load relay 中文意思是什麼

load relay 解釋
負荷繼電器
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  • relay : n 1 接替的馬；驛馬；接替的狗；（備有接替馬匹的）旅館。2 接替；接替人員；補給供應。3 分程遞送；傳...
  1. Breaker, refrigerator over - load protection relay, refrigerant high pressure switch, air circulator thermal switch, fuse, overheat protector, alarm

    無熔絲開關，壓縮機超載保護開關，冷媒高壓保護開關，超溫保護開關，水盤缺水保護開關，電磁開關，故障警告系統，警報器
  2. Ssr - dd series of dc solid relay is vastly applied to output joggle of computer and external equipments, it is also applied to control or switch dc load : dc relay 、 contactor 、 dc electrical motor 、 kinds of electric - heating apparatus 、 dc electromagnetic valve 、 electromagnetic iron 、 solenoid 、 filament lamp 、 indication lamp 、 plc logical electrical appliance and dc solid relay

    Dd系列直流固態繼電器廣泛應用於計算機與外部設備的輸出介面，適用與控制或開關直流負載：直流繼電，接觸器、直流電動機、各類電熱器具；直流電磁閥，電磁鐵、螺線管、白熾燈、指示燈； plc邏輯電器。
  3. Load power supply selective relay

    負載電源選擇繼電器
  4. This paper discusses the ability of avoiding maximal power flow of quadrilateral impedance relay and round impedance relay in detail and puts forward the setting principle and setting method of load limiting resistor of backup distance protection

    本文對四邊形和方向圓特性阻抗繼電器躲線路最大潮流的能力進行了詳細分析，提出了距離保護負荷限制電阻的整定原則和整定方法。
  5. The controller can output four teams of relay contact signal overload, full - load, half - load and light - load

    控制儀可輸出4組8路繼電器觸點信號
  6. Controller can output four teams of light - load, half - load, and full - load and overload relay contact signal, and 010ma, 1010v or 010v analog signal

    可輸出輕載半載滿載超載四組繼電器觸點信號和010ma 1010v或010v的模擬信號。
  7. The actual load is compared to four limit values, and by achieving the limit value, the relay of the crane controller could be switch

    實際的裝載量靠近極限值的同時，又不斷與四個極限值相比較。起重機控制電容可以作為開關。
  8. The ability of power network maintaining its power supply reliability and quality is restricted by power network structure, line and load characteristics, generator drive device characteristics and relay protection mechanism

    電力網路維持其供電可靠性及電能質量的能力是受電網結構、線路和負荷特性、發電機動力設備特性以及繼電保護機制等因素影響的。
  9. Study of a novel over - load relay

    新型過載繼電器的研究
  10. This testing system is based on the pxi bus virtual testing system. there are many secondary types of equipments in the system. such as the programmable power supply, high voltage probe, high voltage relay, high voltage load and pneumatics

    本文以pxi總線虛擬測試系統為核心，輔以程式控制電壓源、高壓衰減探頭、高壓繼電器、高壓放電負載及氣動裝置，分別設計組裝了主機櫃與測試櫃，完成整個自動測試進程。
  11. In the system, the low voltage power line is the first signal tunnel without any other relay equipments between customer terminal and substation collector, public telephone line serves as the second signal tunnel between substation and management center computer. as a breakthrough of conventional concept of electricity meter, this thesis initiate a new concept, namely, intelligent power customer terminal ( shortly, customer terminal ), which is developed with spread spectrum plc communication functional and possesses many advanced functions, such as, in addition to electric energy acquisition, guarding against electricity pilfering, preventing wrong connection, protecting malfunction, remote communication ( for example, remote power supply or halt, remote configuration of electricity meter, remote load control, etc ), and so on

