power induction 中文意思是什麼

power induction 解釋
電力線感應
  • power : n 1 力，力量；能力；體力，精力；（生理）機能；〈常 pl 〉才能。2 勢力，權力，權限；威力；政權；權...
  • induction : n 1 引入，誘發，誘導（作用）。2 【邏輯學】歸納法，歸納推理 （opp deduction）。3 就職，就職典禮；...
  1. The wires and detectors are liable to induction from the power lines.

    導線和檢波器易受高壓線感應。
  2. The research of solid state power supply for induction heating

    全固態高頻感應電源的研究
  3. Power capacitors for induction heating installations - general

    感應加熱裝置電源電容器.總則
  4. Power capacitors for induction heating installations - part 1 : general

    導熱絕緣電力電容器.第1部分:一般
  5. Polyphase induction motors for power generating stations

    發電站用多相感應電動機
  6. Heating principle of intermediate frequency induction furnace and some factors affecting its power factor are discussed, some betterments that parallel connection spacer circuit is replaced by interfusion connection spacer circuit are put in practice

    摘要對中頻感應爐的加熱原理以及其功率因數的影響因數進行了探討，並將不能恆功率輸出的並聯逆變電路改進為混聯逆變電路。
  7. Firstly. operation principle of induction heating is introduced and the actuality of the power supply for induction heating is summarized. then, the scheme of structure of the power supply is established : uncontrolled rectifier and buck chopper constitute dc circuit. in this part, operation principle of a kind of soft switching buck chopper is presented mainly and the conclusion that the power semiconductor devices operate in soft switching is also illustrated by analysing the operation principle of all stages ; series resonant inverter is selected as inverter circuit via comparing the advantage and shortcoming of parallel resonant and series resonant. moreover. the work principle of series resonant inverter is analysed and the calculating method of the best dead time is put forward as well

    文中首先介紹了感應加熱電源的工作原理並綜述了國內外的研究現狀。接下來分析並制定了電源主電路的構成方案：在對比幾種功率調節方式的基礎上選擇了不控整流加斬波調壓作為直流部分。在這部分里，重點研究了一種軟開關buck變換器，通過分析各階段的工作原理說明了開關器件如何工作在軟開關狀態；對于逆變器部分，在比較了串、並聯逆變器優缺點的基礎上選擇了串聯諧振逆變器，並詳細分析了串聯逆變器的工作原理，提出了最佳死區的計算方法。
  8. Through analyzing and researching the problem of variable frequency to working frequency of high - power electromotor in theory, the key of conversion is pointed out in the paper. on the basis of analyzing equivalent circuit diagram and vector - diagram of induction - motor, the phase of working frequency power whether or not consistent with the output phase of variable frequency power at the moment of conversion is the key to decide whether the conversion is successfully

    本論文針對大功率電機變頻轉工頻轉換存在的問題在理論上作深入細致的研究，根據感應電動機的等效電路和相量圖分析，指出大功率電機變頻轉工頻能否成功，關鍵在於變頻轉工頻瞬時，工頻電源和變頻輸出電源是否相位一致。
  9. Through analysising the characteristics of the power system with floating neutral point deeply, the paper puts forward a new plan of single - phase to ground fault line selection on the base of s ' s signal injecton method and gives the hardware and software design. in this design, the high speed sampling and data processing is carried out through using dsp processor ; the large electrice current is drived through the application of a high - performance audio power amplifier and transformer ; the communication between host computer and detectors is realized through rs485 bus technology ; the difference multilevel frequency - selected amplifier is designed and the feeble signal of space is sampled on the base of the theory of magnetic induction ; the interface between dsp and exterior chip and rs485 interface logical is designed through using fpga ; the using of lcd module and keyboard interfacing chip makes the interface between human and machine ; the programme of host computer and detectors is designed through using blocking design method

    在本設計中，採用高速的dsp處理器，實現了對故障特徵信息的高速採集與處理;採用大功率的功放晶元與變壓器配合的方法，實現了大電流信號的驅動輸出;採用485總線技術，組建了裝置主機與多探測器之間的主從式通訊網路，實現了多干擾條件下裝置主機與多探測器的可靠通訊;設計了差分式多級選頻放大電路，採用磁感應的方法實現了對空間微弱信號的接收;利用fpga技術，實現了控制器與多外設的介面及數字信號的串並轉換;採用了先進的lcd液晶顯示模塊及鍵盤介面晶元，設計了人機信息交互的介面;採用了模塊化的軟體設計方法，開發了裝置主機及探測器的軟體程序。
  10. The paper has done all - around study on the ac excited of variable - speed constant - frequency ( vscf ) wind power generation. the author has done thorough study on the vscf wind power generation technology using wound - rotor doubly - fed induction generator, from simulation to experiment, from theory to practice. he also did at large theory analysis to the vscf wind power generation technology using cascaded brushless doubly - fed generator, and has established stability theoretical foundation for continue study work

    本文對交流勵磁變速恆頻風力發電領域的關鍵技術進行了較為全面的從模擬到實驗、從理論到實踐的深入研究，同時對具有廣泛潛在應用前景的級聯式無刷雙饋發電機變速恆頻風力發電技術也進行了洋盡地理論分析，為今後進一步的深入研究奠定了一定的理論基礎。
  11. In this paper, several scheme of vscf is compared firstly, of which gets doubly - fed generating mode. doubly - fed vscf wind power generating system uses a doubly - fed induction generator, which rotate speed can be able to change with wind turbine, and it ensures a constant - frequency output, by controlling the frequency of current input into rotor windings. in vector trans control system, the control of stator active power and the control of stator reactive power can be essentially decoupled, and the former is via torque component and the latter is via exciting component of stator current

