melt crystallization 中文意思是什麼

melt crystallization 解釋
熔融結晶化
  • melt : vi （melted; melted molten）1 融化；熔化；液解。2 逐漸消散[消失、變淡]。3 （心等）變軟，生憐憫的...
  • crystallization : n. 晶化，結晶（作用，過程）；結晶體；具體化，明朗化。
  1. In this investigation carbon black - filled electrical conductive composites of poly ( ethylene terephthalate ) / polyethylene were first prepared through the single - screw melt - blended extrusion, then drawing, followed by the quenching and subsequent press molding. the relationships among the influencing factors including composition, hot stretching ratio and compatibilizer, morphology and properties of composites were systematically investigated. positive temperature coefficients effect and crystallization behaviors of composites were preliminarily analyzed

    本文擬採用單螺桿熔融共混擠出?熱拉伸?淬冷的新的成型方法制備炭黑填充的pet pe復合導電材料，熱拉伸的目的是使材料的分散相（ pet相）在加工過程中原位形成纖維，而炭黑基本分散在纖維中或纖維的表面上，使炭黑粒子間間距減小，形成更多的導電通路，從而提高材料的導電性能，同時保持或提高材料的力學性能。
  2. It is the first time to get phbv fiber by melt spinning in china. and the changes of fiber crystallization structure and orientation structure under force were studied

    並在國內首次通過熔融法制備了phbv纖維，首次論證了纖維結晶結構的變化及其在外力作用下取向結構的變化。
  3. Polyethylene ( pe ) / pe - g - mah / org - mmt nanocomposites were prepared by melt intercalation. xrd, and transmission electron micrograph ( tem ) were used to measure the structure of nanocomposites, the nonisothermal crystallization kinetics of pp / pp - g - mah / org - mmt was studied by differential scanning calorimetry ( dsc ), and their mechanical properties were tested

    採用熔融插層法制備了聚乙烯接枝物蒙脫土納米復合材料，通過xrd 、 tem和dsc研究了pe pe - g - mah org - mmt納米復合材料的結構及結晶動力學，並測試其力學性能。
  4. Combining the unstable heat conduction in crystal layer with heat transfer of undeveloped slug flow in a vertical tube, a time - progression model of crystal layer growth in the bubble column crystallizer pipe is proposed, the calculation results from the numerical method agree well with the experimental data. under certain operating conditions, the periodical arrival of gas plugs can cause crystallization and partial re - melting occur in the crystal - melt interface

    結合未充分發展彈狀流的傳遞特徵和晶層內不穩定導熱，提出了鼓泡塔結晶器管內晶層生長的時間級聯模型，與實驗值吻合良好.特定操作條件下，隨彈狀泡的到來和離去，結晶界面可發生結晶-部分重熔
  5. Kinetics of nonisothermal crystallization of high melt strength polypropylene

    高熔體強度聚丙烯的非等溫結晶動力學
  6. With engaged in person who cast crystallization device electroplate copper repair and new product make in succession, crystallization device always becomes and makes, overhaul of the equipments and reorganize and outfit, refractory material of casting etc. and person who melt hollow particle cast, spend, protect dreg production, storage transportation, etc

    是以從事連鑄機結晶器電鍍銅板修復及新品製作結晶器總成製造連鑄機設備檢修與整備耐火材料及預熔型空心顆粒連鑄用保護渣生產倉儲運輸等為主體的綜合性集體企業。
  7. So we decide to fabricate gi - pof by the method of interfacial - gel mass polymerization of methyl methacrylate ( mma ). secondly, some ways for purifying mma such as two - stage rectification, dynamic melt crystallization and distillation - melt crystallization hybrid process were researched

    其次討論了制備塑料光纖的主要原料mma的精製方法，研究了填料塔兩級精餾、動態熔融結晶及熔融結晶-精餾耦合工藝，提出用分子蒸餾法提純摻雜劑的設想。
  8. In comparison, the addition of mmt to hdpe did not affect the crystallization behavior of the later. 2. preparation, structure and properties of hdpe - g - ydh151 / mmt nanocomposites melt grafting reaction of hdpe with ydh151 was performed in thermohaake rheomix and the melt grafting procession was studied

    兩種復合材料在力學性能上存在較大差異，對于hdpe - g - aa mmt ，隨著mmt含量的增加，拉伸強度和楊氏模量都有所增加，而對于hdpe mmt卻降低。
  9. Formation and crystallization behavior of nanocrystal amorphous in melt spun al87ni10zr3 alloy

    3納米非晶材料的形成及其晶化行為
分享友人
分享到 Line

分享到臉書