normal corrosion 中文意思是什麼

normal corrosion 解釋
一般腐蝕
  • normal : adj 1 正常的，平常的，普通的；平均的。2 正規的，標準的，額定的，規定的。3 智力正常的，精神健全的...
  • corrosion : n. 腐蝕，侵蝕；【植物；植物學】溶蝕。 corrosion preventive 防腐劑。
  1. Normal heat shrinkable tube is universally applied in insulated protection of wire connector and terminal, soldered point, resistor and capacitor ; in anti - corrosion of metallic pod and as wire distinctive mark etc

    阻燃性熱縮絕緣套管廣泛應用於電線連接終端，電阻和電容的絕緣保護；金屬的防腐防銹；電線的標志等。
  2. The inner lining of such materials as br, nr, cr, fer, rpp, pvd, ptfe and f46 in the valve body of all kinds of cast iron and carbon steel or in the inwall of pipe castings can not only adapt to corrosion medium under different working conditions, but also can replace a great many rare and precious metal, which has, under the normal working conditions of valve, saved a large amount of funds for the users

    通過在各類鑄鐵、碳鋼的閥體或管件內壁上進行內襯br / nr / cr / fer / rpp / pvd / ptfe / f46等材料，不但可以適用於不同工況下的腐蝕性介質，而且可以替代許多稀有貴重金屬，為用戶在保證閥門正常使用的條件下節約大量的資金。
  3. 425 bolts, normal hexagonal head, threaded to head, in corrosion resisting steel, passivated - classification : 600 mpa at ambient temperature 425 c

    鈍化處理的耐蝕鋼的螺紋至螺栓頭的標準六角頭螺栓.等級: 600mpa
  4. According to bd s investigation results on reports of defective or fallen aluminium windows and professional opinions of the industry, under normal circumstances, aluminium rivets used in fixing window hinges may start to show signs of corrosion and loosening about 3 to 5 years after installation

    根據屋宇署就過往鋁窗損壞或墮下個案的調查，及行內專業意見，用於固定鋁窗窗鉸的鋁質鉚釘，在一般情況下可能在安裝后3至5年內開始出現銹蝕和松脫的象
  5. Brushed with the thickness of 1. 5 ~ 2. 0mm. it can improve the impermeability pressure up 3 times that of blank samples ; the crystalline reaction can continuously carry out, sealing the crack and waterproofing for ever if water is existent ; very good environmental adaptability, and can be used as normal at ph 3. 0 ~ 12. 0 ; moreover, the contrast tests of the performance of pt coating with two kinds of widely used waterproofing coating xypex and coprox were also carried out in this paper. test results show that the properties such as impermeability, self - rehabilitating ability and corrosion resistance are superior to those of the counterparts

    試驗結果表明， pt防水塗料具有如下的性能特點：具有良好的防水性能，塗刷厚度1 . 5 2 . 0mm ，抗滲壓力可提高3倍以上；在有水的條件下，結晶反應可以不斷進行，能實現自愈合、永久性防水；具有很強的環境適應性，在ph值3 . 0 12 . 0條件下均可正常使用；此外，本文還進行了pt防水塗料與同類型防水材料xypex和防水寶（二者都是目前應用廣泛的防水塗料）的性能對比試驗。
  6. Aerospace series - bolts, normal hexagonal head, threaded to head, in corrosion resisting steel, passivated - classification : 600 mpa at ambient temperature 425 c ; german version en 2887 : 1995

    航空航天系列.鈍化耐蝕鋼短螺紋公稱六角螺拴.等級: 60
  7. Cfrp tendon is a new composite material manufactured by special technology, it has many advantages such as high - strength, low - density, better corrosion - resistant and so on, so it can potentially replace steel tendons in normal concrete structures and prestressed concrete str uctures, particularly in areas where corrosion is a problem

    碳纖維塑料筋是採用特殊工藝製造的新型復合材料，它具有強度高，密度小，耐腐蝕等優點，能夠取代普通混凝土結構和預應力混凝上結構中的普通鋼筋和預應力鋼筋，尤其是在鋼筋銹蝕問題嚴重的地區。
  8. Aerospace series. bearings - spherical plain in corrosion resisting steel with self - lubricating liner, normal series. dimensions and loads

    航空航天系列.普通系列自潤滑軸襯耐蝕鋼制關節軸承.尺寸和負荷
  9. 425 en 2653 aerospace series. screws, 100 degrees countersunk normal head, slotted, threaded to head, in corrosion resisting steel, passivated. classification : 600 mpa at ambient temperature 425 degrees celsius

