nmo 中文意思是什麼

nmo 解釋
正常時差
  1. Comparison between the non - hyperbolic and hyperbolic nmo correct ion results of 3d converted waves shows that the non - hyperbolic method is better than the hyperbolic method

    三維轉換波非雙曲動校正和常規雙曲動校正結果對比表明，非雙曲方法優于雙曲方法。
  2. The 3d anti 3c seismic processing flow established is used in processing of the real seismic data, achieving high quality velocity ratio spectrum and good non - hyperbolic nmo correction and stacking of 3d converted wave

    應用所建立的三維三分量地震資料處理流程，對某實際地震資料進行了處理，得到了較高質量的三維轉換波速度比譜，轉換波非雙曲動校正和疊加取得了較好效果。
  3. In viewing of the characteristics of propagation of 3d converted wave, studies are performed on the processing methods of 3d converted waves, such as horizontal component rotation, calculation of 3d transition point, hyperbolic velocity analysis and nmo ( normal moveout ) correction of 3d converted wave, and non - hyperbolic velocity ratio analysis and nmo correction of 3d converted wave

    基於三維轉換波傳播特點，對三維轉換波資料處理方法進行了研究，包括水平分量旋轉，三維轉換點計算、三維轉換波雙曲速度分析與動校正、三維轉換波非雙曲速度比分析與動校正等。
  4. According to these accomplishments, several techniques are expounded emphatically in this paper, including 3d refraction statics, coherent noise suppression by prestack wave field separating ( prestack fx noise attenuation ), 3d prestack multiple domain random noise attenuation, multiples attenuation, nmo of unsymmetrical hyperbola, dynamic replacement of wave equation, surface - inconsistent residual static, super bin stacking, poststack depth migration and prestack depth migration. all the techniques have been applied in seismic processing of 2d, 3d and wide - line profiling and obtained good results

    本文根據項目組研究成果，重點閘述了三維折射波靜校正技術，疊前波場分離相干噪音壓制方法（疊前fx去噪） ，疊前三維多域隨機噪音衰減技術，多次波衰減技術，非對稱雙曲線動校正技術，波動方程動態替換技術，非地表一致性的剩餘時差靜校正技術，超面元迭加處理技術，疊后深度偏移處理，疊前深度偏移處理等。
  5. In a single pass one has now achieved nmo application, stacking and filtering suitably blanked.

    現在我們一次就可以完成動校正、疊加和濾波，而且做了適當的切除。
  6. The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on

    主要包括：消除近地表因素對資料採集的影響，包括靜校正和噪音壓制技術等；疊前拓寬地震資料領帶，包括振幅補償和疊前反褶積技術等；藉助高精度速度分析、剩餘靜校正和高次項nmo技術，通過多次覆蓋疊加，消除資料中隨機噪聲干擾、提高資料信噪比，尤其是高頻端反射信息的信噪比，改善高頻反射和弱反射信號信噪比，提高「高頻反射死亡線」 ；疊後有限反射頗帶識別、抬高優勢頻率等。
  7. Based on the simple understanding of normal seismic processing, this paper has carried out deep research on the problems of deep prospecting in seismic data processing, such as s / n ( signal to noise ratio ), velocity analysis and residual nmo of unsymmetrical hyperbola, stacking and imaging of complex rays and migration arc. until now tens of accomplishments have been achieved

    在簡單了解地震資料常規處理的基礎上，本文針對當前深層資料的問題，緊緊圍繞著深層地震數據處理技術研究需要解決的重點問題，即信噪比問題、非對稱雙曲線的速度分析與剩餘動校正時差問題、復雜射線的迭加及偏移成像問題和偏移畫弧問題等，進行了深入的研究工作，目前已完成十多個成果。
  8. Firstly, this paper introduces the main concepts of digital filtering, nmo, statics, velocity analysis and stack and so on

    本文首先介紹數字濾波的基本概念、動靜校正、速度分析及水平疊加等等。
  9. If you are defining an application using nmo, define individual arguments in

    如果使用nmo定義應用程序，則在
  10. The nmo objects are in the

    Nmo對象位於
  11. Nmo objects are in the

    Nmo對象位於
  12. Replacement nmo class

    替換nmo類
  13. If you are defining an application programmatically, use nmo for to define actions

    如果您通過編程方式定義應用程序，則請使用nmo定義操作。
  14. If you are defining an application programmatically, use nmo to specify the database properties

    如果以編程方式定義應用程序，請使用nmo指定數據庫屬性。
  15. You can define these properties in an application definition file using xml or programmatically using nmo

    可以使用xml或以編程方式使用nmo在應用程序定義文件（ adf ）中定義這些屬性。
  16. Whether you configure notification services with an icf or with nmo, you provide the following information

    無論是使用icf還是使用nmo來配置notification services ，都需要提供以下信息：
  17. If you are configuring an instance of notification services programmatically, use nmo to specify the schema name

    如果通過編程方式配置notification services實例，請使用nmo指定架構名稱。
分享友人
分享到 Line

分享到臉書