primary coolant 中文意思是什麼
primary coolant
解釋
初次冷卻劑-
It would be like draining primary coolant from a nuclear plant times 10 million
否則會從核裝置排放出千萬倍的原子核冷凍劑 -
There are many equipments important to safety in - vessel of cefr, such as intermediate heat exchanger, decay heat exchanger, primary coolant pump, and core support structure
其堆內有許多涉及反應堆安全的重要部件,如中間熱交換器,事故熱交換器,一次主循環鈉泵以及堆內支承等。 -
Each primary coolant pump will circulate the cooling water ordinary water around the loop through the reactor core at a high pressure of about 155 bar 1 bar 100 kpa. in addition to its
每一臺主泵會帶動約155巴1巴100千帕的高壓冷卻水普通水在其環路內經過反應堆堆芯循環流動,這些冷卻水不但是用作 -
In addition, the fission rate in the pwr can also be controlled by adjusting the boron a neutron absorber concentration in the primary coolant circuit
此外,壓水式反應堆的核裂變也可透過調節一迴路內冷卻劑中的硼濃度來控制硼亦是一種中子吸收體。 -
In addition, the fission rate in the pwr can also be controlled by adjusting the boron ( a neutron absorber ) concentration in the primary coolant circuit
此外,壓水式反應堆的核裂變也可透過調節一迴路內冷卻劑中的硼濃度來控制(硼亦是一種中子吸收體) 。 -
Fault of primary coolant circuit equipment in nuclear power plant and the comprehensive intelligent diagnosis system
船用核動力一迴路設備故障綜合智能診斷系統 -
In - service inspections for primary coolant circuit components of light water reactors - part 4 : visual inspection
輕水反應堆初級冷卻劑迴路元件運行中檢查.第4部分:目 -
The pressuriser is mainly used to maintain the pressure in the primary coolant circuit and prevent overpressure
穩壓器的主要作用是維持一迴路冷卻水的壓力,防止超壓。 -
In - service inspections for primary coolant circuit components of light water reactors - part 7 : radiographic testing
輕水反應堆初級冷卻劑迴路元件運行中檢查.第7部分:放 -
In - service inspections for primary coolant circuit components of light water reactors - part 1 : automated ultrasonic inspection
輕水反應堆初級冷卻劑迴路元件運行中檢查.第1部分:自 -
In - service inspections for primary coolant circuit components of light water reactors - part 2 : magnetic particle and penetrant inspection
輕水反應堆初級冷卻劑迴路元件運行中檢查.第2部分:磁 -
In - service inspections for primary coolant circuit components of light water reactors - part 6 : eddy current testing of steam generator heating tubes
輕水反應堆初級冷卻劑迴路元件運行中檢查.第6部分:蒸 -
The water level inside the pressuriser and thus the pressure in the primary coolant circuit can be controlled by operation of the heaters and water spray
透過控制穩壓器內加熱器和噴淋水的運作,便可調節穩壓器內的水位與及控制一迴路的壓力。 -
Primary - coolant clean - up system in nuclear power plants with light water reactors
輕水反應堆核電站的初級冷卻液清潔系統 -
Each loop has a primary coolant pump, a steam generator and the interconnected piping
每一環路設有一臺主泵一臺蒸汽發生器,與及連接管道。 -
Each loop has a primary coolant pump, a steam generator and the interconnected piping. a pressuriser is installed in one of the 3 loops
每一環路設有一臺主泵、一臺蒸汽發生器,與及連接管道。其中一個環路裝設一臺穩壓器。 -
Nuclear reactor and primary coolant system
核反應堆及主冷卻劑系統 -
Primary coolant system
主冷卻劑系統 -
The primary coolant system of a 900 mw class reactor consists of the reactor pressure vessel and the primary circuit with 3 identical loop top figure
一個900兆瓦的反應堆主冷卻劑系統上圖是由壓力殼及三個相同的環路相連組成即一迴路。 -
The primary coolant system of a 900 mw class reactor consists of the reactor pressure vessel and the primary circuit with 3 identical loop ( top figure )
一個900兆瓦的反應堆主冷卻劑系統(上圖)是由壓力殼及三個相同的環路相連組成(即一迴路) 。
分享友人