optical window 中文意思是什麼

optical window 解釋
光學窗口
  • optical : adj 眼的;視覺的;視力的;幫助視力的;光學(上)的。 optical activity 【物理學】旋光性。 an optic...
  • window : n 1 窗;窗口,窗戶;窗扉,窗框;窗玻璃;(商店的)櫥窗;【計算機】窗口〈電腦視頻顯示器屏幕上的視...
  1. Under the applied voltage of 2v, the duration of colored process and bleaching process of the semisolid - state smart window was 2s and 1. 5s respectively, which denoted rapid response velocities. researches on the glass / ito / wo3 / linbo3 / niox / au all solid - state smart window were referred to the effect of each film ' s thickness on the device ' s electrochromic properties. through the test of the visible light transmittance of the colored state and bleaching state of the device, it proved good electrochromic capabilities with the dynamic optical density changed between 0. 2 - 0. 5

    並在此基礎上繼續研究了glass ito wo _ 3 linbo _ 3 nio _ x au結構的全固態智能窗器件模型,對于各薄膜層厚度對于器件電致變色性能的影響做了初步的研究,測試了器件可見光范圍內的著色褪色透射光譜,光密度變化量在0 . 2 0 . 5范圍內,表明器件具有良好的電致變色性能。
  2. And it should be linear polarization in s direction by analyzing the relations between the reflection, absorption loss of optical thin film at oblique incidence and the polarization state, and at this time the brewster window made of very low - absorption material can be used

    通過對斜入射高反射鏡反射率、吸收損耗與光束偏振特性間的關系進行分析,表明諧振腔內的本徵振蕩最好應為s方向的線偏振光,這樣光束輸出窗口還可採用布儒斯特窗。
  3. The main work can be summed up as follows : firstly, we studied the thermal - field properties of vcsels, and analyzed the influences of current spreading, material parameters and operating conditions on the temperature distributions. secondly, we began with the electrode voltage and calculated the equipotential s distributions, compared the distributions of voltages and current densities in different depths of vcsels, and then studied the influences of the oxide - confining region with different position or thickness, and the different sizes of the gain - guided aperture and emitting window on the distributions of the injected current density, carrier concentration and temperature in the active region. thirdly, we realized the coupling of electricity, optical and thermal - fields, worked out the threshold voltage, calculated the distributions of the injected current density, carrier concentration and temperature under different offset voltages, and analyzed the impacts of temperature profile and carrier density on the refractive index, fermi levels and optical - field

    具體工作可以概括如下:首先,研究了vcsel的熱場特性,分析了電流擴展,材料參數和工作條件對于溫度分佈的影響;其次,從電極電壓入手,計算出激光器中的等勢線分佈,並對不同深度處的電壓和電流分佈進行比較,研究了高阻區的不同位置和不同厚度、限制層和出射窗口半徑的大小對電流密度、載流子濃度和溫度分佈的影響;再次,實現了電、光、熱耦合,求出了閾值電壓,計算了不同偏置電壓下的電流密度分佈、載流子濃度分佈和熱場分佈,分析了溫度和載流子濃度變化對折射率、費米能級和光場的影響;最後,給出了考慮n - dbr和雙氧化限制層時激光器中的等勢線分佈,分析了n - dbr和雙氧化限制層對vcsel電流密度、載流子濃度、溫度和光場分佈的影響。
  4. The new algorithm starts from an initial estimate which is based on the hough transform, and a rectangular window is centered using the current line approximation, and a new line estimation is generated by making a total least squares fit through the pixels contained within the window. this is repeated until convergence is reached. lastly, we have suggested a new technique which may recover the motion and structure parameters of a moving object by using of 21 optical flow lines based on the optical flow fields of the feature line this thesis is the project supported by aeronautical foundation science ( no. 99f53065 ) and research center of measuring and testing technologies, and control engineering in nanchang institute of aeronautical technology ( no. 2001 - 15 )

    演算法的思路是:首先,在小區域內運用霍夫變換確定直線的初始值;其次,以直線的初始值所對應的直線為中心線,建立一個矩形框;最後,利用矩形框內所包含的邊緣點數據不斷地迭代直至收斂,從而達到進一步修正直線的坐標參數;本文基於特徵直線的光流場,即線流場,建立了一種利用21條光流線確定空間三維物體旋轉運動參數、平移運動參數以及對應的空間直線坐標的線性演算法。
  5. Sectional specification for class ivd nonzero dispersion single mode optical fibers for 1550 nm window

    1550nm窗用ivd級非零色散單模光纖的分規范
  6. Blank detail specification for class ivd nonzero dispersion single mode optical fibers for the 1550 nm window

    1550nm窗用ivd級非零色散單模光纖的空白詳細規范
  7. Diamond is a remarkable material due to its special crystal structure, which shows high hardness, low friction coefficient, high thermal conductivity, high optical transparency, low permittivity and high band gap etc. cvd diamond films are widely used in mechanical coating, heat sinks, optical window, semiconductor devices and other application fields because of its low price and high performance

