pull-in test 中文意思是什麼
pull-in test
解釋
牽入試驗-
Finally, an energy approach is combined with the fem in the simulation of the crack propagation along the fiber / matrix interface in a pull out process. the simulated results are in nice conformity with experimental results. the second part of the research deals with the characterization of the failure process in the fragmentation tests, which is one of the most frequently used test methods in studying thermal mechanical properties of fiber / matrix interfaces
在這一部分工作的最後，採用能量法與有限元法結合起來，模擬纖維抽拔試驗中裂紋的擴展:針對以往研究工作中的不足之處，在模擬中使用能量釋放率，在表徵界面破壞時，所使用的應力強度因子考慮了纖維和基體兩種材料的不同屬性，並考慮裂紋尖端的單元奇異性，來研究裂紋長度和溫度對裂紋擴展的影響。 -
Currently, the main methods used to measure the fiber / matrix interface properties of composite were based on micro - mechanics, including single - fiber composites fragmentation test ( sfc ), micro - debonding technique, single - fiber pull - out test, and single - fiber push - out test, in which sfc was most widely used
目前直接用來測定纖維增強復合材料界面力學性能的主要微觀力學方法有單纖維復合材料斷裂實驗（ sfc ） 、微脫粘方法、單纖維拔出法、單纖維頂出法，其中以單纖維復合材料斷裂實驗的應用最為廣泛。 -
Although numerical methods have frequently been used in the study of frc, theoretical analyses of such test methods as pull out tests and single fiber fragmentation tests, seemingly simple, remain to be challenging problems. problems arise when other factors are considered in connection with the various numerical models. these factors include nonlinearities in the properties and / or geometries of the materials, influences of such environmental conditions as temperature ( which is also to be studied in the present work )
本論文正是針對以往研究中的不足，在對纖維增強復合材料破壞問題進行數值模擬的研究中，綜合考慮了纖維和基體材料的非線性效應、纖維和基體材料受外載發生大變形時的幾何非線性，以及纖維基體之間界面脫粘時接觸單元的非線性效應。 -
The 3 batches with 7 groups of prism concrete test specimens and the 3 batches with 22 groups of cube ones were used in mechanical properties test, and a series of parameters of rpc was acquired such as prismatic strength, the cubic strength, split and pull strength, deformation module, peak strain, poisson ' s ratio
進行三批7組稜柱體試件和三批22組立方體試件的力學性能試驗，測定了rpc200稜柱體抗壓強度、立方體強度、劈拉強度、彈性模量、峰值應變、泊松比等參數，並建立了變形模量和峰值應變的擬合公式。 -
Standard test method for field pull testing of an in - place exterior insulation and finish system clad wall assembly
外部絕緣和精整系統包壁組件中的現場拉伸測試的標準試驗方法 -
Roofing and wall cladding. fasteners. determination of the characteristic resitance of the assembly. test method to determine pull - out load of fasteners in crow or valley fixing out of their subconstruction
屋面和墻壁覆面.緊固件.組件抗性測定.拱頂和屋面排水溝安裝的緊固件從基底拉出的拉拔負荷的測定試驗方法 -
This paper first present a study on the bond properties of furan resin concrete reinforced with gfrp bars, in which the pull - out test was adopted to investigate the bond performance between gfrp bars and furan resin concrete, compare the bond strength of gfrp bars of different surface disposal and validated the feasibility by test the gfrp bars reinforced furan resin concrete beam. then the paper provides a micro - mechanical model for the splitting failure analysis of gfrp reinforced concrete member and deducted the relation between splitting failure load and parameter of gfrp rod
本文首先對gfrp筋加強呋喃樹脂混凝土及普通混凝土的界面粘結性能進行了實驗研究，對玻璃鋼筋表面採取了三種處理方法，用拔出試驗研究分析了gfrp筋和呋喃混凝土、普通水泥混凝土之間的粘結強度，比較了用不同方法進行表面處理的效果，確定了合適的表面處理方案，並通過對gfrp筋加強呋喃混凝土梁進行了彎曲試驗，進一步驗證了方案的可行性。 -
In 1989, only 2 percent of the students could pass a fitness test that included a mile run, situps, sit - and - reach ( to measure flexibility ), and pull - ups
在1989年，只有2的學生能通過一項健康測試，該測試包括一英里長跑、仰臥起坐、屈體前伸（測試柔曲性）和引體向上。 -
This paper use the principle of mass concrete temperature raise and down will make concrete inside stress and strain cause change, and mixture ratio of concrete effect temperature stress, and the principle of equilibrium management model of china - pole, and the test curve of temperature in engineering, and the model experiment " anti - pull " together of mass concrete etc, to studied mass concrete anti - crack theory in design, construction and management
本文採用大體積混凝土溫度升降引起混凝土內部的應力和應變產生變化及混凝土的配合比對其溫度應力的影響原理、鏈桿平衡管理模型的計算原理、工程溫度實測曲線、大體積混凝土「抗?放」結合模型的試驗結果等研究了大體積混凝土在配筋設計、施工及施工管理過程中的抗裂措施。 -
Based on the muscle force trait of slalom kayaking and by using the force quality testing equipment, the maximal power test of bench pull in different weight was given to the national excellent women slalom kayakists
