momentum integral 中文意思是什麼
momentum integral
解釋
動量積分-
Momentum integral equation of turbulent boundary layer on ogree section of spillway dam in considering the gravity and centrifugal force
考慮重力及離心力的溢流壩反弧段紊流邊界層動量積分方程 -
In the thesis the low drag - low noise optimization of the vehicle main form design is realized, main accomplishments are as follows. researched the knowledge of drag and flow noise, the parameters of the boundary layer are calculated by the hess - smith method and boundary layer momentum integral method. the calculation of the length of transition zone and change in boundary layer displacement thickness between laminar and turbulent states in the transition is improved, then the drag coefficient and self - noise from the transition zone are calculated as the objective functions of the optimization
主要研究內容和成果如下：對航行器繞流流場進行分析，深入研究了阻力和流噪聲產生機理，建立了阻力系數和自噪聲的評估數值計算模型；採用物面分佈源匯法和邊界層動量積分法對繞流流場的流體動力參數進行計算，改進了轉捩區長度和邊界層位移厚度的計算，應用於航行器頭部駐點自噪聲的計算；最後設計了阻力系數和自噪聲數值計算程序模塊。 -
By the integral to boundary layer thickness and relative conditions, the momentum integral equation of boundary layer is obtained
通過對邊界層厚度的積分並利用相關條件，得到了邊界層動量積分方程。 -
In chapter three, the momentum integral equations and their solutions of two - phase fluids in boundary layer are given and the no - disturbance solutions on the surface of vane are required. leading into the disturbance factor of no - dimension and thickness coefficient ks in boundary layer, the numerical method of finite approximation is used to calculate the boundary layer
第三章給出了固液兩相流泵的邊界層動量積分方程及其解的一般表達式，並得到葉片表面的無擾動解；引入了無量綱擾動因子及邊界層厚度系數k _ ，給出了用於邊界層計算的有限次逼近的計算方法。 -
Firstly, based on n - s equation, the momentum differential equation （ contained centrifugal force ） is derived by simplification in boundary layer and then integrates the differential equation over the thickness of the boundary layer, the momentum integral equation is deduced. the dimensionless centrifugal factor is introduced, then the solution of the momentum integral equation is obtained. the dimensionless group is introduced to determined separation of boundary layer
本文首先根據粘性流體力學的一般方程，通過在邊界層內進行量級比較，在所限定的范圍內得到了含有離心力的邊界層動量微分方程並給出其滿足的邊界條件，然後對該微分方程在邊界層內積分得到離心泵葉輪邊界層動量積分方程，在求解過程中引入了無量綱離心因子，並作了相應合理的假設，得出積分方程解的一般表達式，並引入以邊界層動量損失厚度為主要特徵量的無量綱參數對邊界層分離進行評價。 -
System volume flux was gained by loop integral the momentum equation
利用環路積分的方法求解動量方程，進一步求得系統的體積流量。
分享友人