no-load valve 中文意思是什麼
no-load valve
解釋
零載閥門-
Then a vsc controller using on - off valve and two potentiometers are designed for cushioning control system. it can realize the balanced, no shock, no reversing cushioning. experiments under different air pressure, load mass are carried out, and the results prove that the vsc controller can be used in pneumatic cushioning
第五章首先介紹了變結構控制的原理和應用發展情況，然後針對本實驗系統設計了一個使用開關閥和端位位移傳感器的變結構控制方案，實現緩沖過程的平穩無沖擊和無回彈要求，並在不同氣源壓力、不同負載質量下分析了控制性能的變化，實驗結果證明緩沖控制採用變結構控制是可行的，並具有很強的魯棒性。 -
One side, groovy cast steel flap valves increase the head loss, waste electricity, the other side, when flap valves close, it always delay time because of it ' s low proportion. the bump load seriously threaten the safety of pumping station. through the research and development of flap valve used in the renovation practices in the design of air - filled floating flap valve in no. 1 chuhe pumping station of anhui province, the working characteristics and design methods of air - filled floating flap valve are studied in this paper
但在拍門運行使用的同時，又時常暴露出一些缺陷，主要有：一是常規的鑄鐵或鑄鋼拍門加大了流道的水頭損失，特別是對于裝機容量較大的排澇泵站，其電能損耗相當可觀；二是拍門在自重下下落關閉時，往往由於過多考慮水頭損失導致浮重過小而延誤閉門時間，致使水體倒灌，再因緩沖裝置失靈導致閉門時門體對門框撞擊力很大，嚴重危及站身安全。 -
And then, a method of load - flow low - pressure measurement was proposed in the light of the hydraulic - resistance theory of servo valve. the validity of the method was proved by the experimental results. therefore, the measurement of the characteristic of load - flow and no - load flow can be realized by using this method
然後根據電液伺服閥的液橋理論提出了一種負載流量低壓測量方法，在所開發的測試系統上，利用電液比例閥模擬流量測量裝置對所提出的方法進行了試驗驗證，實現了利用低壓流量計和壓力傳感器進行電液伺服閥負載流量特性和空載流量特性的測量。
分享友人