phase delay time 中文意思是什麼
phase delay time
解釋
相位延遲時間-
This article discussed ar modeling method, capon method, music method and mn method four kinds of high resolution algorithms principle and has separately made the computer simulation in the ideal situation to the above four algorithms. through the comparison, the beam width of high resolution algorithm is much narrower than conventional beamforming method. then unifies the actual utilization, discussed the influence of time delay unbalance, time domain sampling, plane wave supposition and array element with scope and phase not identically to the beamforming and made the computer simulation
本文首先討論了ar模型法、 capon法、 music法和mn法四種高解析度演算法的原理，在理想的情況下分別對上述四種演算法作了計算機模擬，通過比較，高解析度演算法的束寬比常規波束形成法窄得多;然後結合實際運用時的情況，重點探討了延時失配、時域抽樣、平面波假設和基陣的幅相不一致對波束形成的影響並做了計算機模擬。 -
A simple, robust method is proposed that relies on high - resolution measurements and on - line analysis of network traffic to provide real - time alarms in the incipient phase of network anomalies. the anomaly identification algorithms based on behavior model using path changes, flow shift and packet delay variance
通過高性能測量和在線分析網路流和路由信息對初始網路異常產生實時報警，提出基於路由變化、流變化和包延遲建立網路行為模型的網路異常檢測演算法。 -
For phase space reconstruction of ship - radiated noise, using auto correlation function and mutual information to select the delay - time, and using false nearest neighbors method to select the embedding dimension
從自相關函數及互信息嫡兩個方面討論了相空間重構中延遲時間的選擇。 -
To increase the bearing accuracy of amplitude - comparison, the multi - channel system was chosen, the angle of reaching of moving antenna pattern serial was estimated from the frequency domain using the phase - delay estimating method, and at the same time, the selection of antenna, quantization of signal and touch switches were optimized in concrete engineering practice, and so the requirement of the index was satisfied
為提高比幅測向的精度，選用多通道體制，採取相位延時估計法從頻域來估算移動天線方向圖系列的達到角，同時在具體的工程實現上對天線選取、信號的量化、去摸開關等進行優化，從而滿足指標要求。 -
On the one hand, we deduce the off - diagonal term of reduced density matrix is inner - product of two coherent states and we carry out decoherence in macroscopic limits in two special case, on the other hand, we delay decoherent time by controlling the interaction coefficient. in other part, we define two kind independent phase operators by improving two - mode squeezing coherent states in two - mode phase space and resolve their eigenstates
在第二部分中，我們在雙模相位空間里利用雙模壓縮相干態所對應的算符定義二類獨立的相位算符並相應求出本徵態，而它的產生算符和湮滅算符是通過簡諧振子的產生算符和湮滅算符經過正則變換得到的。 -
With compensation of signal ’ s time delay from different radiating element by phase shifters, phased - array antenna can control array beam easily. because there are no mechanical devices for rotating beam, the phased - array antenna system can scan everywhere in beam covered areas in millisecand by stepping the phase shifters. it improves the tracking velocity of antenna towards the object, and becomes the development trends of weapon system antennas
相控陣天線利用移相器補償信號到達輻射單元時間的差異，從而控制波束方向;天線沒有機械旋轉問題，只需改變移相器的設定值，波束便可以在毫秒級內掃描其覆蓋空域內的任何地方，提高了天線對目標的跟蹤速度，是目前武器系統天線的發展方向。 -
Calculations indicate that the carrier phase takes effect till the time width of the pulse envelope becomes smaller than the period of the carrier oscillation, and the interpretation of this phenomenon is also presented. it is the difference between phase delay and group delay that causes the sliding between the carrier and the envelope
數值分析的結果表明，當脈寬小於光波周期時，相位的作用開始顯現出來，當脈寬比光波周期長時，載波相位的作用可以忽略，並分析了相位起作用的原因，用解析的方法說明正是相延遲和群延遲之間的差別造成了光載波在脈沖包絡下的滑動。 -
As ttd ( true time delay ) is utilized in optically controlled phased array at sub - array level to replace the phase shifter in general phased array radar system, and make time delay compensation at sub - array level, which can reduce aperture effect considerably and make the broadband and wide - angle scanning of phased array antennas come true
由於光控相控陣雷達在子陣級上引入實時延時線ttd （ truetimedelay ）取代常規相控陣雷達中的移相器進行子陣級的延時補償，大大減輕了孔徑效應，使相控陣雷達實現了寬帶寬角掃描。 -
There are two uncertain factor about it : the phase of the pn code and the doppler - shift. after capturing the received signal successfully, the traditional ds receiver always uses a delay locked loop ( dll ) to synchronize the pn code and then uses a costas loop to realize the carrier synchronization. this complex closed - loop structure not only take long time to realize the synchronization, but also has the defect of “ hang up ”
