on-off controller 中文意思是什麼

on-off controller 解釋
開關控制器
  • on : adv 1 〈接觸、覆蓋〉上去；開（opp off）。 turn on the light [radio water gas] 開電燈[收音機、自來...
  • off : adv 1 〈運動〉向那邊，隔開。 be off 走，去，逃。 I must be off 我得走了。 Where are you off to 你...
  • controller : n 1 管理人，主管人。2 （會計的）主計人，檢查員；〈英國〉（特指宮廷、海軍等的）出納官〈常作 comptr...
  1. Limited service controller " on - off " switch must be in the extreme “ off ” position to open the enclosure door

    在打開外殼門之前，要保證開關處于「關閉」位置，否則，不能對控制裝置的開關進行維護修理。
  2. Then a vsc controller using on - off valve and two potentiometers are designed for cushioning control system. it can realize the balanced, no shock, no reversing cushioning. experiments under different air pressure, load mass are carried out, and the results prove that the vsc controller can be used in pneumatic cushioning

    第五章首先介紹了變結構控制的原理和應用發展情況，然後針對本實驗系統設計了一個使用開關閥和端位位移傳感器的變結構控制方案，實現緩沖過程的平穩無沖擊和無回彈要求，並在不同氣源壓力、不同負載質量下分析了控制性能的變化，實驗結果證明緩沖控制採用變結構控制是可行的，並具有很強的魯棒性。
  3. Several semi - active control algorithms used in the semi - active suspension system with mr dampers are proposed and developed including the " on - off " voltage controller, the continuously linear variable voltage controller, the modulated continuously linear variable voltage controller based on " sky - hook " damping concept and the hybrid controller based on the combination of " sky - hook " damping concept and " ground - hook " damping concept and the fuzzy logic controllers using measurements of the relative displacement between the sprung and unsprung mass or the absolute acceleration of the sprung mass as the input variables of fuzzy logic controllers. the simulation models were prepared in matlab ? simulink ? fuzzy toolbox programs. the experiment setup of the semi - active suspension system with mr dampers in the lab has been designed and developed

    根據磁流變阻尼器特性和對懸架系統動力學特性的規律性研究，為磁流變阻尼器設計了基於「天棚」阻尼控制概念的「 on - off 」 、線性連續和修正的線性連續控制策略，基於「地棚」阻尼控制概念的磁流變阻尼線性連續控制策略， 「天棚」阻尼和「地棚」阻尼控制概念線性組合起來的磁流變阻尼混合控制策略，根據模糊控制原理設計了以簧載質量和非簧載質量間相對位移或簧載質量加速度分別作為輸入變量的模糊邏輯控制器用於磁流變阻尼半主動懸架的智能控制。
  4. The control method was introduced and the hardware of the controller was designed. the controller uses the 89c52 and 89c2051 as the main control unit and produces the on and off and angle signal of each phase. combined with protecting signal and current chopping signal, it can control the igbt on and off

    介紹了srd的控制方式和本系統所採用的控制策略，對控制器的硬體電路進行了設計，控制器以89c52和89c2051雙cpu為主控單元，採用模糊調節，發出相通斷信號和角度信號，並和電流、電壓等保護信號以及斬波信號相結合，實現對主功率元件的通斷控制。
  5. For a cubic crystal of 1cm 1cm 1cm, the horizontal and vertical selective angles are 0. 008 and 0. 41 respectively. so the system is capable of storing 10000 holograms. we also have made an off - line heater and an on - line heater, both of which are controlled by a temperature controller ( model eurotherm )

    對于邊長為1cm的立方晶體，復用系統在水平方向和垂直方向上的選擇角分別為0 . 008和0 . 41 ，能夠存儲10000幅數據頁；復位裝置的角度復位精度優於0 . 001 ；溫控加熱裝置的控溫精度為0 . 1 。
  6. The control method is introduced and the hardware of the controller is designed. the controller uses the tms320lf2407 of ti company as the main control unit and produces the on and off and pwm signal of each phase controlling the igbt on and off

    介紹了srd的控制方式和本系統所採用的控制策略，對控制器的硬體電路進行了設計，控制器以ti公司的tms320lf2407為主控單元，發出相通斷信號和pwm信號，實現對功率元件的通斷控制。
  7. The hardware of the system comprises the five sub - systems, i. e. welding power source, arc length controller, welding wire feeder, welding head traveller and detector. the software is composed of the off - line serving program and the on - line executing program

    此系統的硬體主要包括五個子系統，即：焊接電源、弧長控制器、送絲機構、焊矩行走機構和檢測機構；軟體包括在線執行程序和離線服務程序。
  8. The controller uses the tms320f240 of ti company as the main control unit, adopts pi digital adjusting and pwm controlling, produces turn - on and turn - off signal of the igbt, combining with the protection current and voltage

    該控制器以ti公司的tms320f240為主控單元，採用pi數字調節及pwm控制，並結合電流、電壓保護，實現對主功率器件的通斷控制。
  9. On - off controller

    通斷控制器
  10. This series the machine adopt the programmable controller of plc the control, and have the point start, the half auto operate the way with full - automatic etc., and adopt the hands button the operation, and the pressure can within the scope of certain and arbitrarily regulate, and the route of stroke then pass the route of stroke on - off to arbitrarily regulate, and operate simple, vivid, safety is dependable

