壩段的特殊結構和邊界條件進行深入分析研究，弄清了該壩段向下游有較大變形的物理成因
  13. It comes to a pulse skipping mode in a low load condition to decrease power loss and increase the operation efficency

    電路的另一個特點是在輕負載時進入跨周期調制模式以減小功耗並提高效率。
  14. This paper discusses the influence of several parameters in heat release rate formula on the working process and proceeds with numerical simulation to the working process in part load condition according to the locomotive character

    本文討論了放熱率中幾個參數對工作過程的影響，並且按牽引特性對部分工況進行了計算。
  15. The mathematical model of multi - loop, which is improved through selecting new stator loops in this paper, can be used to simulate the transient behavior of external short circuit at machine ' s terminal and internal short circuit in the stator, not only under no - load condition with single machine but also under load condition connected to power network

    本文改進了原來的多迴路數學模型中對定子迴路的選擇，不僅可對同步發電機機端各種外部短路故障和單機空載下的各種定子內部故障進行暫態過程的模擬，還實現了負載時內部各種故障的暫態模擬。
  16. However these converters become more complicate. phase - shift zvs technique has been used in bidirectional dc / dc converters since it can realize zvs for all switches without auxiliary switches. however when the amplitude of input voltage is not matched with that of output voltage, the current stresses and rms currents of the converters become higher, in addition the converters can not achieve zvs under light - load condition

    諧振、準諧振或多諧振技術方案，變換器的電壓電流應力較高，變頻控制增加了濾波器設計的難度；能量緩沖吸收電路或有源鉗位電路方案，由於需要增加多個額外輔助元件，增加了變換器的復雜性；全橋相移技術方案，由於主電路無需增加額外元件，只需利用相移控制，即可實現軟開關，因此引起關注。
  17. The thesis also makes a study of the combustion optimization of boiler at the part load condition through testing, and draws some useful conclusions

    對電站鍋爐低負荷運行（深度調峰）時的燃燒優化問題，也通過試驗的方法進行了研究，得出一些有用的結論。
  18. From the above analyses, the conclusions can be made as followed : under the present load condition, suzhou urban mv / lv distribution power network should have the sustainability ; when the load increases by 20 % or 40 %, a few mv / lv lines will be unable to meet the load demand

    從以上幾個方面分析，得出「研究」的結論。即在當前負荷下，蘇州城市中低壓配電網應當具有承受的能力；而當負荷發展到1 . 2 、 1 . 4倍時，將有少部分中低壓線路不滿足負荷需求。
  19. To save energy, choose high efficiency chillers, and decide the unit number basing on the part - load condition. the number of water pumps should be synchronized with the chillers

    空調系統為了節能應該考慮選用高能效比的熱泵機組，根據機組部分負荷時的特點和效率確定合理的臺數，水泵選取數量與熱泵機組相同。
  20. As a fast algorithm, the whole control system can be realized based on a dsp, but this control strategy can ’ t work under unknown load condition. according to the offline control strategy, a prototype is made in this paper

    由於計算量較大，採用dsp和fpga來共同控制， dsp負責采樣和計算指令電壓，計算出指令電壓后把指令傳給fpga ， svm演算法在fpga內完成。
分享友人
分享到 Line

分享到臉書