傳統的擴頻接收機通常在捕獲偽碼信號后利用遲早門鑒相的延時鎖定環來實現偽碼的精同步，解擴后利用科斯塔斯環實現載波同步，這種閉環結構不僅同步時間長、結構復雜，而且鎖相環還存在所謂的「 hang - up 」現象。 -
A perturbation method by tight - binding approximation which provide the relation of phase constant and angular spectrum of fields of in - waveguide is presented. the strip width of phase constant can be given. on the other hand, the group delay - time due to the k dispersion in single - mode transmission can also be estimated
提出一種利用緊束縛近似的微擾法計算陣列波導的相位常數與輸入光角譜的關系，由此算出相位常數的帶寬，並利用衍射方法估算單模傳輸中k色散引起的群延時。 -
The reasons focusing only on ray travel times are " noise tolerance could be enhanced and the sensitivity to the environment model mismatch may be reduced by neglecting amplitude information ; phase ambiguity is eliminated by employing the group delay of arriving wave packets ; travel times are pseudo - linear functions of sound speed profiles of the medium, and the perturbation of ray travel time is much smaller than sound pressure ' s
之所以選擇聲傳播時間的原因是：噪聲容限可以得到提高，並且傳播時間的計算可以不考慮聲壓的信息，從而降低了對環境模型失配的敏感性；相位的起伏也可通過到達包絡的群延時來消除；傳播時間是介質聲速分佈的偽線性函數並且傳播時間的起伏遠小於聲壓的起伏。 -
Firstly, the differences between the ultra - wideband antenna and conventional wideband antenna are introduced in this thesis, and the definitions of several performance parameters of the ultra - wideband antenna are presented, among which the phase center and the group delay time are primarily discussed in that they describe the time domain properties of the antenna
首先，簡要介紹了超寬帶天線與傳統超寬帶天線的區別，給出了超寬帶天線的性能參數在時域的描述方法。著重介紹了描述超寬帶天線時域特性的兩個參數，即相位中心和群延時。 -
In measuring distance, two common methods : pulse - counting and phase - shifting are compared and analyzed. we analyze and compare analog intervene method and time delay method according to their measuring precision and the measuring blind area to improve the measuring precision
對脈沖計數法中的兩種提高測量精度的插入法:模擬插入法和延遲線插入法的精度和測量盲區兩個方面作了分析和比較。 -
The main methods of this thesis are as following : chaotic time series is created by dynamics equation, then use gp algorithm to calculate embedding dimension and mutual information algorithm to calculate delay time. based on takens embedding theorem, the method utilizes the observed values of single variable of chaotic system to reconstruct phase space
論文首先求解動力學方程組產生混沌時間序列，然後用gp演算法確定嵌入維數、互信息法求出延遲時間，再根據takens嵌入定理，利用混沌系統的單變量觀測值對混沌背景重構相空間。 -
Determination for the delay time of phase space reconstruction
相空間重構延遲時間的確定 -
Selection of embedding dimension and delay time in phase space reconstruction
相空間重構中嵌入維和時間延遲的選擇 -
Djw - wb 、 sjw - wb series single and three phase & large - power auto compensated voltage regulator, incorporating advanced technology of group winding compensation and mon - contact suitch and micro - computer controling ac regulation, with functions of high effeciancy quick regulating ou - to - balance of three phases no mechanical no mechanical broken down and wear of carbon brush and time delay over and low load warning and protection
集先進的組合繞組補償方式和無觸點開關、微機控制交流穩壓技術於一體，具有高效節能、調節快速、三相自動平衡、無機械故障和碳刷磨損，並具有延時，過、欠壓報警和保護等功能。 -
Fourthly, respectively using cross correlation method for estimation of time delay, phase spectrum method for estimation of time delay and high order spectrum method for estimation of time delay, this paper measures time delay estimation of the data obtained because time delay between two signals has big importance on the testing result. through comparing three results, accurate time delay is obtained under their own different circumstances
再次，由於兩信號的時間延遲對測量結果有很大的影響，因而研究了用互相關時間延遲估計、相位譜時間延遲估計和高階譜時間延遲估計的方法對測量數據進行了時間延遲估計，結果表明，三種時間延遲估計方法在各自適應的環境下使用，都能得到比較準確的時間延遲估計值。 -
These include two keys problem in phase space reconstruction theory, that is embedding dimension and optimal delay time, and numeric recognition of chaos, that is lyapunov exponent, as well as numeric recognition of fractal, that is correlative dimension of chaotic attractors
其中重點講述了非線性動力學的數值研究實驗方法：相空間重構的兩個關鍵問題，即嵌入維數和最佳延遲時間；混沌的數值識別，即李雅普諾夫指數；分形的數值識別，即吸引子的關聯維數。 -
In this paper one kind of fractal dimension - correlative dimension is discussed thoroughly. and the parameters ( include the delay time and the embedding dimension ) that affect the reconstruction of phase space and the result of the correlative dimension are discussed thoroughly. in this paper the c - c method is selected to determine the delay time and the embedding dimension
本論文深入探討了分形維數的一種? ?關聯維數在機械故障診斷中的應用，探討了相空間重構和關聯維數求解過程中嵌入維數和延遲時間的選擇的意義及方法，本論文選用c ? c方法，並編制了相應的程序來確定嵌入維數和延遲時間。
分享友人