non-axial load 中文意思是什麼

non-axial load 解釋
偏心載荷
  • non : adv 〈拉丁語〉非，不是 （＝not）。 non assumpsit 【法律】被告否認契約的答辯。 non compos mentis ...
  • axial : adj. 1. 軸的。2. 成軸的。3. 軸周圍的，軸向的。adv. -ly 在軸的方向，與軸平行地。
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  1. In this part, it is also found that the equivalent prismatic column, which is obtained based on the equal elastic critical load as the non - prismatic member, is not actually equivalent to the tapered column in inelastic stability, and the latter has higher load carrying capacity. finally, the behavior of tapered beam - column acted by combined axial load and transverse load has been investigated. a bending - thrust interaction curve is established which is similar to the ones for the design of prismatic members

    三是研究了楔形變截面懸臂構件在大端固定，小端同時承受橫向及軸向荷載共同作用下的強度和彎矩平面內的穩定，同時參考等截面構件的設計公式，得到了用大端截面來表示的軸力p與彎矩m的之間的相關關系。
  2. In this thesis, the experimental research of the behavior of high strength concrete axial compression columns and eccentric compression columns under non - uniform temperature field are conducted. from the experimental analysis, the variational regularity of ultimate load capacity and deformation of high strength concrete compression - flexure members under non - uniform temperature field is obtained. the influences of different factors including temperature, stirrup contents, strength grade of concrete, pre - loading level, eccentricity and different loading - temperature paths to refractory capability of members are investigated

    文中還對高強混凝土軸心受壓柱和偏心受壓柱在不均勻溫度場下的力學性能進行了試驗研究，通過試驗分析了高強混凝土壓彎構件極限承載力和變形在不均勻溫度場下的變化規律，考察了不同升溫溫度、箍筋用量、混凝土強度等級、預加荷載水平、荷載偏心以及荷載?溫度途徑等對構件耐火性能的影響，通過試驗量測，得到了構件的截面溫度場。
  3. In this paper, the buckling behavior of cold - formed angle members is studied by non - linear finite element method. the influence of the width - thickness ratio of the single cold - formed angle column under axial load is analysed. the criteria of flexural buckling and torsional - flexural buckling for cold - formed egual - leg under axial loads is presented. according the calculating results of the ansys finite element method, the stability - coefficient formulas are simulated for the cold - formed loading single angle members of flexural buckling and torsional - flexural buckling

    本文運用非線性有限元法對冷成型單角鋼的穩定性能進行了研究，分析了寬厚比對冷成型單角鋼軸壓桿穩定性能的影響，給出了等邊冷彎角鋼發生彎曲屈曲和彎扭屈曲的判斷條件，根據ansys有限元的計算結果擬合出了冷成型單角鋼軸壓桿在發生彎曲屈曲以及在發生彎扭屈曲時的穩定系數公式，在此基礎上得出了冷成型單角鋼軸壓桿在所有長細比情況下的穩定系數公式。
  4. In recent years, pro f bazant has been devoting to the work ofmicroplane theory microplane theory a theory on the basis of micro - mechanics, has excellent ability of describing not is iv only the concrete constitutive behaviors under non - proportional load but also the damage behavior of concrete under multi - axial stresses

    著名學者z . p . bazant教授近十年一直致力於微平面理論的研究，該理論對于描述混凝土在非比例加載下的本構行為和混凝土在多軸應力作用下的損傷行為具有優勢。
  5. The cold - formed square hollow section columns are widely used in various structures such as building structure, trusses, space frames and offshore plates etc. this paper is mainly doing the research on load carrying capacity of the cold - formed square hollow section columns under axial load, the paper includes the following main contents : ( 1 ) an elastic buckling stress for cold - formed square hollow section is presented by finite element analysis, and is compared with the result given by classical elastic buckling theory ; ( 2 ) the elastic - plastic non - linear behavior of the cold - formed square hollow section columns analyzed by ansys is presented ; ( 3 ) by using material model, and geometry nonlinear analysis, the cold - formed effect to stub columns of cold - formed square hollow section is studied ; ( 4 ) by using an material model, the geometry nonlinear analysis, the influence of initial geometrical imperfection to stub columns of cold - formed square hollow section is also analyzed ; ( 5 ) the load carrying capacity of the cold - formed square hollow section columns, which are including the cold - formed effect and influence of initial geometrical imperfection is analyzed by non - linear finite element, and the theoretical analysis results are compared with the results of experimental study and the results calculated by specification gb50018 - 2002

    冷彎方管作為軸心壓桿廣泛用於房屋結構、桁架、網架、塔架以及海洋平臺等結構中，本文主要研究軸心受壓冷彎方管的承載力性能，內容主要包括以下一些： （ 1 ）對冷彎方管的彈性臨界應力進行有限元分析，並與經典理論結果進行對比，以驗證有限元程序的適應性； （ 2 ）闡述冷彎方管採用有限元彈塑性非線性分析理論及應用ansys軟體的非線性分析方法； （ 3 ）採用彈塑性模型，考慮幾何非線性及材料非線性，對不同寬厚比的軸心受壓冷彎方管柱的冷彎效應進行有限元非線性分析研究； （ 4 ）考慮冷彎效應對屈服應力的影響，對不同寬厚比的軸心受壓冷彎方管短柱在不同初始變形下的承載力性能進行有限元非線性研究； （ 5 ）考慮冷彎效應、幾何初始變形，對不同長細比和不同寬厚比的軸心受壓冷彎方管長柱的承載力性能進行有限元非線性研究，並與試驗結果以及我國現行規范gb50018 ? 2002計算結果進行對比分析。
  6. Non - linear fem analysis for dynamic progressive buckling of thin - walled circular tubes under axial impact load

    受沖薄壁圓管動態漸進屈曲的非線性有限元分析
分享友人
分享到 Line

分享到臉書