outlet temperature 中文意思是什麼
outlet temperature
解釋
出口溫度- outlet : n. 1. 出口，出路；排水口；通風口。2. 【商業】銷路。3. 批發商店。4. 發泄（情感）的方法；排遣。5. 地方廣播電臺[電視臺]。
- temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
-
In this paper, using phoenics software to compute and analyze the variety rule of the convecting transfer heat at the basis of computing and analyzing the temperature and velocity field of one underfloor supply air room with a focus hot source, and concluding that the number of the hot source and the supply air outlet > the intensity of the hot source and the volume of supply air will influence convecting transfer heat, and obtained its correlativity formula
本文針對一下部有集中熱源的地板送風空調小室，利用phoenics軟體，在計算分析小室內氣流的速度場及溫度場的基礎上，對對流熱轉移量的變化規律做了計算分析，最後得出對于下送風小室的對流熱轉移量與熱源的個數、送風口個數、熱源強度、送風量等因素有關，並且得出了其相關關系式。 -
Sluice gate of double disk is controlled by electric - hydraulic handspike ; plc will compare sand temperature on outlet according to pre - designed value and inner sand temperature of double disk ; and then it adjusts close time of sluice gate, controls residence time of hot sand in double disk ; therefore, it can control sand temperature of outlet and make it reach required value.
雙盤的卸砂門由電液推桿控制， plc根據預設的出口砂溫與實測的雙盤內砂溫進行對比，而調整卸砂門的關閉時間，控制熱砂在雙盤內的停留時間，進而控制雙盤出口砂溫使其達到要求。 -
This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation
本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。 -
The goal is to control the water outlet temperature by manipulating the flow rate of the steam and control the water inlet rate by manipulating the height of the water level in the water tank
本文中，換熱器的控制任務主要有兩個，首先通過控制水箱進口水閥門開度，進而控制水箱水位，進而控制換熱器進口水流量。 -
The recovery of atmospheric light oil yield of atmospheric in the northern atmospheric distillation tower of shenghua teaching & test factory, science and technology group of china university of petroleum has been increase by about 4 or 5 percent through the following methods : changing the tray perforation of atmospheric tower, adjusting the amount of stripping steam and the outlet temperature of the atmospheric heater and merging atmospheric excess vapor into 3rd atmospheric drawn - stream to keep the fractions content of bottom oil below 5 % before 350
摘要中國石油大學科技集團勝華教學實驗廠北常減壓蒸餾裝置換煉勝利管輸油后，通過改變常壓塔塔盤開孔率、調節常壓塔汽提蒸汽量和常壓爐出口溫度、常壓過汽化油併入常三抽出線等措施，控制常壓塔底油350前餾分含量小於5 % ，使常壓輕質油收率提高約4 % ~ 5 % 。 -
In order to realize the on - line prediction the baking temperature of ladle lining, and to study its temperature uniformity, a 3 - d transient mathematical model with multi - inlet and multi - outlet of ladle heating facility facilities was built
摘要為了對鋼包的烘烤溫度進行在線預測，筆者耦合了流體流動、燃燒和換熱過程，建立了多入口、多出口的三維非穩態鋼包烘烤數學模型。 -
This paper describes how to calculate the temperature of high - temp gas at the outlet of combustor by means of limited gas composition and analyses how errors in measuring gas composition, low calorific value of fuel, fuel composition and fuel temperature, etc. affect gas temperature
摘要敘述了一種根據有限的燃氣成分推算燃燒室出口高溫燃氣溫度的計算方法，並分析了燃氣成分測量誤差、燃料低熱值、燃料成分及燃料溫度等對燃氣溫度的影響。 -
It is discovered that the combustion condition of the second stage pc is up to the outlet temperature of the first stage pc and the content of combustible gases in first stage flue also plays positive effect on the ignition of second stage pc. the effects of parameters of two coal - air mixture, wall temperature of first ignition chamber and annular filling air on imfit are studied experimentally in this thesis. in this thesis, the numerical simulations of ignition and combustion of pc in imfit are conducted
本文通過建立數學模型，對感應加熱煤粉多級無油點火進行數值模擬，研究了一級煤粉煤粉在點火室內的著火過程和二級點燃過程、煤粉粒徑分佈對煤粉多級無油點火的影響，研究了一級點火室壁面溫度、一級煤粉氣流和二級煤粉氣流的風粉參數在煤粉多級無油點火過程中的影響規律；根據二級點燃段的流場和溫度場分佈，研究了環形夾心風推遲二級煤粉著火的機理。 -