    航空航天系列.鈍化耐蝕鋼100度標準埋頭槽頭螺紋頭螺絲.等級: 600mpa
  10. With proper design and reliable construction, reinforced concrete structure owns good durability in normal surroundings. but if the conditions mentioned above can not be attained, the usage performance and endurance will be damaged because of the corrosion of steel tendons

    鋼筋混凝土結構如果設計得當，施工質量可靠，在正常環境條件下具有良好的耐久性，但當上述條件不滿足時常會因為鋼筋的銹蝕而影響結構的使用性和耐久性。
  11. Due to the influence of the corrosive agents in the outer environment, the resistance and dynamic reliability of the chemical structures declined with time very fast. and it is difficult for the chemical structures that with the normal design reliability level to fulfil their structural functions. on the condition that the design service life is confirmed, the design reliability level of the chemical structures should include the corrosive environment and its effect on the structures. based on agents ' corrosiveness fuzzy classification, this paper suggests a practical method on design reliability level decision - making of the industrial structures, which is very useful for the anti - corrosion design of the industrial structures

    化工結構由於受到外部腐蝕性介質環境的影響，其承載能力及動態可靠度水平隨使用時間衰減過快，按照普通結構設計可靠度水平設計的工業建築常難以順利完成設計使用功能.因此，在設計基準期預先確定條件下，化工結構的設計可靠度水平應綜合考慮腐蝕性環境及其對建築結構的影響特點來決策.根據介質腐蝕性模糊分級，提出了工業建築設計可靠度水平的一種實用決策方法
  12. Specification for bearings - spherical plain in corrosion resisting steel with self - lubricating liner - normal series - dimensions and loads

    軸承規范.帶自潤滑內襯的耐蝕鋼普通球面軸承.標準系列.尺寸和負荷
  13. List normal and special sources of acoustic or electromagnetic noise, serious vibration, sources of corrosion, and any other significant interfering parameter that might prevent successful measuring

    列出常見和特殊的聲、電磁噪聲來源，嚴重的振顫，腐蝕源以及所有有可能影響正常測量的干擾因素。
  14. 1. introduction for the pre - stressed concrete bridges in offshore and cold area, due to the corrosion effect of the corrosive agents in the environment to the structures, the safety of the bridge structures will decline with the service time, and this will affect the normal use of the bridge structures in the residual service time

    第一章緒論處于沿海地區及冬季寒冷地區的預應力混凝土橋梁，由於所處環境或冬季所採用的除冰鹽中氯離子的腐蝕作剛，導致結構安全性的降低，使結構不能保證其在後續使用期內的正常使用，造成較大的經濟損失。
  15. Cnx coating provided a comparable to or better surface than dlc for the normal cellular attachment, growth and morp hology. compared with dlc, cnx coating also exhibited higher hardness, lower coefficient of friction, lower roughness, and lower corrosion, which obviously contributed to more sp3c structure and indicated a longer wear and corrosion life for cnx coating

    本試驗中所制備的碳氮薄膜和類金剛石薄膜都具有很好的光潔度，但cn膜表面的針狀突起少於dlc膜表面，整體更加勻實光滑，三種薄膜的硬度和拉伸強度都很高，顯示出良好的機械性能和很低的摩擦系數。
  16. Corrosion durability and maintenance control of pre - stressed concrete bridge compared with that of normal reinforcement, the corrosion damage characters of pre - stressed steel have its own specialty

    第三章預應力混凝土橋梁的腐蝕耐久性及控制維修與擰通鋼筋的腐蝕特點相比，預應力鋼筋的腐蝕破壞牡點則有所不同，有其特殊性。
  17. The probability distribution of the ratio of the maximum corrosion depth to the general corrosion depth was analyzed. through k - s test, it was found that this ratio follows the normal distribution or the lognormal distribution, which constructs a relationship between the mean corrosion condition and the worst corrosion condition

    分析了最大腐蝕深度與平均腐蝕深度比值的概率分佈特徵，通過k - s檢驗分析表明比值分佈為正態分佈或對數正態分佈，這個指標建立了鋼筋銹蝕整體平均狀況與最嚴重狀況的關系。
  18. Corrosion protection of burried valves ; coating for normal requirement

    埋設管道的腐蝕保護.第1部分:公稱要求的塗層
  19. Bearings, airframe rolling - rigid single row ball bearings in corrosion resisting steel - diameter series 0 and 2. normal clearance category - dimensions and loads

    機體軸承.耐蝕鋼的剛性單列球軸承. 0號和2號直徑系列.標準游隙類.尺寸和負荷
  20. Dihydrothiazole was synthesized and mixed with normal corrosion inhibitors

    摘要將二氫噻唑衍生物與其它緩蝕劑進行了復配。
分享友人
分享到 Line

分享到臉書