    本文首先比較了幾種變速恆頻方案，從中選擇了雙饋式變速恆頻方案；它運用雙饋電機的工作原理，允許發電機轉速變化，而在電機轉子側接入低頻勵磁電流，通過控制該電流的頻率，保證雙饋電機定子輸出的頻率恆定；再結合矢量控制技術，通過調節轉子電流來控制定子電流的轉矩分量和勵磁分量，相應獨立地控制發電機輸出的有功功率和無功功率。
  12. The work principle of dual stator - winding induction generator system, and the researches on practical application of dual stator - winding generator system are analyzed in detail. aimed at the work condition of wide rotor speed and optimization of static reactive power generator ’ s volume, the performance of dynamic state and static state and optimal control of high - voltage dc generator system based on dual stator - winding induction generator, are studied in this paper. these researches not only achieve the work characteristic of dual stator - winding induction generator system, but also set up the foundation of optimal design of dual stator - winding induction generator and engineering realization of dual stator - winding induction generator system used in wind generating

    本文闡述了定子雙繞組發電機的基本工作原理，基於matlab軟體建立了定子雙繞組感應電機發電系統的模型，並在此基礎上詳細分析了定子雙繞組感應電機發電系統的工作機理、影響兩套定子繞組容量比的因素等，從而摸清了該系統的特性，尤其是定子雙繞組感應電機高壓直流發電系統在變轉速、變負載下工作的特性，從而為該系統的工程實現奠定了重要的理論基礎。
  13. Induction heater is the main part of the electromagnetic induction heating, it determines the heating efficiency and power distribution. this article designs and analyzes the induction heater and magnetic flux field concentrator

    感應器是電磁感應加熱的重要部分，對感應加熱的效率和能量分佈起決定性作用，磁通集中器的設計直接關繫到系統加熱效率。
  14. Industrial electro - heat equipment ; power measurement on high - frequency appliances for induction heating equipment, measuring method for determination of power output of high - frequency generators

    工業電熱設備.感應加熱裝置用高頻設備的功率測量.高
  15. At the same time, the control circuit must realize power regulating of the rectifying circuit and the inverter circuit and keep some parameters impervious to the interferer. this paper has researched high frequency solid induction heating power supply

    同時，控制電路必須對整流電路、逆變電路等系統主電路部分進行功率控制，使在各種擾動下維持系統各參量不偏離其設定值。
  16. According to the requirements of propeller aerocraft model test in wind tunnel, specifications of the driven motor is presented by aerodynamic analysis, and a short - term operated high power density three - phase induction motor is developed with reasonably designing the motor, such as electromagnetism load, heat checkout and high - efficiency heat exchanger

    摘要針對螺旋槳飛機模型帶動力風洞實驗要求，通過氣動性能分析提出驅動電機的技術指標，在滿足結構約束的條件下，通過合理設計電機的電磁負荷、校核發熱、採用高效冷卻裝置等，研製出短時工作制高功率密度三相異步電機。
  17. After carefully analyzed the principle of standard svpwm and traditional overmodulation methods, this paper proposed one simple and effective overmodulation scheme. experiments were carried out in one 1. 5kw induction motor and its results were recorded and analyzed by pz4000 power analyzer and the proposed scheme were proved to be effective. although there are many sensorless control methods for induction motor control, many of which are either too complicated or too sensitive to the motor ? parameter to be put into practice

    在分析了標準svpwm演算法和常見各種過調演算法的原理的基礎上，提出了一種簡單有效的演算法滿足過調控制的要求，在1 . 5kw異步電機上進行了實驗並使用pz4000功率分析儀對其結果進行了準確測量與分析，證明了本文提出的svpwm演算法可以有效地提高電源電壓的利用率。
  18. Estimation of rotation speed for induction motor under non - sinusoidal power supply based on modified bp network

    神經網路非正弦供電下異步電動機轉速估計
  19. At present, in studying and developing heavy capacities and parallel resonant inverter, it is expected to solve the problems of researching on simple structure and easy to start frequently series resonant inverter in the fields of domestic high frequency induction heating installation. therefore, researching of the subject is to design and study a high frequency ( more than 1 mhz ) and high power topological structures of full solid - state induction heating power supply

    目前在研究和開發大容量的並聯逆變中頻電源的同時，研製結構簡單，易於頻繁起動的串聯逆變高頻電源是國內高頻感應裝置領域有待解決的問題，基於此種需要，本課題主要研究設計一種高頻（ 1mhz以上）大功率全固態感應加熱電源逆變電路的拓撲結構。
  20. The stator of aceg is connected to the grid and the three symmetrical excitation windings in the rotor are fed by converter. the magnitude and frequency and phase and phase sequence of excitation voltage can be controlled, so the magnitude and position of excitation mmf as well as the speed of rotor can be controlled. therefore, acegs have superior performances by contrast with conventional synchronous generators and induction generators, such as upstanding stability, power generation of variable speed constant frequency ( vscf ), adjusting active power and reactive power independently, and absorbing lag reactive power deeply

    交流勵磁發電機的基本結構與繞線式異步電機相同，其定子側接電網，轉子上採用三相對稱分佈的勵磁繞組，由變頻器提供對稱交流電勵磁，且勵磁電壓的幅值大小、頻率、相位、相序都可根據要求加以控制，從而可以控制發電機勵磁磁場大小、相對于轉子的位置和電機的轉速，使得交流勵磁發電機具有良好的穩定性及轉速適應能力、獨立的有功與無功調節能力和較強的進相運行能力，性能超越傳統同步發電機和感應發電機，因而有著廣闊的應用前景。
分享友人
分享到 Line

分享到臉書