When temperature changed, in order to keep the outlet temperature of the cooling water stable, we can change the areas of draught deflectors, so the speed and area of the draught is changed, which will improve the safety and economy of the running assembling sets with the assumption of economizing water in winter
當外界溫度發生變化時，為保證出塔水溫不發生變化，可通過改變擋風板面積的方法，使進風口面積及進塔風速發生改變，進而保證出塔水溫，保證冷卻塔在冬季的正常運行。 -
In the matter - in - loop simulation experiment of aero - engine control system, the turbine outlet temperature, which characteristics with high and quick change, is hard to be simulated
航空發動機控制系統半物理模擬試驗中，渦輪出口氣體溫度高、變化快，難以模擬。 -
Abstract : the empty tower was retrofitted because the outlet temperature of as high as 83 threatened the safety of downstream frp equipment and restricted further increase in output
文摘:由於生產能力的提高，凈化系統空塔出口氣體溫度高達83 ，不僅使下游玻璃鋼設備的安全受到威脅，也制約了生產能力的進一步提高，於是對空塔進行改造。 -
Behavior of flow and heat transfer in venturi tube was simulated numerically and the relationships of outlet temperature, mass fraction of vapor and pressure loss with spraying flow rate were obtained
當噴射流量小於臨界噴射流量時，出口爐氣的溫度和水蒸氣質量分數隨噴射流量的增大分別呈線性下降和上升關系；當噴射流量大於臨界噴射流量時，爐氣降溫和水蒸氣質量分數增長不顯著。 -
The paper takes single factor analysis with every factor. these factors include outlet temperature 、 outlet velocity and outlet diameter
這些因素包括送風溫度、送風速度、送風口直徑、送風方式等。 -
In summer, outlet velocity which is 8m / s and outlet temperature which is 19 are the best. in transitional season, outlet velocity which is 10. 2m / s is the best. in winter, outlet velocity which is 9. 9m / s and outlet temperature which is 24 are the best
在夏季，應選擇8m / s的送風速度和19的送風溫度；在過渡季，應選擇10 . 2m / s的送風速度，將未經處理的室外新風直接送入室內；在冬季，應選擇9 . 9m / s的送風速度和24的送風溫度。 -
Through static emulating calculation of the high - pressure heater, the influence of high - pressure heater leakage upon its operation paeameters, such as outlet temperature of the feed - water, pressure loss of the steam extraction pipeline, and temperature of the drain, has been analysed
摘要通過對高壓加熱器的靜態模擬計算，分析了高壓加熱器?漏對其運行參數，如給水出口溫度、抽汽管道壓損、疏水溫度的影響。 -
Finally, in order to solve the problems encountered in experiment, an improved design, including gas path, mechanism and controller design, is proposed. experiments are accomplished in the improved system platform, and the results demonstrate that the improved system can meet the requirement of simulating the turbine outlet temperature of aero - engine
最後，針對試驗中遇到的問題，從氣路部分、機械部分以及控制器三個方面對溫度模擬系統進行了改進設計，並在改進的系統平臺上進行了試驗，試驗結果表明改進后的系統能基本滿足對發動機渦輪出口溫度信號模擬需求。 -
After the modification, the characteristic of outlet water of the spray nozzle is changed and the outlet temperature of the cooling water from the spray nozzle is decreased. as a result, the coal consumption is reduced and the efficiency of the steam turbine is better
通過對噴濺裝置的改造，改變了噴頭的出水特性，從而降低了冷卻水出水溫度，提高了汽輪機真空和汽輪機熱效率，降低了煤耗，提高了機組運行的經濟性。 -
Experimental study on outlet temperature distribution in plate - fin heat exchangers under secondary header configuration
二次封頭結構板翅式換熱器出口溫度分佈的實驗研究 -
The computer programme worked out this way has been applied in the measurement of gas temperature at the outlet of a certain high heat - tolerance combustor, obtaining the outlet temperature field
根據此方法編制的計算機程序已應用於某高熱容燃燒室出口燃氣溫度測量中，獲得了燃燒室出口溫度場。 -
In the water inlet rate control, a pid - fuzzy two - mode controller is used. in the outlet temperature control, this paper proposes to use takagi - sigeno type fuzzy system to construct controller for plants with time delay
在出口水溫控制中，本文提出了比例-模糊雙模控制，其中模糊控制器是基於takagi - sigeno模糊推理系統構建，用以解決系統存在的滯后問題。
分享友人