passing beam 中文意思是什麼
passing beam
解釋
近光光束-
Detailed numerical results for a pgsm beam passing through a bifocal lens are presented. it implies that the degree of polarization is no longer uniformly polarized in general and propagation - induced polarization changes depend on the beam parameters and system parameters, such as beam coherence parameter
通過對雙軸透鏡系統進行的數值計算表明， pgsm光束光場的偏振不再是均勻偏振，光束的偏振特性與光束參數和光學系統參數有關，不同相關狀態下場點的偏振度不同。 -
The multi - pass amplifier was being adopted proverbially, which could improve the output energy consumedly. but on the other hand the beam quality was degraded by the severe wave - front ' s aberration that exacerbated by multi - passing the beam through the amplifier
多程放大系統因能夠較大提高系統的輸出能力，故得到較為廣泛的應用；但由於多程放大級各類波前誤差的相干疊加，使系統輸出激光的波前發生比較嚴重的畸變，導致光束質量的下降。 -
Quantum tunnelling time of cold atom passing through a laser beam
冷原子穿越激光束的量子隧穿時間 -
4, single focuse the single head : is single for single laser head that panasonic lead off to adopt to focuse the double the laser beam for focusing ordering the project, he adopting the special whole synthesizing lens, passing lens in the center part ofly the focusing of formation cd the point, and pass the anastigmatic laser beam of part edge the formation the focusing of dvd the point, this kind of construction because of have no the machining to spread to move, and also can t produce the mechanical trouble, therefore increased to recognize the dish the speed, and however and also lowered the cost. but adoption this project of generation is with part of the next generation dvd nonsupports cdr
4單聚焦單鏡頭：為panasonic率先採用的單激光頭單聚焦鏡雙聚焦點方案，他採用特別的全息綜合透鏡，通過透鏡中間部分的激光束形成cd的聚焦點，通過透鏡邊緣部分的激光束形成dvd的聚焦點，這種結構由於沒有機械傳動，也不會產生機械故障，所以提高了認盤速度，不過同時也降低了成本。但採用此方案的第一代和部分第二代dvd不支持cdr 。 -
Based on the generalized huygens - fresnel diffraction integral and in consideration of the effect introduced by astigmatism, the transformation properties of gaussian beams passing an astigmatic lens are studied analytically, the beam quality of astigmatic gaussian beams is analyzed in terms of the beam propagation factor ( m2 - factor ) and power in the bucket ( pib ), and illustrated with numerical examples
基於廣義惠更斯-菲涅爾衍射積分，並考慮了像散的影響，對高斯光束通過像散透鏡后的傳輸特性作了解析研究，以光束傳輸因子和桶中功率為參數分析了像散高斯光束的光束質量，並以數值計算例加以說明。 -
( 2 ) from the equilibrium conditions of the isolated segment from a beam - column sub - assemblage, it is clarified for the first time that the bond stress along the beam rebars passing through the joint transfers into the column end to balance shear at this column end at the same ratio as that of the compression force in the compressed concrete at beam ends
通過對樑柱組合體柱脫離體的平衡條件，首次明確了貫穿節點梁筋粘結應力和梁端受壓混凝土的壓力以相同的比例傳入柱端以平衡柱端剪力，從而對節點區的傳力機理重慶大學博士學位論文結出了完整的和具有說服力的解釋。 -
( 2 ) based on the propagation equation of fgbs passing through unapertured paraxial abcd optical systems, the similar transformation conditions are obtained for the first time, which is expressed as that two fgbs with the same beam order have similar intensity distributions at the two positions of equal generalized fresnel number when they propagate through two ajb, cjdi ( i = l, 2 ) systems. furthermore, a comparison between a fob and a sgb of the same beam a ^ - factor but different waist widths is performed for the first time
（ 2 ）通過對作為整體的平頂高斯光束在無光闌限制近軸abcd光學系統中傳輸公式的分析，首次得到了平頂高斯光束的相似變換條件，即階數相同的平頂高斯光束在傳輸矩陣為a _ ib _ ic _ id _ i （ i = 1 ， 2 ）的兩個光學系統中傳輸時，在菲涅爾數相等的兩個面上具有相似的光強分佈。 -
This dissertation is mainly about the transit radiation of the electron beam passing through the gap with the random standing wave electric field. in order to satisfy the requirement of the task, the feasibility of generation of more than 1 gw high power microwave in x - band using the transit radiation oscillator based on the transit effect is studied
研究了二維柱坐標系網格劃分演算法，並用此演算法對五腔開放腔進行網格劃分，採用時域有限差分與快速傅里葉變換相結合的方法計算了五腔開放腔/ 6 、 2 / 6 、 3 / 6 、 4 / 6 、 5 / 6模這五個模式的頻率和場分佈。 -
Based on behavior of joint core under cyclic reversal load, according to actual measurement load - displacement hysteresis loops, slip of longitudinal reinforcement passing through joint and shear deformation of joint in a serial of beam - column subassemblage tests, the typical slip hysteresis model of longitudinal reinforcement passing through joint and typical shear deformation hysteresis model of joint are proposed in this paper