    本系列機器採用plc可編程式控制制器控制，具有點動、半自動和全自動等操作方式，採用雙手按鈕操作，壓力可在一定范圍內任意調節，行程則通過行程開關任意調節，操作簡便、靈活、安全可靠。
  11. The on / off control performances of the skyhook damper in semi - active suspension system, the occur of chatter and its avoiding are analysis. the continuous damping rules are derived according to the feature of damping curve given by the controller in active control system

    首先對主動懸掛系統阻尼控制中的天棚阻尼原理在半主動懸掛中的應用進行了研究，分析了其開關控制特性、顫振及其避免方法；根據主動懸掛控制信號的特點導出了連續阻尼控制規律。
  12. Including picking control system designed by two - chip structure controller and system of let - off & take - up motion based on servo control. and some deep research on tension control and start mark compensation

    包括two - chip結構的控制器實現的選緯控制系統以及基於伺服控制的送經及卷取系統，並對張力控制以及開車痕補償問題進行了深入研究分析。
  13. The controller is a single refrigeration controller, it contains compressor startup delay protection, temperature sensor error alarm and other functions, the controller can run regularly with set on - off rate when error

    本控制器為單製冷溫度控制器，具有壓縮機開機延時保護溫控探頭故障告警功能，溫控探頭故障時可以按設定的開停比定期運行。
  14. This system has various kinds of sensors, such as pressure, temperature, electric current, voltage, controlling synthetically, etc. after a sensor does not work or takes off the line, other sensor of on - the - spot equipment will serve as the commander or the controller. so the system does not be influenced with for some sensor ' s trouble. this is the best advantage of control system based on fieldbus

    由原集散控制系統（ dcs ）升級為fcs系統，本文所討論的系統有壓力、溫度、電流、電壓、綜合控制等各種傳感器，當一個傳感器失靈或脫線后，其它有關傳感器會自動擔任指揮員或調度員，系統不會因為某一節點的故障而影響整個系統的運行，這是基於現場總線控制系統（ fcs ）的優勢。
  15. A bandwidth - limited active suspension controller for off - road vehicle based on co - simulation technology

    基於聯合模擬技術車輛有限帶寬主動懸架控制系統
  16. Carlos eduardo jeronymo, hironao yamada, takayoshi muto. adaptive predictive controller for hydraulic system driven by fast - switching on / off solenoid valves [ j ]. jsme international journal, series c, 1996, 39 ( 3 )

    劉忠，楊襄璧，趙宏強.基於高速開關閥的液壓控制系統及其控制方式的應用研究[ j ] .鑿巖機械氣動工具， 1998 （ 4 ）
  17. A survey of the current fluid dispensing technology is given at first, including its history, present situation and development trend. then the paper introduces the robots which are used in the dispensing process, with their characteristics and working situation. the control system scheme for the bench top robot which is selected as the dispensing motion platform is discussed and the final integrated control scheme is adopted which consists of off - line programming system based on cad / cam and motion controller based on dsp

    論文首先對點膠技術的歷史、研究現狀和發展趨勢進行了介紹，然後介紹了點膠工藝中所使用的機器人的種類、特點及使用場合;本課題選用了桌面型直角坐標機器人作為點膠的運動平臺，並採用時間/壓力型點膠方式，對直角坐標機器人控制系統方案進行了討論，制定了基於cad / cam機器人離線編程系統， dsp機器人控制器的集成控制系統方案。
  18. Almost every program for programming a plc controller possesses various useful options such as : forced switching on and off of the system input / outputs ( i / o lines ), program follow up in real time as well as documenting a diagram

    幾乎所有用於為plc控制器編程的程序都擁有各種不同的選項，例如系統輸入/輸出（ i / o線）的強制開關，程序實時跟蹤以及圖表驗證。
  19. The controller will turn on the compressor and turn off the cross valve after turning on the defrosting, and then use heat pump to defrost

    化霜啟動后開壓縮機關四通閥，利用熱泵化霜。
  20. Based on the heating treatment control system of a spring steel - wire production line in a factory, hubei province, the paper deals with the design of fully automatically monitoring system across its manufacturing process. through research of parameters of temperature control during the period of heating, annealing and tempering in steel wire manufacturing process, the corresponding composite intelligence fuzzy controller is designed. in light with the way of fast heating, a composite intelligent fuzzy controller combined with on - off control & pi control is set up

    本文以湖北某鋼絲繩廠彈簧鋼絲熱處理生產線控制系統為依託，論述了整個生產過程的監控系統的設計，通過對該類鋼絲生產中的快速加熱過程、退火、回火等過程中的溫度控制參數的研究，設計了相應的智能型復合模糊控制器，根據快速加熱過程的實現方式，對于快速反應的被控對象，給出了以模糊控制為基礎的結合開關控制、 pi控制的快速升溫，且不超調的一種智能型復合模糊控制器，對于退火、回火等工藝過程，採用電加熱方式，該類工藝過程作為控制對象屬于具有純滯后的大慣性系統，作者設計出模型預測自適應模糊控制器，並對所設計的控制器進行計算機模擬實驗，取得了滿意的效果。
分享友人
分享到 Line

分享到臉書