loading condition 中文意思是什麼

loading condition 解釋
負載情況
  • loading : n. 1. 裝貨。2. 裝載量;重量;載荷;(船隻等的)貨載。 3. 填充物,填料。4. 額外人壽保險。
  • condition : n 1 狀態,狀況,情形;品質。2 〈pl 〉外界狀況,周圍情形。3 地位,身分。4 條件;【語法】條件子句。...
  1. The stress induced electrical current changes with stress changing. the sensitivity of cfrc and plain concrete depends on their component, loading condition and the method of measurement. the study on mechano - electric effect of hardened cement paste provides a new method to make smart concrete structures. according to nonequilibrium thermodynamics, a mathematical model on the relatrionship between strain gradient and electric potential gradient is presented

    研究表明,碳纖維混凝土(粗骨料)的電阻隨所受荷載的變化而變化,不同組成混凝土的力電機敏特性不同,力電機敏特性可望用於混凝土結構的應力診斷,從而為智能混凝土結構的實現開辟了新的途徑。
  2. Saturated sand are testes in the laboratory under the undrained cyclic loading condition with static - dynamic dual purpose triaxial compression test apparatus, which is designed under the cooperation of hohai university and marui co. ltd japan. the results indicate that the stress path approaches from a initial stress point to the failure lines as cyclic loading goes on, and eventually converges on a certain limiting stress path in the vicinity of the failure lines. the stress - strain curve, however, does not converge on a closed hystersis loop ; the shear strain rapidly increases in looser sand or gradually and continually increases in denser sand

    利用河海大學與日本圓井株式會社共同研製的新型的多功能靜動三軸儀進行了飽和砂土循環扭剪不排水試驗,研究表明,對于松砂,剪應變幅度快速地由微小增加到百分之幾甚至百分之十幾,對于緊砂,剪應變幅度逐漸地由微小增加到百分之幾甚至百分之十幾;經試驗初步研究表明用初始有效平均正應力歸一化的有效應力路徑很好的一致性。
  3. Extreme loading condition

    極端荷載條件
  4. Normal loading condition

    正常荷載條件
  5. This dissertation generalizes the test on the full - scale reinforced concrete simply - supported slabs and three - span continuous slabs under fire at the normal loading condition. the conclusion can be drawn from the test about the deformation of the both kinds of slabs and the specimen section temperature distribution. meanwhile, the failure modes, mechanism and internal force redistribution of the continuous slabs are analyzed

    本文對足尺鋼筋混凝土簡支板、三跨連續板進行了恆載下的受火試驗研究,通過試驗,給出了鋼筋混凝土簡支板和連續板在高溫下的變形、構件截面溫度分佈規律;分析了連續板的內力重分佈和破壞機構的特點。
  6. Temporary loading condition

    臨時荷載條件
  7. The structural safety of the dam under vehicle loading condition was reviewed in 1999 by a reservoir expert engaged by the water supplies department ( wsd )

    水務署曾在一九九九年委聘一位水塘專家檢視該堤壩在車輛荷載條件下的結構安全。
  8. With experiences of the author in the tobacco near - infrared spectroscopy, factors affecting the accuracy of near - infrared spectroscopy are summarized and introduced in this paper, including the representation of the calibrating samples, sample water content, sample granularity, sample loading condition, spectral colleting parameters and so on, which provides some instructions to nir operators in the areas

    摘要本文結合作者煙草近紅外分析研究的經驗,對校正集樣品的代表性、樣品水分、樣品粒徑、裝樣條件和光譜採集參數等影響近紅外光譜分析結果準確性的因素作綜述介紹,以期為同行工作者提供參考。
  9. By means of the sea trial, it is verified that at full loading condition of 12. 5m draught, the vessel ' s speed attained to 15. 09 knots with the rotate speed of 100. 5rpm, at the condition of the sea margin of 15 % and rotate speed margin of 5 % at csr of main engine

