push pull converter 中文意思是什麼

push pull converter 解釋
推挽變換器
  • push : vt 1 推（門等） （opp pull; draw）; 推動（車子等）；刺出（劍、手杖等）。2 大力推進，進行。3 使延...
  • pull : vt 1 拉，拖，牽，曳 （opp push）; 勒（馬）。2 拽住；扯破，扯開。3 拔去（雞等的）毛；拔（牙齒、瓶...
  • converter : n. 1. 使轉變[改變信仰]的人。2. 改裝者，改裝品。3. 【冶金】煉鋼爐，吹風轉爐；【電，無】換流器，變壓器；變頻器；【自動化】變換器；密碼翻譯[編制]機。
  1. Push pull converter

    推挽轉換器
  2. Then novel circuit structure of bi - directional voltage mode ( based on forward converter ) inverters with high frequency link, are proposed, which is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filter ; the circuit topologies family of this bi - directional voltage mode inverters with high frequency link include six circuit topologies, such as push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controlled bi - directional voltage mode inverters with high frequency link is introduced

    本文首先論述了dc / ac逆變技術的應用前景及發展現狀。基於正激forward變換器的雙向電壓源型高頻環節逆變器電路結構，由輸入周波變換器、高頻變壓器、輸出周波變換器、以及輸入、輸出濾波器構成;雙向電壓源高頻環節逆變器電路拓撲族，包括推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式六種電路。
  3. This paper introduces the fundamental and characteristic of the fuel cell, analyzes the necessity and detail scheme of adding assistant energy sources to the fuel cell power generation system. considering for the special demand of the fuel cell power generation system, this paper gives out a push pull forward converter ( ppfc ) with passive and lossless dual cdd snubber circuit

    本文首先闡述了燃料電池的基本原理和性能特點，分析了在燃料電池發電系統中引入輔助能源系統的必要性及具體的配置方案，然後針對燃料電池發電系統對dc / dc變換器設計的特殊要求，提出了一種加雙cdd無源無損緩沖電路的推挽正激變換器（ pushpullforwardconverter ， ppfc ） 。
  4. A new soft - switching push - pull three - level converter

    一種新型軟開關推挽三電平直流變換器
  5. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  6. Using the modified method, 6 kinds of tl topologies of single - switch converter are obtained. the deep research reveals that these tl topologies can have less value of the inductor by using interleaving modulation strategy compared with conventional modulation strategy on the condition that the current ripple of the inductor are the same. some drawbacks such as high voltage stress, difficulty of realizing soft - switching, and magnetic aberration were presented in the conventional push - pull converter

    對基本方法進行改進，提出了適合6種單管直流變換器的三電平拓撲變換方法，成功地得到了其三電平拓撲，開關管的電壓應力降為原來的一半；經過對這些三電平拓撲控制策略的深入研究，詳細論述了交錯開關方式可以最大幅度地減小電感的電流脈動，從而可以在電流脈動要求相同的情況下減小電感的設計值。
  7. Comparing with usual push - pull converter, the bias - magnetic can be retrained due to the clamping capacitance. but bias - magnetic can not be avoided

    推挽正激變換器相比普通的推挽式變換器，由於箝位電容的存在，偏磁可以被抑制，但並不能完全消除。
  8. The push - pull tl converter can be deduced by using the basic tl topology derivation and by special derivation only used in this topology, in which, the voltage stress of each switches is input voltage

    應用三電平拓撲的基本變換方法，經過對該拓撲結構的特殊變換，得到了推挽三電平直流變換器的拓撲，其開關管的電壓應力為輸入電壓，與傳統推挽直流變換器相比，電壓應力降低了一半。
  9. These methods all can be used to solve the magnetic aberration hi the conventional push - pull converter

    這兩種方式均可以解決傳統推挽直流變換器存在的偏磁問題。
  10. Based on comparison of different dc / dc converter, push - pull forward converter ( ppf ) is selected as main system prototype

    在比較多種常用拓撲的優缺點后，本文選用推挽正激電路作為主電路拓撲。
  11. The thesis focused on the dc link topology of the modulariation aviation static converter. first, the push - pull converter is developed. then, the principle of push - pull forward converter is analyzed in detail

    本文主要針對模板化航空靜止變流器直流環節進行研究，研究了推挽、推挽正激和隔離型boost三種電路方案。
  12. The whole high power switch supply have four bidirectional dc / dc converters which are parallel connection. the theory of phase - shifted full - bridge zvs pwm dc / dc converter and the theory of push - pull boost converter are introduced. the methods of realize zvs ( zero voltage switching ) is studied in detail

    文中介紹了移相全橋式軟開關變換及推挽式dc dcboost變換的工作原理，分析了移相全橋zvs的實現和占空比的丟失，並設計了各自的控制電路和保護電路。
  13. In this dissertation, a novel bidirectional dc / dc converter ' s topology was designed, witch used in vehicle power supply systems. the converter is composed of fundamental bidirectional switch cell, using phase - shifted full - bridge zvs pwm dc / dc converter in buck circuit and using push - pull boost converter in boost circuit

    文中從雙向dc dc變換基本單元入手，針對某大型車載電源系統設計了一種新型雙向dc dc變換器拓撲電路，降壓變換採用移相全橋式zvs ? pwm功率變換，升壓變換採用推挽式dc dcboost功率變換。
  14. Aimed to acquire high efficiency and realize high frequency of the converter, this paper takes the forepart of the aeronautical static inverter ( asi ) - dc / dc converter as research object. push - pull forward converter ( ppfc ), which adapts to be applied in low voltage, high current input power field, is proposed and studied in this paper based on comprehend to main characters of asi and references to the development of the vrm

    本文以航空靜止變流器中dc dc ? dc ac結構的前級為主要研究對象，針對效率和高頻化問題，在充分考慮航空靜止變流器前級dc dc特點的基礎上，借鑒國外vrm技術的發展歷程，選擇了適合於低壓大電流場合下工作的推挽正激電路（ ppfc ） ，作為基本電路拓撲，進行了一些理論與實驗的研究工作。
  15. Then novel circuit structure and circuit topologies family of current source ac / ac converters with high frequency ac link, based on flyback converter, are proposed. the circuit structure which can transfer one unregulated sinusoidal voltage with high thd into another regulated constant frequency sinusoidal voltage with low thd, is constituted of input cycloconverter, high frequency storage transformer, output cycloconverter, input and output filter. the circuit topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits

    本文提出了基於反激flyback變換器的電流源高頻交流環節ac ac變換器電路結構及其拓撲族，該電路結構由輸入周波變換器、高頻儲能式變壓器、輸出周波變換器以及輸入、輸出濾波器構成，能夠將一種不穩定劣質的正弦交流電變換成另一種同頻率穩定的優質正弦交流電壓；該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式等四種電路。
分享友人
分享到 Line

分享到臉書