positive shear 中文意思是什麼

positive shear 解釋
正剪力
  • positive : adj 1 確實的,明確的;確定的;無條件的 (opp qualified implied inferential); 絕對的,無疑問的,...
  • shear : vt vi (sheared 〈古語〉 shore; shorn sheared)1 剪(羊毛等);修剪(樹木);剪(呢絨的)長毛。2 ...
  1. The derived dry bulk modulus must be positive and greater than 2 / 3 of shear modulus to insure a positive lame constant and poisson ' s ratio

    提取的乾燥體變模量必須為正,並且大於剪切模量的2 / 3 ,以保證拉梅常數和泊松比為正。
  2. Abstract : it presents the law of “ the reverse is positive ” on how to evaluate the unknown force of statically determinate structure, the movement law of force vector for drawing the axial force diagram and shear diagram. and expounds the simple and convenient method of drawing the moment diagram according to the rubber band deformation, and the auxiliary teaching software corresponding to the above - mentioned methods. the methods are believed to save class hour and gain a better effect on teaching

    文摘:闡述了求靜定結構未知力的反為正規律;繪制軸力圖、剪力圖的力矢移動法則;按照橡皮筋變形繪彎矩圖的簡便作法以及與上述方法對應的計算機輔助教學軟體.相信這樣作,對教學可起到省課時、效果好的作用
  3. Discussion on the positive direction of shear stress in material mechanics

    材料力學應力分析中剪應力正向的探討
  4. In this paper, based on the analysis of the rlem of theory foundation, computing method, preference, applicability, etc, we anatomized the rlem of three self - deficiencies and six scarcities. moreover, we adopted the parallel ways of contrasting the rlem with the fem and applied it to analyzing the impact of slide block of elasticity and plasticity, slip surface of coefficient and slip bed of elasticity, plasticity upon the stability of slope and in the plain linearity slope, the plain refracted line slope and the plain arc slope. in addition, we discussed the warp of between the lem of ( sarma, janbu, order, bishop, morgenstera - price, etc ) and the fem of result and the distributing of positive stress and shear stress on the slip surface

    本文從剖析剛體極限平衡法的理論基礎、計算方法、參數選取、適用條件等方面入手,剖析了剛體極限平衡方法的3點自身缺陷和6點不足,並在此基礎上採用了剛體極限平衡法(平面滑動破壞法、 sarma法、傳遞系數法、普遍條分法、 janbu法、 bishop法、 morgenstern - price法)與大型有限元法對比研究的方法,分析研究了平面直線型滑坡、平面折線型滑坡、平面圓弧型滑坡在漸進破壞中邊坡的滑體彈塑性參數、滑麵塑性參數) 、滑床的彈塑性、以及極限平衡法無法考慮開挖應力釋放等因素對邊坡穩定性的影響與滑動面上的正應力、剪應力分佈規律、安全系數的解答的差異。
  5. The typical samples with different lithological characters are collected from two wells of representative reservoir consisting of sandstone and conglomerate of positive rhythm. compressional and shear wave velocities, porosity, and clay content are measured in two states fully saturated with water

    在復雜的正旋迴砂礫巖儲層中,從兩口井系統地採集了不同巖性的典型樣品,在不同的有效壓力及兩種狀態氣飽和和水飽和下測試了巖石的縱橫波速度。
  6. To guarantee the stability of the frame in strong earthquake motion, and on the basis of analysis on the concept of “ capacity design ” in the above three countries seismic design provisions, it is advised that the moment amplification coefficients at the bottom sections of columns for the frame structures in some seismic intensity be increased to reduce the possibility of the frame column yielding. taking the above three countries seismic codes as reference, it is recommended that it be added details of seismic design by using diagonal shear reinforcement to safeguard beams against sliding shear failure, when the positive - negative shear forces are reverse and the ratio is high

    為了保證在大震作用下框架結構的穩定性,借鑒國外規范「柱-梁承載力級差系數」的思想,本文提出了對部分抗震等級的框架結構的柱端抗彎能力增強系數應予以提高,以降低框架柱屈服的可能性;參照國外有關規范的發展,本文建議對于正、負剪力反向且比值較大的框架梁宜增加交叉斜筋,以防止沿垂直裂縫發生嚴重的剪切錯動。
  7. The combination of positive displacement rotor and idle wheel of wgb pump had better function and can realized the transportation of liquid with low shear change and no pulse

    Wgb泵的正排量轉子和惰輪組合體工作中有較好的緩沖作用,能達到低切變,無脈沖的流體輸送。
分享友人