measurement amplifier 中文意思是什麼
measurement amplifier
解釋
測量放大器- measurement : n. 1. 測量，計量，量度。2. 份量，尺寸，大小，寬度，厚度，深度（等）。3. 測量法。 measurement goods （按體積、容積計算的）體積貨物。
- amplifier : n. 1. 【電學】擴大器；擴音器。2. 放大鏡；放大器。
-
The measurement amplifier is designed to be installed in a control cubicle and can be put on a carrying rail in a top hat rail housing made of extruded sections
這個測量放大器是設計安裝在控制機箱內，也可以安裝在由擠壓型材製成的頂帽式導軌外殼的承載軌上。 -
The instrument is integrated with a multi - channel high precision open circuit potential measurement system for the ion selective electrode and a potentiostat used in voltammetry, an analog lock - in amplifier is also presented to measure the response of light addressable potential sensor
對于不同的測量技術，儀器中集成了用於測量電極的多通道高精度開路電壓測量系統和用於溶出伏安法測量的多路電化學測量系統，以及用於測量光尋址電位傳感器的鎖相放大器。 -
This measurement amplifier with relay outputs works as a uniform voltage amplifier for strain gauge measuring bridges
這款測量放大器帶有繼電輸出，它像恆定電壓放大器那樣工作，用於應變測量電橋。 -
Specifications and methods of measurement on trunk amplifier used in catv systems
有線電視系統干線放大器.入網技術條件和測量方法 -
The cox report says, " china great wall industry corp. determined that the root cause of the failure was a deterioration in the gold - aluminum wiring connections within a power amplifier for the follow - up frame torque motor in the inertial measurement unit
《考克斯報告》稱， 「中國長城工業總公司確定失敗的根本原因，是慣性測量裝置中，隨動架轉矩電動機功率放大器內部金鋁合金線路連接處破損。 -
Measurement of the electrical properties of microwave tubes. part 9 : crossed - field amplifier tubes
微波管電性能的測量.第9部分:正交場放大管 -
We have designed different measurement instruments according to the methods. the instrument used to measure electrode is a high precision multi - channel system constructed with a iaadc as the core and high input impedance amplifier and low input current multiplexer
對于硫屬玻璃電極，我們設計了以高精度的adc為核心，配以高輸入阻抗低噪聲的前置放大器和低漏電流多路模擬開關的多路精密電極測量系統。 -
Realization of lock - in - amplifier software and parameter measurement
鎖相放大器的軟體實現與參數測量 -
The measure module has bigger signal - to - noise ratio because adopting instrumentation amplifier, programmable gain amplifier and accumulate measurement
信號檢測模塊採用儀表放大、程式控制增益放大、積累檢測方式等措施有效地提高了測量系統的信噪比。 -
The precise measurement of microwave antenna pattern with lock in amplifier
利用鎖定放大器實現微波天線方向圖的精確測量 -
Methods of measurement for radio equipment used in satellite earth stations - part 2 : measurements for sub - systems - section ten - high - power amplifier
衛星通信地球站無線電設備測量方法第2部分:分系統測量第十節:高功率放大器 -
Design optimization of the characters measurement system of 4 2 3 multi - slab - amplifier
3陣列式放大器參數測量系統優化設計 -
A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift
採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。 -
In order to measure the characteristics of such semiconductor optical amplifier, we adopted a set of measurement system. this measurement system can be used to measure the characteristics of all kinds of active or inactive optical passive components. such device presents good polarization insensitivity ( < 0. 9db ), wide 3db bandwidth ( > 33nm ) at 0 - 200ma and different input signal light wavelength and power, the maximum fiber - to - fiber gain of 10db, lossless operation current of 50 - 75ma for different input signal light wavelength and power, large extinction ratio ( > 50db ) and lower noise figure ( nf ) ( < 8db )
與張瑞英博士一起，首次利用該種有源區結構制備出偏振不靈敏半導體光放大器，並在0 - 200ma注入電流范圍內獲得33nm的3db帶寬，在不同信號波長，不同信號功率0 - 200ma的注入電流范圍內，偏振相關損耗均《 0 . 9db ，在耦合差損為7db / facet的條件下，最大fiber - to - fiher增益達10db ，無損操作電流為50 - 70ma ，消光比達50db以上，而噪聲指數則低於8db ，最小可達4 . 6db 。 -
The measurement system consist of computer, 16 - channel high speed data acquisition board, spark plug pressure sensor, crank angle signal generator, charge amplifier and oscillograph. the max acquisition frequency of this system is 1mhz
由通用微機、 16通道無相差高速數據採集卡、火花塞式壓力傳感器、角標信號發生器、電荷放大器、示波器組成的高速數據採集系統，最高總采樣頻率為1mhz 。 -
The main part and key technique of the cpa system is study : the generation of the femtosecond laser pulse is study, the modulation and maintenance of the ti : s laser is learned ; the types of the measurement for ultrashort laser pulse is generalized and the interferometric autocorrelation is expatiated ; the varieties of the stretchers is sum up and aberration - free stretcher is calculated and optimized to improve the stretching ratio ; the pulse selection is analyzed and a single pulse can be selected successful from the pulse train at a repetition rate of 82mhz ; the kinds of the amplifier in cpa system is gathered up, the eight - pass pre - amplifier and a good many effects in it is investigated. finally, the second, third and fourth - order dispersions in cpa system is analyzed systemicly, and the according means for dispersion compensation is worked out
對cpa系統的主要環節及關鍵技術進行了研究：掌握了鈦寶石激光器的調節和維護技術，較深入地研究了飛秒激光脈沖產生的機理，其中對群速色散、自相位調制、自鎖模等問題進行了詳盡的分析；總結了超短激光脈沖的測量技術，重點研究了干涉自相關測量法；在總結展寬器類型的基礎上，對無象差展寬器進行了理論計算、優化設計，提高了展寬倍數；深入論述了脈沖列的選單問題，熟練掌握了脈沖選單技術。 -
Digital strain gauge measurement amplifier
數字應變測量儀放大器 -
Analogue strain gauge measurement amplifier
模擬應變測量放大器 -
Design of high - performance measurement amplifier controlled by single - chip microcomputer
單片機控制高性能測量放大器的設計 -
This analogue measurement amplifier specially developed for very fast and accurate force measurement is used to adjust the output signal of strain gauge force transducers to make it suitable for information devices or a connected control system
這款模擬測量放大器是特別為快速準確的力測量而設計的，可以調節應變測量力傳感器的輸出信號，使之適應信息設備或所連接的控制系統。
分享友人