molten polymer 中文意思是什麼
molten polymer
解釋
熔融聚合物-
Blend in molten state make hdpe crystals small, crystallinity large, quantity of cb particle benefit to conductivity decreasing ; in solid state cb aggregate is sheltered with a insulate hdpe film, also cb structure will be broken down during blend ; all of these will make conductivity bad. but processing alds can lower this effect obviously. 3. the effect of crosslink is restricting the movement of molten polymer molecules
為此筆者認為固相混合使hdpe晶粒尺寸變小,結晶度增大,使得異相成核的晶粒增多,參與導電的炭黑粒子數量減少:熔混卻使炭黑粒子表面被覆一層絕緣膜:這都將導致材料的導電性明顯變差,同時兩種混合還會造成炭黑結構的破壞,皆使得材料的導電性明顯變差。 -
And the linear viscoelastic behavior, steady rheological behavior and the formation / evolvement of particles net structure for molten nanocomposites were studied using an advanced rheometric expansion system ( ares ) and capillary rheometry. it is believed that the melt intercalation is a more efficient processing for formation of nanophase in polymer - layered silicates hybrids
用高級流變擴展系統( ares )及毛細管流變儀對復合體系熔體的線性粘彈行為、穩態剪切流變行為進行了表徵,並對熔體粒子網路結構的形成與演化作了較系統的研究。 -
The molten layer at specified time result is generated from a 3d cooling analysis and shows the percentage of polymer that has not frozen at the time specified. this result is the inverse of the 3d frozen layer result
熔融層比例? 3d冷卻分析時特定時間的未凝固材料層所佔的比例,與凝固層比例的結果是相對應的。
分享友人