本文以節點的受力特性及規律為基礎，基於若干樑柱組合體低周交變加載試驗的實測節點恢復力滯回曲線以及從中分離出來的貫穿節點的梁筋滑移變形結果、節點剪切變形結果，分析總結得到有一定代表性的梁端剪力與貫穿節點梁筋滑移之間和梁端剪力與節點剪切變形之間的滯回關系模型。 -
The article analyzes mainly the relation between pressure distribution of neutralizer and efficiency of neutralize describing neutralized rate of high - energy ion beam in the process of passing neutralizer. then, we accurately analyze pressure distribution in the axis direction of axis of nbi system, especially of pressure distribution curve of neutralizer
主要分析了高能離子束通過中性化室的中性化效率與中性化室內壓強的關系，給出了nbi系統從離子源引出端到托卡馬克裝置入口處的軸線上壓強分佈情況，尤其是中性化室內的壓強分佈曲線。 -
Considering the joint core deformation effect, the existing cantilever program was assembled with the slip deformation model of longitudinal reinforcement passing through joint and the shear deformation model of joint to obtain the program for simulation of hysteretic characteristics of beam - column subassemblage
本文考慮節點區變形的影響，為原有程序組裝了節點區貫穿節點梁筋的滑移變形模型和節點剪切變形模型，得到樑柱組合體在低周交變加載下的梁端荷載-位移滯回規律模擬程序。 -
The fundamental principle of this system is as follows. divide the incident beam into two beams, one of which passing through variable optical delay ( vod ), then combination of the two beams with the same amplitude and delay - superposition is sent to bi - photon detector and transformed into current signals, whose intensity is proportional to the intensity of bi - photon autocorrelation signals
本系統的主要原理是:把入射光分為兩束，讓其中一束光通過一個可調光纖延遲線，再把這兩束具有相同幅度並延時重合的光合路後送進雙光子探測器，該探測器同時吸收兩個光子發生雙光子效應從而產生電流信號，且其大小與雙光子自相關信號的強度成正比。 -
Starting from the propagation law of partially coherent light and using a typical partially coherent light, i. e., gaussian schell - model ( gsm ) beam describing the multimode laser in practice, i present in this dissertation the research results on vectorial partially coherent light, spectral changes of partially coherent light passing through optical element, spectral switch of partially coherent light diffracted by an aperture, and the spectral anomaly of diffracted fully spatially coherent light by an aperture
本文從部分相干光的傳輸理論出發，以模擬實際多模激光的一類典型部分相干光? ?高斯-謝爾模型（ gsm ）光束為主要研究對象，對矢量部分相干光、部分相干光通過光學元件的光譜變化、被光闌衍射的部分空間相干光的光譜開關和被光闌衍射的完全空間相干光的光譜異常等現象進行了深入研究。 -
Behavior of the confinement mechamsm is also different. before obvious bond deterioration of the beam rebars passing through the joint core occurs, the shear is mainly transfered by the truss mechansim. when the bond deterioration occurs comprehensively, the shear transfered by the truss mechamism is reduced significantly, the majority of the shear is transfered by the diagonal strut
當貫穿節點的梁筋未出現明顯的粘結退化之前，節點作用剪力主要通過街架機構傳遞，斜壓桿機構傳遞的剪力和約束機構發揮的作用較小；當梁筋全面出現粘結退化以後，行架機構傳遞的剪力明顯降低，作用剪力主要由斜壓桿機構傳遞。 -
Second, we have proposed a reflective and coaxial configuration, in which the ultrasound beam and the incident laser are kept in the same axis direction. then a 1mhz ultrasound beam is focused into the simulating media to modulate and tag the scattering laser light passing through the ultrasonic focused zone
並且在綜合國內外各小組的實驗技術的優點的基礎上，創造性地提出聲光同軸反射式方案，即超聲和入射光同軸，並和探測器在同一方向上。 -
Three factors, that beam reinforcement relative diameter, concrete intensity, axial compression ratio are considered in the model of slip of longitudinal reinforcement passing through joint, and the correlation between shear deformation and cycle number are simulated four factors that concrete intensity, axial compression ratio, shear compression ratio, hoop reinforcement characteristic number are considered in the model of joint shear deformation, and the correlation between joint shear deformation and cycle number are also simulated
貫穿節點梁筋的滑移模型考慮了貫穿梁筋的相對直徑、混凝土強度及軸壓比三個因素，並根據試驗結果模擬出滑移量隨循環次數的變化規律。節點剪切變形模型考慮了混凝土強度、軸壓比、剪壓比、節點配箍特徵值四個因素，並根據試驗結果模擬出節點剪切變形量隨循環次數的變化規律。 -
Beam bridges have being developed rapidly, are often built by segmental construction with the final bridge structure formation passing through many constructional segments ( system transferring )
梁橋的施工多採用分節段施工方法，橋梁結構的最終形成需要經歷多個施工階段，其中包括結構體系的轉換。
分享友人