magnetic reactance 中文意思是什麼
magnetic reactance
解釋
磁抗-
In this paper, we at fist analyse the distribution of magnetic field in the permanent magnet synchronous motor which rate power is 800w and calculate parameters of this motor on the basis of the traditional approach to ca1culating armature reactance, we put forward a new method which is based on the iteration of the electromotive force equation, and name it after " electromotive oprce method "
本論文運用有限元方法分析一臺800w稀土永磁同步電動機內部電磁場的分佈情況，計算出相應的電機參數。並在傳統的計算電樞反應電抗的基礎上提出了一種基於電勢平衡方程式的計算方法，本論文稱之為「電勢法」 。 -
3. we do short circuit analysis upon multiple magnetic circuit transformers by use of steady non - linear analysis and get the leakage reactance respectively between high voltage and high voltage 、 high voltage and low voltage 、 two high voltage and low voltage 、 low voltage and high voltage and low voltage and two high voltage. what ’ s more, we do finite element analysis upon the temperature field of transformers and according to its distribution we get the wind speed to forced air cooling
3 、採用穩態非線性分析法對多磁路變壓器進行短路阻抗計算，利用能量法計算出變壓器高壓與高壓、高壓與低壓、兩高壓與低壓、低壓與高壓以及低壓與兩高壓之間的漏感;對變壓器的溫度場進行有限元分析，確定溫度場分佈情況。 -
Against a prototype which is being produced ， its three dimension end region entity model of stator is established ， and with the aim of simplifying calculation ， the theory of how to simplify entity model is studied ， then the theory is made use of ， and the end region entity model of stator is simplifi - ed ； meshing characteristics of three dimension entity model and shortcomin - gs of end region entity model of stator are studied ， then meshing method of three dimension end region entity model of powerformer stator is studied as well ， and the simplified entity model is meshed with this meshed model ， the distribution of end region magnetic field of stator is analyzed ， and the magnetic field energy and reactance of powerformer end region are calculated and compared with design value because the prototype is being produced ， in this paper ， stator core ， gap and eddy equipment are not taken into consideration ， and this has a little influence on the result ， but through analysis ， the result is proved to be good through the example calculation ， it is known that the method of this paper is useful and through theoretic analysis ， it is proved that end region
針對一臺生產中的樣機，對其建立了定子端部三維實體模型，而且為了達到簡化計算的目的，研究了如何將其簡化的理論，並應用這些理論對樣機定子端部實體模型進行了簡化；研究了三維實體模型的剖分特點和定子端部實體模型存在的缺點，在此基礎之上，研究了對簡化的powerformer定子端部三維實體模型的剖分方法，並且對簡化的實體模型進行了剖分。應用剖分的三維實體模型，用有限元法分析了powerformer定子端部的磁場分佈，計算了端部區域的磁場儲能，並利用磁場儲能計算了powerformer定子端部漏抗，將計算值與設計值進行了比較、分析。由於樣機處在設計生產階段，本文暫時沒有考慮定子鐵心、氣隙和渦流器件對端部磁場的影響，這對分析結果有一定的影響，但是仍然得到較好結果。 -
In this paper ， the design characteristics and development situatution of powerformer are introduced ； the structure of prototype is studied ， and three dimension end region entity model of powerformer stator is established ； the theory of analyzing end region eddy magnetic field of stator by finite element method is studied ； end region magnetic field of stator is analyzed and the numerical value of end region leakage reactance of stator is calculated
本文介紹了powerformer的設計特點和發展現狀；研究了其樣機本體結構，並建立了定子端部三維實體模型；研究了用有限元法分析定子端部渦流磁場的理論基礎；用有限元法分析了定子端部磁場並計算出了定子端部漏抗值。 -
In this paper, firstly we analyse the distribution of the magnetic field in the permanent magnet canned motor pump which rate power is 15kw, and calculate the reactive electromotive force, armature reactance parameters of this motor pump with no loads and loads
本論文運用有限元方法分析了一臺15kw稀土永磁同步屏蔽電泵內部磁場的分佈情況，得到了在空載、負載等不同情況下，電泵的氣隙磁密分佈磁場，計算了反電動勢和電樞反應電抗等參數。
分享友人