particle structure 中文意思是什麼
particle structure
解釋
粉粒構造-
Thus the alpha particle is an exceptionally stable nuclear structure.
由此可見，粒子是一種特別穩定的核結構。 -
Examination questions ' storehouses, which is about manipulative skills of customtailoring workers in apparel design, whose quality standard must be united, whose applied ability principles must best strengthened, and whose content and structure must be checked in designing appraise details of essential elements measure module ( appraisable particle ) check examination questions ( check item ), and take form united 、 norm 、 optional and open - ended the examination questions ' storehouse so that appraised and checked qualith of the manipulative skills can be guaranteed
摘要服裝設計定製工操作技能試題庫必須堅持統一質量水平、強化適用能力的原則，通過設計考核內容結構鑒定要素細目測量模塊（鑒定點）考核試題（考核項目） ，形成統一、規? 、可選、可擴充的服裝設計定製工操作技能試題庫，以保證服裝設計定製工操作技能鑒定考核的質量。 -
Zn power, se power and diethylamine was used as the sources in this method and nanocrystal znse powders were synthesized at 225. these powders have been identified as polycrystal znse with zinc blende structure by xrd. the size of particle is about 100nm ~ 200nm
採用zn粉和se粉為原料，以二乙胺為溶劑，在225下得到了znse粉末， xrd結果顯示其為znse多晶粉末，從tem照片可看出其顆粒的尺寸約為100nm 200nm 。 -
The structures and characteristics of several graphite samples are measured by means of powder x - ray diffraction ( xrd ), brunauer - emmer - teller ( bet ) surface area measurement, inductively coupled plasma ( icp ) spectroscopy, particle size analysis and electrochemical measurements. the effects of origin, structure, impurity, particle size, specific surface area of carbon materials on the electrochemical characteristics are studied. a synthetic graphite with abundant resources, low cost and favorable performance is determined as the raw material for modification of graphite
採用xrd 、 bet 、 icp 、激光粒徑分析及電化學性能測試等方法，對國內外多種典型石墨樣品的結構與性能進行比較，研究石墨材料的來源、晶體結構、雜質含量、顆粒大小、比表面積等因素對其充放電性能的影響，確定一種性能較好、價格低廉、來源廣泛的普通人造石墨粉作為熱處理與摻雜改性、以及復合結構炭材料研究的原材料。 -
The results showed that the acr emulsoid particle size and its distribution can be adjusted by varying the amount of seed emulsion used in the pre - emulsionized seed - emulsion polymerization, and the acr emulsoid particles have core - shell structure obviously
結果表明，採用預乳化種子乳液聚合法制備acr乳液，可以有效地控制乳膠粒徑及分佈；且所合成的acr乳膠粒子具有明顯的核殼結構。 -
The emulsoid particle size and its distribution were determined by laser particle sizer. the composition changes of acr were inspected by ir, and the core - shell structure was observed by tem. the morphologyes of acr resin particles were inspected by polarization microscope at last
通過激光粒度分析儀對所合成的乳膠粒徑及其分佈進行了分析測試，藉助于ir考察了所合成的acr的組成變化，並通過透射電鏡對所合成的acr的核殼結構進行了驗證，最後藉助于偏光顯微鏡觀察了破乳乾燥后得到的acr粒子。 -
The linear relationship between shock wave velocity d and particle velocity u of our samples were obtained : d = 3. 701 + 1. 527u there the unit of relocity is km / s. no phase transition shows for enstatite with perovskite structure according to the experimental linear d - u line up to 110gpa
實驗結果表明，在80 115gpa壓力范圍內本文所用頑火輝石的沖擊波速度d與粒子速度u可用線性關系： d = 3 . 247 + 1 . 626u來描述。 -
The difference of reactive mechanisminduced the difference of their structure. v _ 2o _ 5 product prepared by melting - cooling showed more notable undefined structure. after heat - treating under300, particle size becomes smaller, and aggregate to globate grain, showesbetter electrochemical performance at low charge - discharge rate
熔融淬冷法合成的樣品其無定型結構更明顯，前驅體經過300熱處理后，材料的粒徑變細，團聚成球狀的顆粒，球狀特徵更顯著，在低倍率下具有較好的電化學性能。 -
Fe3o4 nano - particles, which can be dispersed in nano scale, were prepared by means of chemical co - precipitation method. such influencing factors as the type of precipitant, the feeding mode, the surfactants, the reaction temperature, the curing temperature were surveyed. some properties such as crystal structure, particle size, magnetic properties and iron content were characterized
深入探討了沉澱劑的種類、加入方式、表面活性劑、反應溫度、熟化溫度等各種因素對產物的粒徑及磁性能的影響，對fe _ 3o _ 4納米粒子進行了晶體結構、粒徑、磁性能、鐵含量等性能的表徵。 -