    Sin ) ,主機正常功率帶有15的海上裕度和5轉速裕度時,航速為15刀9節,轉速100 5pm ,與設計吻合。最後,本文進行了滬東型( hd )螺旋槳的系列研究。
  10. The change of residual contact pressure of bimetal composite pipe under the action of heat load in this article, the possibility of separation between two metal layers in temperature cycle was researched ; it has been shown that under heat loading condition, it has a limit working temperature

    摘要分析了在熱載荷作用下雙金屬復合鋼管結合強度的變化,研究了經歷溫度循環后內外層管之間出現松脫的可能性。
  11. 2 ) wake measurement on shafting direction, at over loading condition

    2 )船舶在吃水t 14刀m時,軸向伴流的測量。
  12. Abstract : in plane dynamic loading experiments, the velocity of flyer and state of impact are key parameters of loading condition

    文摘:平面動載實驗中,飛片碰撞速度和碰撞狀態是加載條件的一個基本描述。
  13. This study dealled with high concentrated pharmaceutical wastewater treatment. the high level sediments of organic pollutants were examined qualitatively and quantitatively, and the three dominated strains, which can degrade the sediments of albendazole, chlor - trimeton and brufen, had been screened. the three dominated strains were trailed to solidify by materials three of bounded solidification and two of embed solidification. the results of degradation experiment announced that at high loading condition a removal ratio over 90 % of organic compounds had been obtained, about 1 / 3 higher than conventional activated sludge process. assumes to treat the high level organic wastewater has been suggested

    針對制藥行業的高濃度有機廢水,定性定量地測定了高濃度有機物底物;篩選出降解以阿苯噠唑、撲爾敏和布洛芬為主要底物的3種優勢細菌;應用了3種結合固定化材料和2種包埋固定化材料對優勢菌群進行了固定化試驗;通過降解試驗,在高負荷的情況下有機污染物最高去除率可達90 %以上,比一般活性污泥法提高功效1 / 3 ;提出了利用現有設施對高濃度有機廢水的處理工藝設想。
  14. Tensile loading experiments of 0. 20 % c and 0. 45 % c ( all mass fraction ) steel were conducted in the experiments. the mfl distributions of specimens under uniaxial tension loading condition and after removal of applied uniaxial tension at different loadings were tested by the weak magnetic measurement system

    試驗以20 ~ #鋼和45 ~ #鋼為研究對象,分別進行了含典型缺陷試件拉伸時表面泄漏磁場的在線測量和經過不同程度拉伸並卸載后表面泄漏磁場的測量。
  15. 2. tow different types of power loading condition were applied on chips respectively. the transient thermal analysis was conducted to determine temperatures vary over time

    2 .以兩種不同功率加載方式進行自然對流換熱條件下的封裝瞬態熱分析,得出封裝體溫度隨時間的變化規律。
  16. This paper is concerned with an infinite slab containing a semi - infinite crack, which is subjected to the anti - plane shear loading condition

    本文研究的是無限大板中的半無限長的型裂紋問題。
  17. Accident loading condition

    意外載荷條件
  18. Study on residual stiffness of layer composite plates under cycle - loading condition

    循環加載條件下復合材料層板的剩餘剛度試驗研究
  19. Grounded on a comprehensive discussion of the effects of tonnage, loading condition, ratio of water depth to draft and tugboat power, the thesis puts forward the assessment curves as well as the regression formulae

    詳細討論了船舶排水量、裝載狀態、水深吃水比和拖輪功率與極限航速的關系,並給出極限航速估算圖譜以及相應的回歸公式。
  20. The results provide guidance for optimizing the h2 - loading technique. 3. the fbg was fabricated and the relation between h2 - loading condition and performances of fbg was discussed ; the effects of annealing on fbg were studied

    三、對不同載氫條件的光纖刻入光纖光柵,探討載氫條件與光柵性能的關系,研究退火對光纖光柵性能的影響,所得到的結論對製作光柵提供了依據。
分享友人