locking circuit 中文意思是什麼

locking circuit 解釋
保持電路強制同步電路
  • locking : 打開或關閉文件共享鎖
  • circuit : n 1 （某一范圍的）周邊一圈；巡迴，周遊；巡迴路線[區域]；迂路。2 巡迴審判（區）；巡迴律師會。3 【...
  1. It is discoverde that with a looped feedback circuit, the dds acousto - optic mode locking has the function of tracking the frequency interval of the laser resonator longitudinal mode, and stabilizing the quality of the laser beams

    Dds聲光鎖模器在增加閉環反饋環路后，可以跟蹤激光諧振腔縱模頻率間隔變化，穩定激光光束輸出質量。
  2. Fault analysis and circuit transformation of kg7005 intelligent gas locking device for ventilation and power supply

    7005智能型風電瓦斯閉鎖裝置故障分析與線路改造
  3. Analyze item by item the position of unintact cycle, the running clearance of unintact cycle, locking - deform, datum dimension regulating, repeatly install, power voltage wave and marking running etc. at the same time, we give the calculating formula to calculating the running marking random error, and use it to calculate the system error of big diameter measure instrument - - datum dimension frame error, gyro - wheel diameter error, error caused by circumstance temperature, error caused by backing distance, angle error, delay error of data collecting circuit, lathe main shaft running error, workpiece install partial error

    對不完整圓的位置、不完整圓的轉動間隙、鎖緊變形、基準尺調整、重復安裝、電源電壓波動、標記轉動等隨機誤差進行了逐項分析，並給出轉動標記隨機誤差的計算公式。對大直徑測量儀的系統誤差?基準尺尺架誤差、滾輪直徑誤差、環境溫度引起的誤差、後退距離引起的誤差、角度誤差、數據採集電路延時誤差、車床主軸回轉誤差、工件安裝偏心誤差分別進行了計算，最後對誤差進行合成。
  4. Identification card systems - intersector rules for locking and unlocking of integrated circuit cards

    識別卡系統.集成電路卡鎖定和非鎖定的部門間規則
  5. Approach locking track circuit

    接近鎖閉軌道電路
  6. The core part does n ' t use the protocol of tcp / ip, and it transfers especial format data defined by myself by a serial port / parallel port or a usb port with driver software researched by myself and keeps isolated state which is equal to physical disconnect when one side exchanges data with the part of the core by the circuit locking each other

    這個核心部分不使用tcp / ip協議，用自主獨立研發的驅動程序軟體，通過串並口或者usb口將自定義格式的數據進行傳輸。在數據傳輸過程中，通過電路互鎖機制使內網或外網任何一方與隔離交換器進行數據交換時，另一方保持相當於物理隔離的隔離狀態。
  7. Controlling system is composed of drive circuit, locking memory, shift register. temperature compensating circuit and drive power circuit are also needed

    控制系統是由驅動電路、鎖存器、移位寄存器等組成，此外還需要溫度補償電路和驅動電源電路，本文對控制系統進行了詳細的論述。
  8. The system is based on chopper constant current drive technique, according to the top level design idea, adopting advanced specical subdivision control integrate circuit and powerful function 80c196kc to organize the system frame, desiging the minimum system of single - chip microcomputer, multifunction i / o interface circuit, relay switch circuit, keyboard and display circuit, multifunction digital setting interface circuit and so on, utilizing the hso and hsi interface circuit which are owned by this single - chip microcomputer exclusively and its powerful command system to realize dual - degree switch control, automation orientation, automatically searching zero position, locking machine when stopping, frequency to set digitally, automatically adjusting speed through changing frequency, swithing subdivision or squarewave control, on the basis of above, the system also have the function of running according to the setting steps and the frequency, voltage and current to display through the led, etc

    系統基於斬波恆流驅動技術，按照頂層設計思想，採用先進的專用細分控制電路和功能強大的80c196kc單片機來組建系統構架，設計了單片機最小系統、多功能i o介面電路、繼電器切換電路、鍵盤顯示電路和多功能數字設定介面電路等，利用該單片機獨有的hso和hsi介面及其強大的指令系統，實現了雙余度混合式步進電動機的余度切換控制、自動定位、零位自動搜索、停機鎖定、數字化頻率設定、自動調頻變速控制、細分方波切換控制，在此基礎上，該系統還設有按預置步運行、 led頻率電壓相電流顯示等功能。
  9. It can be deduced from the characteristics of ilpll circuit that injection - locking bandwidth is not only related to the injection - locking bandwidth without feedback loop, but also related to the characteristics of frequency mixing, loop gain and the change of the loop phase. thus, the needed bandwidth can be obtained by adjusting the loop parameters. and the phase noise characteristics are mainly determined by loop transmission factor

    由ilpll電路特性的推導得出:注入鎖定帶寬不僅跟開環時的注鎖帶寬有關，而且與混頻特性、環路增益以及環路相位變化相關聯，可以通過調節環路的參數得到所需帶寬;相噪特性主要由環路傳輸因子決定，可以通過調節環路濾波得到比開環注入鎖定相噪更優的特性。
  10. And the new circuit structure for improving the locking range, that is, injection - locked phase - locked loop circuit ( ilpll ) is introduced into the millimeter wave circuit

    在此基礎上，結合注入鎖定和環路鎖相原理，在毫米波頻率源中引入了一種新型的展寬帶寬的電路結構環路注入鎖定鎖相電路（ ilpll ） 。
  11. Design and realization of a single - chip digital phase - locking frequency - multiplier circuit

    單片數字鎖相倍頻電路的設計與實現
  12. Rccn locking circuit board support cs - type material : ul approved nylon 66, 94v - 2 by hand to support p. c. b

    使用時先將基板鉆孔4 . 8mm后將隔離柱固定，再將p . c .板套入即可。
  13. The paper analyzes in detail the characteristics of this circuit in the aspect of locking range improvement and its merits in the aspect of phase noise, and designs the ilpll circuit in the form of ka band cavity structure and verifies its characteristics

    文章詳盡分析了此電路在展寬帶寬方面的特性和相噪的優越性，設計了ka波段腔體結構形式的ilpll電路並驗證了其特性。
  14. Locking circuit board support cs - type at richeng

    Pc板隔離柱cs
  15. Thus, the better phase noise can be obtained by adjusting the loop wave filtering. through experimental verification, the locking range of the designed ka band ilpll circuit is 2. 5 times to 9 times widened and the phase noise, compared to that without feedback loop, is reduced by 4dbc @ 1khz and the noise can be reduced by adjusting the loop wave filtering and

    經過實驗驗證，設計的ka波段ilpll電路的鎖定帶寬拓展了2 . 5倍以上，最大處達到9倍左右;相噪與開環注鎖相比降低了4dbc @ 1khz ，且可以通過調節環路濾波和注入功率來降低噪聲。
分享友人
分享到 Line

分享到臉書