load-displacement curve 中文意思是什麼
load-displacement curve
解釋
荷載-位移曲線- load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
- displacement : n 1 轉位，移動；取代，置換；（人的）流離失所。2 撤換，免職。3 【機械工程】（活塞）排氣量；【航海...
- curve : n 1 曲線；彎曲；彎曲物。2 曲線規 （＝French curve）；【機械工程】曲線板；【棒球】曲線球；【統計學...
-
First, using strip - partitoning method and programming in matlab language, the numerical caculations of the relation curve between moment and curvature are done for the beams strengthened with non - prestressed and pretressed cfrp sheets, base on the assumption of plane section, non - bonding slip and non - peeled destroy. secondly, nolinear finite elemeant analysis by ansys are done for the beams strengthened with prestressed cfrp sheets base on the three assumptions before mentioned, the analysis are all done for the relation curve between load and displacement, the distribution of material stress, the distribution of cracks. lastly, calculation formula of flexural capacity and deflection are proposed
）的全過程關系曲線。其次基於上面的三個假定，選擇合理的本構關系，利用ansys通用有限元分析程序對預應力碳纖維布加固梁進行非線性有限元分析，分析了加固梁的荷載-撓度關系、材料的應力情況、裂縫的分佈情況等。最後提出了承載力計算公式和正常使用狀態下撓度計算公式。 -
According to the recorded full process fracture curve, the paper calculated and compared the fracture toughness ( kic ), the fracture energy ( gf ) and crack tip opening displacement ( ctod ) of the different strength grade boulder concrete and crushed stone concrete, it is found that the maximal load ( fmax ) and the fracture toughness ( kic ) of boulder concrete and crushed stone concrete increase when the strength of them increases, so does the fracture energy of boulder concrete, but the fracture energy of crushed stone concrete does n ' t obviously increase when it ' s strength increases. the crack tip opening displacement ( ctod ) of all specimens chang less when the strength of concrete increases, so it is concluded that the location of the axle in the ligament of the specimens is relatively stable
根據記錄的全曲線，計算了不同強度等級的卵石混凝土、碎石混凝土的斷裂韌度k _ （ ic ） 、斷裂能g _ f以及裂縫的尖端開口位移ctod ，比較了不同強度等級卵石混凝土及碎石混凝土的斷裂韌度k _ （ ic ） 、斷裂能g _ f以及裂縫的尖端開口位移ctod的關系，發現卵石混凝土、碎石混凝土的荷載峰值fmax 、斷裂韌度k _ （ ic ）隨強度增加而增加，卵石混凝土的斷裂能g _ f隨強度增加而呈增加趨勢，碎石混凝土的斷裂能g _ f隨強度增加變化趨勢平直，增勢不明顯。 -
Comparison including the cracking, yielding and ultimate loads of the beam, load - displacement curve, envelop curve, the ductility and energy - dissipation capacity were made between the response of the specimens before and after strengthening. test results indicated that the yielding loads of the specimens after strengthening were improved from 12. 3 percent to 17. 2 percent and the improvement of specimens rehabilitated by jacketing was higher than that of the bonding steel plates one
加固后試件破壞同樣發生在梁端，屈服荷載比加固前提高12 . 3 17 . 2 ，與粘鋼加固相比，加大截面法加固的試件承載力提高幅度較大；加固后試件的延性和耗能性能比加固前有很大的改善，其中以粘鋼加固的試件提高最為明顯。 -
The experiment procedure and analysis result about exteriorly extended end - plate connection with high strength bolt are introduced primarily ; each sample ' s dimension is given. the adding load equipment, measuring apparatus placed, measuring point established is detailed. adding load measure load and m - curve is produced ; the single span gabled frames horizontal displacement formula is deduced when the horizontal concentrated force is applied to it
重點介紹了外伸端板高強螺栓連接的實驗過程及實驗分析結果，介紹了各組試件的形狀尺寸、加載裝置、測量儀器安放、測點的布置等；給出加載方式及測出的m -曲線；計算出試驗節點的初始剛度；推導水平集中力作用下單跨門式剛架考慮節點半剛性的側移計算公式。 -
According to the frndamental and the steps of this method, we cans use the linear regress filter method to make the simulation of the wind load and then we can educe the curve of the time - process wind velocity. after that step, we can get the chart of the dynamic wind load which we can deliver the crosswind into the particle wind load and put them on the corresponding cell nodes. then we can do the analysis of the dynamical wind load through the time - process analysis to get the max value of the displacement
根據線性回歸濾波器法的基本原理和步驟，藉助相關軟體進行風荷載的人工模擬並得出風速時程曲線，進而轉化為風動力譜，由此將橫風向風力表達成節點風荷載作用於相應的單元節點上，按時程分析法對該空間桁架體系進行風荷載的動力分析，求出結構在進行風動力荷載分析時，結構相應節點對應的最值位移值。 -
Through the pull - out experiment, the load displacement curve was obtained. contrasting the test results under the different condition to post - installed bar, it was clear about the mechanism of the inorganically post - installed bars. the test results of inorganically post - installed bars was compared especially with the traditional organically post ? installed bars
通過拉拔試驗，得到了荷載位移曲線，對比了不同條件下植筋的試驗結果，明確了無機植筋的受力過程，特別同有機植筋進行對比，並提出了帶錐頭無機植筋的施工工藝。 -
Based on the constitutive relationship coupled microstructure evolution, 3d - fe simulation of isothermal forging process of tc6 titanium alloy disc is performed dealing with different deformation temperature, punch velocity and shear factor of friction, effect of process parameters on equivalent strain, equivalent stress and grain size is calculated, and load - displacement curve is calculated
本文基於微觀組織演變的本構關系模型，對不同變形溫度、凸模速度和摩擦條件下鈦合金盤的等溫鍛造過程進行了三維數值模擬，研究了變形工藝參數對等效應變、等效應力和晶粒尺寸的影響，計算了各變形條件下的位移?載荷曲線。 -
As for dam ' s dynamic properties in condition of elastic foundation, author uses mapping infinite element, which can reflect displacement ' s property of diminishing in semi - infinite materials. through exchanging data between three analytic software - matlab, ansys, fortran, dynamic properties of dam is computed in condition of elastic foundation. and then the dynamic displacement curve is obtained under the load of earthquake with the method of newmark - b
對于彈性地基情況下壩體的動力特性，作者採用了能夠反映半無限域介質中位移衰減特性的映射無限元，通過matlab 、 ansys 、 fortran三種計算軟體之間數據交換得出了彈性地基下壩體的動力特性，並通過自編newmark -法程序計算了壩體在地震荷載作用下動位移響應。 -
Based on the test results, the failure mechanism, the factors affecting the strength and ductility of these columns are analyzed. a fortran program is compiled to calculate the load - displacement skeleton curve
編寫了計算壓彎構件非線性全過程分析的程序，計算了高強混凝土壓彎構件在低周水平反復加載時的荷載?位移骨架曲線，與實驗結果進行了對比。 -
A corresponding program is developed. nonlinear load - displacement curve in complete - process analysis of a double - layer reticulated shell structure is traced out by the program
研製了相應有限元程序，對網殼結構進行非線性的荷載?位移全過程跟蹤分析，得到網殼結構荷載?位移全過程曲線。
分享友人