mortar joint 中文意思是什麼

mortar joint 解釋
灰縫, 砂漿接縫
  • mortar : n. 灰泥；灰漿；膠泥；【地質學；地理學】碎斑結構。vt. 用灰泥塗抹[接合]。n. 臼,搗缽,研缽；【軍事】臼炮,迫擊炮；【礦物】（試驗炸藥用的）臼炮。vt. 用迫擊炮轟擊。
  • joint : n 1 接合，榫接合處，接合點。2 【解剖學】關節。3 【植物；植物學】節。4 【電學】接頭。5 【建築】接...
  1. Methods of test for ancillary components for masonry - determination of shear load capacity and load displacement characteristics of shear ties and slip ties couplet test for mortar joint connection

    圬工輔助砌塊的試驗方法.剪切桿和滑動桿的拉伸和壓縮負載容量和負載轉移特性的測定
  2. Methods of test for ancillary components for masonry - part 7 : determination of shear load capacity and load displacement characteristics of shear ties and slip ties couplet test for mortar joint connections

    圬工輔助成份試驗方法.第7部分:拉伸和壓縮負載容量和墻系柱和負載代替特性測定
  3. Full degree of mortar at bed joint

    砂漿飽滿度48
  4. Testing of mortars containing mineral binders - part 9 : hardened mortars ; determination of the mortar compressive strength in the bed joint

    含礦物粘合劑灰漿的試驗.第9部分:凝固灰漿.層間接縫
  5. Methods of test for ancillary components for masonry - determination of bond strength of prefabricated bed joint reinforcement in mortar joints

    圬工輔助砌塊的試驗方法.灰漿連接處預制基地接合處加固的粘結強度的測定
  6. 3. the parameters of steel frame with infill which affect the lateral, resistant ability, such as panel ratio, frame - to - panel connectors, frame - to - panel interface friction, gap between panel and frame and mortar joint bond and friction were discussed. it is emphasized that the reduced location, shape and dimension is very important for the function of dog - bone reduced beam flange and must be paid more attention

    對填充墻高寬比、填充墻與鋼框架抗剪連接件、內填充墻與框架梁空隙、填充墻開洞和鋼框架與內填充墻界面摩擦等影響填充墻鋼框架抗側力性能的因素進行了討論，並指出設計中考慮這些影響因素對于達到預期的設計目的是至關重要的，必須予以重視。
  7. This paper researches the influence of no treating, paving cement and fly ash paste, and paving cement mortar on rcc layer surface upon the ultimate tensile strain of placing joint of rcc layers under the condition of different interval of placement of rcc layers and different amount of binding materials

    研究在不同的層間間隔時間條件下，採用不同的膠凝材料用量，對碾壓混凝土層面分別採取不處理，鋪水泥粉煤灰漿（簡稱水泥凈漿） 、水泥砂漿等處理措施對碾壓混凝土層面極限拉伸值的影響。
  8. Wall ties. methods of test for mortar joint and timber frame connections

    墻腰箍.第1部分:灰縫和木構架連接的試驗方法
  9. Methods of tests for ancillary components for masonry - part 2 : determination of bond strength of prefabricated bed joint reinforcement in mortar joints ; german version en 846 - 2 : 2000

    磚石工程輔助元部件試驗方法.第2部分:灰縫中預制底層
  10. The experiments show all the compression strength shear strength, elastic modulus of the composite blocks and their masonry can satisfy the requirements of standard compared to concrete, the haojiao materials elastic modulus is so low that we ignore it ' s improvement to the composite block ' s compression strength. however the area of horizontal mortar joint of composite block masonry is enlarged just because of the haojiao materials " existence, so the shear strength of composite block masonry is higher than one of small hollow betonblock masonry in thermal performance, the heat - preservation and heat - insulation capabilities of composite block masonry are analyzed and researched

    試驗表明：復合砌塊及其砌體的抗壓、抗剪強度、彈性模量等均滿足規范規定的要求；由於昊角材料與混凝土相比，彈性模量相差懸殊，在受壓時，可以不考慮昊角材料芯塊對復合砌塊及砌體抗壓強度的提高，同時又因為昊角材料的存在，砌體水平灰縫面積增大，復合砌塊砌體的抗剪強度較空心砌塊砌體有較大的提高。
  11. Methods of test for ancillary components for masonry - part 2 : determination of bond strength of prefabricated bed joint reinforcement in mortar joints

    圬工輔助成份試驗方法.第2部分:灰漿粘結處預制床接頭增強的粘結強度測定
  12. Standard test methods for in situ measurement of masonry mortar joint shear strength index

    圬工灰漿粘接剪切強度指數現場測量的標準試驗方法
分享友人
分享到 Line

分享到臉書