preparation of charge 中文意思是什麼

preparation of charge 解釋
爐料準備, 裝料準備
  • preparation : n 1 準備，預備；〈常 pl 〉準備工作[措施]；預修，預習 （for） 預習時間；（對…的）準備。2 （藥、菜...
  • of : OF ＝Old French 古法語。
  • charge : vt 1 填；裝（子彈）；充（電）；使飽和；使充滿；堆積，裝載。2 命令；促；諭示，指令。3 責備；告誡。...
  1. Cluster models and quantum chemical methods were used to study the charge - discharge mechanism, performance and their relationship with the structure of lig for the purpose of providing a theoretical ground to the preparation, function improvement and application of materials

    本文採用簇模型並利用量子化學等方法探究了嵌鋰石墨充放電機制、性能和與嵌鋰石墨結構間的關系，為負極材料的研製、改性及應用提供材料設計的理論依據。
  2. This position is in charge of the managing, editing and gathering manuscripts, and also the daily management of edit department, including soliciting manuscripts, supervision, control of magazine content and work progress and preparation for the launch of the magazine

    此崗位一半是處理編輯部的采編任務，另一半是部門日常運做的管理，包括人員約稿、監督、控制雜志內容和工作進度以及籌備新雜志的出版。
  3. The interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  4. Abstract : the interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    文摘:研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  5. A series of experiments were conducted to research on electrode according to the principle of energy - storage materials, electroly tes, preparation techniques with the aids of the measure methods such as cyclic voltammetric measurements ( cv ), constant charge / discharge measurements, impedance spectrum, x - rays diffraction ( xrd ), transmission electronic microscope measurements ( tem ), and so on

    本文採用了循環伏安、恆電流充放電、交流阻抗、 x射線衍射、透射電子顯微鏡等實驗方法和測試手段對超大容量電容器的電極活性物質材料及電極製作工藝、電解質溶液的選取等問題展開了一系列研究。
  6. In additon this paper studied the preparation techniques and obtained small capacitor with the specific capacitance of 54 f / g when the charge - discharge current was 2. 5ma / cm2, whose cyclic life was over 1000 cycles. successfully we made kilofarads capacitor

    本文進一步研究了碳電極的製作工藝，得到的小型碳基電容器在2 . 5ma cm ~ 2的充放電電流下測得的比容量可達54 . 01f g ，循環壽命千次以上，並成功的制備了千法拉級的電容器。
  7. Resume ( s ) of the person ( s ) - in - charge of the organization preparation and relevant certificates

    （四）擬設機構籌建負責人的簡歷及相關證明材料。
  8. ( 1 ) carbon aerogel and xerogel were made from resorcinol - formaldehyde organic gels and used as the anode materials for lithium ion batteries. by discussing the influences of pyrolysis temperature, the level of the catalyst and the concentration of reactant in the preparation of carbon materials on their behavior of lithium ion storage, their performance of storing lithium ions and process of charge and discharge were studied in details. moreover, the relationship between the structure of carbon aerogel and xerogel and the performance of storing lithium ions was analysed, and the mechanism of the storage of lithium ions in this type of porous carbon materials based on organic gels was also dicussed simply

    （ 1 ）從合成間苯二酚-甲醛有機凝膠出發，制備了碳干凝膠和氣凝膠，研究了其作為鋰離子電池碳陽極材料的儲鋰性能，探討了碳材料制備過程中的熱分解溫度、催化劑用量、反應物含量等條件對碳干凝膠和氣凝膠儲鋰行為的影響，並分析了碳材料結構與儲鋰性能的關系以及充放電過程，也簡單探討了鋰離子在這類基於有機凝膠的多孔碳材料中的存儲機制。
  9. In charge of and make sure payroll calculation and distribution ， iit preparation

    負責並確保員工工資的正確計算和支付、稅金的正確計算和繳納。
分享友人
分享到 Line

分享到臉書