photoelectric signal processing 中文意思是什麼

photoelectric signal processing 解釋
光電信號處理
  • photoelectric : adj. 【物理學】光電的。
  • signal : n 1 信號，暗號；信號器。2 動機，導火線 （for）。3 預兆，徵象。adj 1 暗號的，作信號用的。2 顯著的...
  1. With the increasing requirements for detecting distance, photoelectric module, including light source and modulation, can be put under water to reduce the loss of light power in the optical fiber transmission and transmit the detected signal to the signal processing workstation on the shore. optical transceivers must be applied to realize the low - rate optical communication between the workstation on the shore and the long - distance photoelectric modules under water

    隨著光纖水聽器陣列技術的發展，可將光源與調制部分作為遠程光電模塊置於水下，減少光纖傳輸過程中光波信號的損耗，而直接將光纖的探測信號傳回岸基工作站進行處理，以增加光纖水聽器的探測距離。
  2. The important part in photoelectric transform circuits is design of driving circuits and signal processing circuits about linear ccd. the time order driving circuit of ccd are designed and debugged with cpld ( complicated programmable logic device ), which make the whole driving circuit ' s volume very small, shorten design period, modify design at any time, and enhance reliability and agility of circuit

    在設計過程中，採用了一種復雜可編程邏輯器件（ cpld ）設計線陣ccd驅動脈沖電路的新方法，只對器件進行重新編程，在不改變任何硬體的情況下，就可以實現驅動器的更新換代，非常適合線陣ccd脈沖產生電路的設計研究，具有高集成度、高可靠性、開發時間短、投資少等優點。
  3. The technique core of the 3 - d outline tracking scan lies in the adoption of several photoelectric sensors, laser measuring sensors and super voice wave measuring sensors to carry on probing, the single chip makes the photoelectric signal examined as the control basis, and controls the step motor to drive measurement machines and probing sensors to make outline tracking and scans movement along high and breadth direction of the vehicle, and record its outline track, and the data measured is delivered to the computer, finally, acquires the size of the vehicle checked through the place of computer data processing

    三維輪廓跟蹤掃描技術的核心在於採用多套光電傳感器、激光測距傳感器、超聲波測距傳感器進行探測，單片機把檢測到的光電信號作為控制依據，控制步進電機驅動測量機及探測傳感器在車長、車高和車寬方向上作輪廓跟蹤掃描進給運動，記錄其輪廓軌跡，並把測得的數據傳送到上位機，經上位機數據處理獲得被檢車輛的特徵尺寸。
  4. The conventional quadrants sensors mainly have 4 or 8 quadrants, which are not integrated with the signal processing circuits in one chip but are soldered with the discrete signal processing circuits. in this way, it ' s difficult to realize the micromation and system optimization of the devices. in addition, there are few number of photoelectric sensor parts in conventional quadrants sensors, which limits the targets information got from the conventional quadrants sensors

    傳統的硅象限傳感器主要採用四象限，八象限的結構，採用焊接的方式將分別製造的感光象限和電路結合在一起，不能實現感光象限與信號處理電路的單晶元集成，難以實現器件的微型化和系統優化；同時，傳統象限傳感器的感光象限單元數量較少，獲取的目標信息有限，難以實現對目標的坐標位置獲取、形狀識別等功能。
  5. In the course of experiment, we design and set up a microlens test system, which includes several main parts, such as photoelectric detection, signal enlarging, data gathering and analyzing and image processing, etc

    實驗過程中，設計並搭建了一套完整的微透鏡測試系統，包括光電探測、信號放大、數據採集和分析以及圖像處理等幾個主要部分。
  6. The active pixel sensor structure widely used in image sensor is used here to convert the micro photoelectric signal generated in pixel to large electric signal to facilitate the signal processing and reduce the noise. the arrayed sensor structure ? s used to obtain the coordinate and shape information of targets

    該傳感器的感光單元採用了cmos圖象傳感器中使用的有源像素傳感器（ activepixelsensor ， aps ）設計，在感光單元內部由光電信號預處理電路直接將傳感產生的光電信號轉化為幅度較大的電信號輸出，避免了對微弱信號的處理，降低了噪聲的影響。
  7. The experiment of ccd driving and signal processing circuit shows that the drivers can assort with ccd well, take advantage of the characteristic of ccd photoelectric transition and output steady and reliable electric signal

    對ccd驅動及視頻處理電路進行了試驗，結果表明驅動電路能很好地與ccd配合，充分發揮ccd光電轉換特性，輸出穩定可靠的電信號。
分享友人
分享到 Line

分享到臉書