Using the particle - in - cell ( pic ) model, a 8 millimeter relativistic backward wave oscillator underlying superradiance mechanism was gotten, the influence on both operation frequency and radiation efficiency of the guiding magnetic field, the diode voltage, the beam current and the beam radius as well as the corrugation structure were also presented
採用pic方法，通過數值模擬優化設計了超輻射狀態下的8毫米相對論返波振蕩器，分析了引導磁場、二極體電壓、電子束流、電子束半徑、周期慢波結構等對器件的輻射功率及輻射效率的影響。 -
The influences of structure variables such as impeller types, baffle configurations, gas sparger, and operational variables such as gas rate, particle fraction on critical suspension speed of floating particle in an agitated vessel were investigated
摘要探討了攪拌槳型、擋板和氣體分佈器等結構因素及氣體流量、顆粒質量分數等工藝因素對下沉顆粒三相體系臨界攪拌轉速的影響。 -
Traditionally it is considered that particles are formed into the single - chain structure, while the body - centered tetragonal ( bct ) structure comes into being when the particle volume is a little high. and the other structure models such as the layer model, the fiber model, the column model and so on
粒子發生聚集所形成的結構傳統的認為是單鏈模型，而當粒子的體積濃度比較大時，一般認為是體心四方結構（即bct模型） ，此外還有諸如層結構模型、纖維結構模型、圓柱結構模型等等。 -
" for the discovery of the connection between collective motion and particle motion in atomic nuclei and the development of the theory of the structure of the atomic nucleus based on this connection
發現原子核中集體運動和粒子運動之間的聯系，並且根據這種聯系提出核結構理論與 -
The lath martensite nanometer structure can play the role of fine - particle strengthening and dislocation strengthening as well as coordinate the distribution of dislocation. it is hopeful that the strength and toughness of material with this structure can be increased at the same time
板條馬氏體組織納米化結構，可起到納米晶粒的細晶強化與位錯強化的聯合作用，並可協調位錯分佈，有望使具有這種組織的材料強度和韌性同時得以提高。 -
The model shows that : 1 ) structure of the stabilized soil from silt is formed by hydrates, which are generated by hardening agent hydration, wrapping and cementing soil particles and filling pores among the particles ; 2 ) structure of the stabilized soil formed from clayey soil is formed by the hydrates wrapping and cementing clay particle groups, filling pores among the groups, and squeezing and filling pores in the groups
該模型認為：粉土固化土結構是由固化劑水化物充分包裹膠結土顆粒和填充土顆粒間孔隙而構成；黏性土固化土結構是通過固化劑水化物包裹膠結土團粒、填充土團粒間孔隙、擠壓填充土團粒內孔隙而構成。 -
As predicted theoretically, the ps polymer spreaded over the surface of the titania particles to form composite particles with core - shell structure. the influence of ph value and non - ion surfactant in heterocoagulation was discussed. the property of the coated particles was characterized by sem, and zeta potential, particle size distribution of the particles before and after encapsulation was obtained by laser particle size analyzer
根據機械力化學的原理，採用自行制備的微米級ps和pmma （聚甲基丙稀酸甲酯）高聚物微球、金屬粒子、納米級的tio _ 2 、爐料為原料粒子，通過採用自行研製的乾式沖擊設備和lg攪拌磨製得以高聚物微球、金屬粒子為核，納米tio _ 2 、碳黑粒子等為包覆粒子的具有不同特殊功能的納米微米復合粒子。 -
The key items influent on the characteristics of spraying have been also studied in the dissertation, we can get a good spraying result by adjusting the related parameters efficiently. ( 3 ) the theoretical model of the dynamical parameters such as temperature, moisture, pressure and contour for hot medium and particle inside the drying chamber were obtained by model, utilized the computational fluid dynamics technique to solve the problem between spraying droplets medium by arranging the double grid dispersing structure and rotary outlet structure and the developed structure improved the drying efficiency and product quality
（ 3 ）採用-模型實現了壓力噴霧乾燥塔的溫度場、濕度場、流場的理論建模，利用計算流體力學（ cfd ）技術來解決噴霧乾燥過程中熱介質與霧滴間的傳熱傳質以及動量傳遞和湍流擾動等問題，避免了乾燥過程中的設計不合理狀況；通過增加雙格柵均風裝置和旋轉出風裝置，改善了乾燥塔內的熱質傳遞，提高了乾燥塔的體積蒸發強度。 -
One particle structure
單粒子結構 -
The recent research advances in the synthesis of styrene - butadiene latex for paper coating, including monomer composition, particle structure, balance of surface strength and blister resistance, coating with good fluidity at high speed, latex stability, additive and material addition sequence were reviewed with 15 references
摘要介紹了近年來國外塗布紙用丁苯膠乳在單體組成、粒子結構、塗布紙表面強度與抗起泡性的平衡性、塗料高剪切流動性、膠乳德定性、添加劑和加料順序等方面的研究進展。 -
Study on relationship of particle structure and photocatalytic properties of nano - tio2 powder
2粉末以及顆粒相結構與光催化性能關系的研究
分享友人