    金剛石的特殊晶體結構使其成為一種性能優異的功能材料,它具有高硬度、低摩擦系數、高熱導率、高透光率、低介電系數和高禁帶寬度等性質。化學氣相沉積制備金剛石膜成本低、質量高,廣泛應用於工具塗層、熱沉、光學窗口、半導體器件等方面。
  8. Because this wavelength coincides with the minimum loss window of conventional silica - based optical fiber, many works are currently devoted to the study of er doped materials

    由於此波長與常用的si基光纖的最小傳輸窗口對應,因而吸引了許多研究者從事er摻雜材料的研究。
  9. The reasonability of fadw designing should be proved experimentally, so this paper studies the various running properties of the fadw whose output window ' s size is 30mmx30mm experimentally. it uses the methods of the far - field beam profile measurement, the lateral shearing interferometer ( lsi ) and the hartmann - shack wavefront sensing to measure the window ' s optical qualities when the fadw works in the situations of different inlet total gas pressure

    夏克波前傳感器分別對現有的口徑為30mmx30mm的氣動窗口的光學特性和對輸出激光光束質量的影響進行了實驗測量和分析,同時建立了氣動窗口的性能測量的實驗方法,並分析了fadw對輸出激光影響的物理機制(如類透鏡效應等) 。
  10. It is well known that for an optical pulse, its distribution in time domain is infinite. but only a limited time window width t _ ( w ) may be selected in numerical calculations because of the limitation of the microcomputer. therefore, the selection of t _ ( w ) is also a key aspect that should be considered carefully in numerical simulations

    基於此,本文提出了利用分步傅里葉方法計算光脈沖在光纖中傳輸時間窗口的選取方法,給出了正確模擬光脈沖通過不同長度的光纖后光脈沖的變化所要選取的時間窗口(即計算過程中所取的積分上下限之差) 。
  11. Typical temperature is 800 - 1000 in cvd diamond process, while the high temperature limits its application in optical window and coating such as gaas, zns etc. low temperature can not only make diamond crystal nucleus finer, reduce surface roughness of diamond films and lessen light dispersion, but also eliminate thermal stress

    化學氣相沉積金剛石膜過程中,襯底的典型溫度為800 1000 ,這么高的溫度限制了其作為gaas 、 zns等低熔點光學材料窗口和塗層的應用。低溫沉積金剛石膜不僅可以使晶粒細化,降低表面粗糙度,減小光的散射作用,而且可以消除熱應力。
  12. The experiment results are valuable to the research of infrared lens, laser window, integrated optical device, the device for blue semiconductor laser, optical detector, nonlinear device, optical waveguide, thz emitter and other devices the following is a brief summary of the works conducted in this thesis and the results achieved

    實驗結果有助於這些材料作為紅外透鏡、激光窗口、集成光學器件,藍光半導體激光器件、光探測器件、非線性光學器件、波導調制器件、 thz發射器件等的研究。
  13. Our technical team has successfully completed the research and the production of laser protection lens, laser coatings in watch window of tank for national defense project of 123, and also those of other optical coatings

    公司科研人員曾成功完成「國防123工程' '坦克視窗中鐳射防護鏡,鐳射薄膜及其他光學薄膜的研發,生產。
  14. By analyzing the relation between the refractive index and the temperature and the stress field of the optical window in the aero - dynamic environment, according to the thermal - optical effect and the elasto - optical effect, we obtained the relationship of the index - of - refraction and temperature and stress, and explored the further study method of the aero - optical effect

    摘要首先從熱光效應和彈光效應的角度,分析了飛行器在大氣層內飛行時,在氣動熱環境中的材料折射率與溫度場和應力場的關系,得出了溫度和應力對材料折射率的影響關系式,並進而探索氣動光學效應下一步的研究方法。
  15. Furthermore, as the high - power co2 laser is widely used, especially the development of the research on co2 laser propagating in atmosphere and window material in infrared band, the research on the surface thermal distortion in optical thin film irradiated by 10. 6 m laser is more and more important

    而且,隨著高功率co _ 2激光器應用的日益廣泛,特別是國內外有關co _ 2激光大氣傳輸研究工作的進展以及紅外波段窗口材料的研究,使10 . 6 m激光輻照下光學薄膜熱畸變和微弱吸收研究具有重要意義。
  16. In this work, after giving the selective method of the time window width and the minimum time window width required for corrected calculations of optical pulse propagation in fibers, the shapes of various incident pulses after passing through different fiber lengths have been simulated by selecting different time window widths

    在此基礎上,對不同的光脈沖在光纖中的傳輸進行了數值模擬,發現前人得出的超高斯光脈沖在光纖中傳輸會由於色散而產生脈沖形狀扭曲這一結論是錯誤的,並指出了錯誤的原因所在。
  17. For example, light emits from the surface of a typical main sequence star falls mainly in the optical window. that is why we can see our sun in daytime and countless stars at nighttime

    例如,大部分主序星表面發射出來的輻射是可見光,因此我們能夠在日間看見太陽,夜間看到漫天星斗。
分享友人