    本文首先系統地總結了目前國內外低壓電力網數據傳輸技術的研究現狀和存在的問題，在此基礎上，從理論上論證了在低壓電網上應用擴頻載波數據通信技術的可行性和優越性，並重點論述了擴頻載波技術抗電力線噪聲干擾的機埋；本文提出了一個新穎的基於低壓電力線擴頻載波通信技術的集中遠抄系統的總體方案，即由用戶終端、集中器和電能管理系統所組成的網路系統，其中，用戶終端到配變集中器用低壓電力線作為通道，中間無需其他硬體中繼設備，集中器到電能管理系統用公用電話網作為通道。
  12. The transformer that use solid state relay to realize automated regulation is explored in this issues, it change the winding turn of once side according to the voltage of second side by on - load tap - changer. thus the purpose to realize automatic steady voltage

    本課題研製的應用固態繼電器實現的有載自動調壓變壓器，通過自動有載調壓分接開關根據變壓器二次側的電壓自動改變變壓器一次側的匝數，從而實現自動穩壓的目的。
  13. The electricity accuse partly adds to load to count to be apparent the time relay and counts to be apparent the counter, convenient

    電控部分加裝數顯時間繼電器數顯計數器，方便操控。
  14. The electricity accuse partly adds to load to count to be apparent the time relay and counts to be apparent the counter, convenient to operation

    電控部分加裝數顯時間繼電器數顯計數器，方便操控。
  15. Along with the development of power system, more and more generators and ehv transmission systems are put into operation. there come many new situations, such as the lengthening transmission distance, the heavier load, the increasing transient elements during the transient process. these new conditions influence the correct working of relay protections

    隨著電力系統的不斷發展，大容量發電機組和超高壓輸電系統的相繼投入運行，系統中出現了許多新的情況，如輸電距離增大、負荷加重、故障暫態過程中的暫態分量大大增加、持續時間變長等，這些情況對目前常用的各種繼電保護方法的正確動作會產生許多不利的影響，甚至不能正常運行。
  16. Lastly, we arrive a conclusion on test condition of relay ' s electrical life - test device when simulating motor load. this kind of test condition includes the voltage across relay ' s contacts and current through its loop circuit

    最後總結得出繼電器電壽命試驗設備模擬電動機負載時的試驗條件，其中包括繼電器的觸點電壓和迴路電流條件。
  17. Firstly, begin with building a mathematical model of relay ' s load, or a single - phase asynchronous motor, we analyze the transient process of the spam when it starts and stops by means of qualitative and quantitative methods

    首先從繼電器的負載?單相異步電動機的數學模型的建立入手，分別從定性和定量兩個角度對單相異步電動機的起動和停止時的瞬態過程進行分析。
  18. The chongqing electric power load system was set up in 1992, and by 1996, a control center composed by novell network, six bi - directional relay transmit stations, 2 unilateral transmit stations and 1260 diversified terminals have been established, which covered areas managed by the former electric power bureau of chongqing. the system scope of the established electric power system was on the top place among the large and middle cities over the country

    重慶電力負荷控制系統始建於1992年，到1996年時，已建成了一個由novell網路構成的控制中心、 6個雙向中繼轉發站、 2個單向轉發站、各類型終端1260多臺，覆蓋原重慶電業局所轄供電區域。系統規模在當時全國各大中城市建立的電力負荷系統中居首位。
  19. To test the time parameter, namely, is to test the operate time, release time and bounce time when the relay ' s winding is put or removed the rated voltage. these parameters ( especially the bounce time ) are very essential to relay ' s rated load

    檢測時間參數的目的是檢查繼電器在線圈施加或切除額定電壓時的動作、釋放、回跳及穩定時間，這些參數（特別是觸點回跳及穩定時間）對繼電器通過額定負載是很重要的。
  20. It has the characteristics of fault component relays such as being immune to the load and the system operating mode and the zero sequence components required by the relay can he easily acquired and available for a long time

    由於採用零序電量作為判斷依據，新方法具有受兩側電源角度的影響小，且受負荷、系統運行方式的因素影響小的特點。
分享友人
分享到 Line

分享到臉書