operating loads 中文意思是什麼
operating loads
解釋
工作荷載-
Or, if have the same operation loads, the downcomer size of ctst tray can be designed smaller than the fl valve tray. it was found that ctst plates have bigger operating capabilities than other traditional plates in coping with foaming systems
總之，在處理兩種物系，尤其是易發泡物系時， ctst與f1浮閥等傳統塔板比較，其降液管操作能力大得多。 -
The exhaust emission of a diesel engine differs in different operating condition. in order to study the fuel - economy and exhaust emission performance of vehicle turbocharge - intercooled diesel engine on all steady operating conditions, on yc4112zlq d. i. turbocharge - intercooled diesel engine, 72 operating conditions ( 8 speeds, 9 loads per speed ) were tested under steady operating condition
為了在整個工況范圍內研究車用增壓中冷柴油機的經濟性與排放性能，作者在柴油機穩定運轉狀態下，對yc4112z _ lq （ 125kw 2300r min ）型直噴式增壓中冷柴油機的72個工況點（ 8個轉速，每個轉速9個負荷點）作排放特性試驗研究。 -
Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。 -
The plexiglass model test is carried out by two selective shape, the stress of each test operating loads was obtained in order to validate the correctness of the finite element modeling. in this paper, a regularity of shear lag effect of main sections in two kinds of box girder is given. as the foresight project of double - level - driveway continuous box girder, this research fully utilizes the space of box girder structure and flexural and torsional properties of high - depth box girder, which have innovative significance and applied foregroundin engineering
對所選擇的結構形式進行縮尺有機玻璃模型試驗，得到實腹連續箱梁和空腹箱梁在各種試驗工況荷載下的應力，通過換算分析，驗證了本文所建立的有限元模型的準確性，由此得到兩種箱梁各主要斷面剪力滯效應的變化規律。 -
Based on the theories of gear engagement, contact analysis, friction and heat transfer, a three - dimensional finite element model of gear tooth was established to investigate temperature distributions and variations along the contact path over a range of applied loads and operating speeds with consideration of lubrication conditions. sensitivity analysis of surface temperature to gear configuration, frictional heat flux, heat transfer coefficients, and oil and ambient temperature was conducted and the major parameters influencing surface temperature were evaluated
本文基於齒輪嚙合原理、輪齒接觸分析、摩擦學和傳熱學，以有限元分析方法和理論分析計算相結合為手段並以實驗測量結果作為參考，建立了適用於工業應用並具有較高計算精度的高速齒輪傳動輪齒溫度分析的模型和方法，系統地分析了輪齒本體溫度的大小和分佈以及齒輪幾何、載荷及轉速和潤滑冷卻條件等對輪齒本體溫度的影響。 -
The advantages and the disadvantages of every structure and every flow rate dividing method are analyzed. further requirement of techniques and problems to be investigated are pointed out in this chapter. then it presents a new idea of flow rate dividing method based on pressure decrease sensing and meter - in flow rate feedback control to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第一章緒論綜述了多執行器系統的概念、基本構成和一些分流控制方法，分析了各種分流控制結構和分流控制方法的優缺點，在此基礎上指出了一些所需要進一步研究的問題；接著提出了論文的選題意義和一種基於壓差傳感和執行器進油側流量反饋的分流控制方法來實現大小慣性多執行器流量合理分配的構想。 -
Ethernet direct product & solutions work reliably under extreme conditions, such as electromagnetic interference, high operating temperatures and mechanical loads
鴻道科技的產品和解決方案在極端的條件下仍可靠地運轉，例如電磁干擾、較高的運作問題和機械載荷。 -
Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system. special analysis about simultaneously operating multi - actuators with different inertia loads is made. finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient
第三章介紹了基於執行器進油側流量反饋的分流控制的原理，並針對大小慣性執行器同時起動時採用該分流控制方法進行了具體分析；最後通過模擬說明該分流控制方法能在大小慣性執行器同時起動並在泵輸出流量不足的情況下有效提高泵輸出流量的利用率，並能實現優先級和分流比混合控制。 -
Abstract : for offsbore oil fields with large power and heating loads, butlack of asaociated gas, the solution of power and heating co - generation will improve theovemll energy efficiency and cut down operating costs, thus improving the mteof return and lowering the barrel oil xost
文摘:對于電負荷和熱負荷都比較大而伴生氣量嚴重不足的海上油田，實現熱電聯供將會提高能源綜合利用率，節省操作費用，從而提高油田收益率，降低桶油成本。 -
The simulation models of balance traction transformer with two connection symbols are established. the operating state of transformer with symmetric and unsymmetric loads in secondary side is analyzed
摘要構建了兩種聯結平衡牽引變壓器的模擬模型，分析了二次側對稱和非對稱負載時變壓器的運行狀態。 -
Earth - moving machinery - loaders - part 5 : calculation and verification methods for rated operating loads
運土機械.裝載機.第5部分:額定工作載荷的計算和驗證方法 -
It brings about the problems of low flow - used ratio and bad harmony in flow dividing control when simultaneously operating multi - actuators with different inertia loads. this paper is aimed to solve these problems by method based on pressure decrease sensing and meter - in flow rate feedback control of actuators. in this paper, several important points including theoretical analysis, computer simulation, and experiment study will be explained
本論文主要針對因執行器所驅動慣性負載的差異而引起流量利用率低和協調性不佳的問題，提出了一種基於壓差傳感和執行器進油側流量反饋的分流控制方法，並進行了相應的理論分析、模擬研究和實驗研究。 -
Additionally, the dry - pit submersible pumps shall operate within the acceptable field vibration limits as established by the hydraulic institute for this class of equipment at all speeds and loads within the operating range specified herein
此外，乾井潛水泵應該能夠在美國水利協會為這類設備規定的可接受的現場振動范圍內，在本說明書的工作范圍內，以全速、滿負荷進行正常運轉。 -
In addition, aerodynamic stiffness and aerodynamic damping on the system are already obtained in the condition of fluid - structure interaction. it is known that aerodynamic loads are associated with blade vibration. the systematic eigenvalues are used to judge whether the flutter occurs so as to find the stable operating range of a wind turbine
本文把風力機葉片簡化為懸臂梁，對梁截面的二維葉型建模，完整推導了二維葉型的線性運動微分方程和流構耦合條件下系統的氣動剛度和氣動阻尼，此時氣動載荷與結構的位移矢量以及速度矢量是相互耦合的，再利用系統的特徵值來判斷葉片顫振是否發生，從而獲得風機的穩定工作范圍。
分享友人