measuring of leakage current 中文意思是什麼

measuring of leakage current 解釋
漏電電流測定
  • measuring : n. ,adj. 測量（的），測量用（的）。 remote measuring 遙測。
  • of : OF ＝Old French 古法語。
  • leakage : n. 1. 漏，漏出。2. 泄露。3. 漏出物，漏出量。4. 【商業】漏損率；漏損量。
  • current : adj. 1. 通用的，流行的。2. 現在的，現時的，當時的。3. 流暢的；草寫的。n. 1. 水流；氣流；電流。2. 思潮，潮流；趨勢，傾向。3. 進行，過程。
  1. Measuring of leakage current

    漏電電流測定
  2. For the leakage often occured on condenser brass pipe of hanchuan power plant, using differential inner insert detecting coil the on - line multi - frequency eddy current check technology effectively restrains interferance source signal from support board, etc, improves measuring sensitivity and the measuring result gets more reliable

    摘要針對漢川電廠凝汽器銅管在運行中多次發生泄漏，利用差分內插式檢測線圈，通過多頻渦流檢測技術對凝汽器進行渦流在役檢測，有效地抑制了支撐板等干擾源信號，提高了檢測靈敏度，使得檢測結果更可靠。
  3. On the base of the theory of the adaptive noise cancellation and the adaptive line enhancement, we have made an improved adaptive noise cancellation in use of the measuring of hv insulator ' s leakage current

    結合普通自適應噪聲對消和自適應譜線增強原理，提出了一種改進型自適應噪聲對消器，用於高壓絕緣子泄漏電流檢測。
  4. The efficiency and the homogeneity of cavities gettering were analyzed by measuring the leakage - current for the diodes in a wafer, which was thermally treated at the optimal condition, that is 700 1hr, then 800 6hr and slow cooling down

    第二階段，氦微孔吸雜效果的研究。採用做有二極體的大矽片在700 lhr + 800 6hr + 』漫降溫的熱處理條件下對微孔吸雜的效率、均勻性進行實驗。
  5. Insulators leakage current has a close relationship with insulators contamination and humidity state, so it can provide an integrated reflection of the course of contamination flashover. the contamination flashover on - line monitoring device introduced in this paper predominates the insulators insulation degree by measuring leakage current, environment temperature and humidity. with the help of the device, an active partial aperiodic cleaning method will substitute the former passive general fixed cleaning method in order to prevent the contamination flashover to a larger extent

    本文所描述的防污閃在線監測系統通過直接測量絕緣子表面的泄漏電流及環境的溫度和濕度，經過數據處理、分析、判斷，達到對絕緣子絕緣狀況實時監測的目的，以此為依據變定期的、全面的、被動的清洗為不定期的、局部的、主動的清洗，最大程度地防止污閃事故的發生。
分享友人
分享到 Line

分享到臉書