摘要通過研製的力量素質測試設備，根據皮劃艇激流運動主要肌肉用力特點，對國家皮劃艇激流隊優秀女隊員進行了不同重量下的臥拉最大功率的測試。 -
In our country, no pull - out test of pressure - type anchor has ever been made in rock till now. in chapter 4, consulting some pull - out tests of pressure - type anchor made by some civil researchers, contrast pull - out tests of pressure - type and tensile - type anchor in rock is designed in crag slope engineering in chongqing university
本文第四章在在參考國內一些單位已經進行的部分壓力型錨桿抗拔試驗的基礎上，針對基於巖層的該類型試驗還是空白的現狀，結合重慶大學沿江危巖邊坡治理工程設計了巖層中的壓力型錨桿與傳統拉力型錨桿抗拔力對比實驗。 -
Bearing capacity and displacement are two main problems in the application of geotechnical engineering. based on a series of pull - out tests using three kinds of paper and a sort of window screening as geogrid, twenty - seven in limit and several in working - stress geogrid - reinforced slope model tests designed through orthogonal principle have been conducted to have obtained the relationship between the bearing capacity and four factors ( i. e. reinforcement, angle of reinforced slope, the designed - length of reinforcement and the distance between layers of reinforcement ). the law of slope lateral ( horizontal ) displacement versus to the height of slope vary with external - load was derived from the model test data, and the main factor affecting the lateral and vertical displacement of geogrid - reinforced slope was obtained through analysis
承載力（強度）和變形是巖土工程應用領域的兩大主要問題，本文以紙和窗紗布模擬加筋土邊坡的土工格柵，在一系列拉拔試驗的基礎上，以正交設計理論分別安排27個極限應力狀態和若干個工作應力狀態加筋土邊坡模型試驗，並以模型試驗獲得的數據為依據，採用誤差、極差及回歸分析方法，探討了加筋土邊坡承載力與筋類、筋長、層間距、坡角4因素的相關關系，獲得了在外荷載作用下加筋土邊坡的側向位移隨坡高的變化規律（並進行了定性解釋）和坡頂的豎向位移特性，並分析其主要控制因素。 -
By the test of anchor cable pull - out intensity, research is carried on anchor capability, stiffness coefficient and prestress losses of anchor cable in reinforcing similar soil slopes. the mechanisms of reinforcing similar soil slopes by prestressed anchor cable sash ( beam ) are studied by the method of combination of field test, theory analysis and numerical simulation, as a result, the calculational pattern of internal force of anchor cable sash ( beam ) is put forward
本文通過大量野外調查，提出類土質邊坡的概念，並分析了它不同於一般粘性土邊坡的特性；通過錨索抗拔試驗研究了類土質邊坡的錨固力大小、錨索剛度系數和錨索預應力損失情況；通過現場試驗、理論分析和數值計算相結合的方法，研究預應力錨索框架（地梁）加固類土質邊坡的機理，提出預應力錨索框架（地梁）的內力計算模式。 -
This thesis attempts to explore some issues that deserve greater attention and further elucidation. based on a number of on - the - spot surveys and investigations, the thesis, taking statistics approaches such as factor analysis, one - way anova, independent - sample t test and regression, carries out in depth study of the push - pull theory, residents ’ perceptions and attitudes towards tourism in vernacular villages in southern anhui. furthermore, this thesis analyzes problems existing in tourism development of vernacular villages in southern anhui from a macroscopic perspective
為了促進皖南古村落旅遊的可持續發展，本文試圖從目前皖南古村落旅遊研究中涉及較少或已涉及但有待深化的領域著手，在大量實地走訪、問卷調查的基礎上，通過因子分析、方差分析、 t檢驗法和回歸分析等定量評價方法，深入研究皖南古村落旅遊推力-引力體系和古村落居民感知與態度，並從宏觀層面上分析皖南古村落旅遊發展中存在的一些問題。 -
To identify the interaction between kyot2 and zo - 2 - i3, yeast two - hybrid system, purification of kyot2 protein and gst pull - down assay were performed in the experiments. after kyot2 and zo - 2i3 exchanged their vectors, yeast two - hybrid test revealed physical binding of the two proteins
本實驗通過酵母雙雜交及gstpull downas腳驗證了kyotz蛋白與zoz蛋白在體外的相互作用，並通過酵母雙雜交實驗初步確定其相互作用的位點。 -
Furthermore, analyzing the characteristics of the ultrasonic motor in the resonant state. on the basis of theoretical research, an experimentation is made, by which we analyse the disadvantages impacting the work of traveling wave and test the relationship among pressing force, speed and pull. the results of the experimentation validate the correctness and reliability of theoretical analysis
在理論分析的基礎上，對設計的超聲波馬達進行了實驗分析與測試，分析了影響馬達運轉的不利因素，測試了超聲波馬達不同預壓力下速度與力矩以及馬達空載時速度與頻率、速度與電壓之間的關系，驗證了理論分析結果的正確性和可靠性。 -
Studies on the net shape and shape pull test with steel in road border water and soil loss controlling project
公路邊坡水土流失治理工程中網狀及條帶式加筋拉拔特性的試驗研究 -
Roofing and wall cladding - determination of the characteristic resistance of the assembly - test method to determine pull - out load of fasteners in crown or valley fixing out of their subconstruction
屋頂和墻面覆蓋層.耐安裝特性的測定.固定在拱頂或屋谷下層結構之外的緊固件的拉出力測定的試驗方法
分享友人