push pull current 中文意思是什麼
push pull current
解釋
推挽電流-
From the view point of the whole topologies of current mode hfl inverters, two topologies of half - bridge and push - pull current mode hfl inverters are proposed, which are composed of four power switches. hfl inverters in discontinuous current mode ( dcm ) are extended to those in continuous current mode ( ccm )
從完善電路拓撲和降低成本的角度出發，本文提出了兩種結構的電流源高頻鏈逆變電路，它們分別是由四個功率管組成的半橋和推挽雙向電流源高頻鏈單級逆變電路，並將工作在電感電流斷續模式的逆變電路擴展到電感電流連續模式。 -
Using the modified method, 6 kinds of tl topologies of single - switch converter are obtained. the deep research reveals that these tl topologies can have less value of the inductor by using interleaving modulation strategy compared with conventional modulation strategy on the condition that the current ripple of the inductor are the same. some drawbacks such as high voltage stress, difficulty of realizing soft - switching, and magnetic aberration were presented in the conventional push - pull converter
對基本方法進行改進，提出了適合6種單管直流變換器的三電平拓撲變換方法，成功地得到了其三電平拓撲，開關管的電壓應力降為原來的一半；經過對這些三電平拓撲控制策略的深入研究，詳細論述了交錯開關方式可以最大幅度地減小電感的電流脈動，從而可以在電流脈動要求相同的情況下減小電感的設計值。 -
The push - pull mode switch power supply is chosen as the main circuit of the other voltages with pwm control circuit, over - current protection circuit, insulated drive circuit, mosfet buffer circuit and so on
採用高效的推挽式電路作為中低壓電源的主電路，並以pwm控制電路、隔離式驅動電路、過流保護電路、 mosfet緩沖電路、軟啟動電路、穩壓電路等作為輔助電路。 -
The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier
本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。 -
Voltages, applied to microscopic electrodes built up around these islands, push and pull electrons in and out of these regions, opening and closing the logic gates and regulating the flow of electric current through them
在這些島之間布置的微電極上加電壓，就能推拉電子進出這些區域、開關邏輯閘，並且調控經過其間的電流。 -
Aimed to acquire high efficiency and realize high frequency of the converter, this paper takes the forepart of the aeronautical static inverter ( asi ) - dc / dc converter as research object. push - pull forward converter ( ppfc ), which adapts to be applied in low voltage, high current input power field, is proposed and studied in this paper based on comprehend to main characters of asi and references to the development of the vrm
本文以航空靜止變流器中dc dc ? dc ac結構的前級為主要研究對象，針對效率和高頻化問題，在充分考慮航空靜止變流器前級dc dc特點的基礎上，借鑒國外vrm技術的發展歷程，選擇了適合於低壓大電流場合下工作的推挽正激電路（ ppfc ） ，作為基本電路拓撲，進行了一些理論與實驗的研究工作。 -
The circuit topologies family of voltage mode ac - ac mode ac / ac converters with high frequency link include eight circuit topologies, such as single forward mode, interleaved - forward mode, push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. the circuit topologies family of current mode ac - ac mode ac / ac converters with high frequency link include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controll is introduced
電壓源交?交型高頻環節ac ac變換器電路拓撲族，包括單正激式、並聯交錯正激式、推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式八種電路；電流源交?交型高頻環節ac ac變換器電路拓撲族，包括單四象限功率開關式、推挽式、半橋式、全橋式四種電路。 -
Then novel circuit structure and circuit topologies family of current source ac / ac converters with high frequency ac link, based on flyback converter, are proposed. the circuit structure which can transfer one unregulated sinusoidal voltage with high thd into another regulated constant frequency sinusoidal voltage with low thd, is constituted of input cycloconverter, high frequency storage transformer, output cycloconverter, input and output filter. the circuit topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits
本文提出了基於反激flyback變換器的電流源高頻交流環節ac ac變換器電路結構及其拓撲族，該電路結構由輸入周波變換器、高頻儲能式變壓器、輸出周波變換器以及輸入、輸出濾波器構成，能夠將一種不穩定劣質的正弦交流電變換成另一種同頻率穩定的優質正弦交流電壓；該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式等四種電路。 -
Push - pull current mode hfl inverter also is composed of four power switches. the simulation and experiment of a 500va experimental prototype indicates that this circuit has the advantages of less components, simple topology, the ability of four quadrant operation and high efficiency. the inverter does not need the symmetry of the components " parameters and can be applied to dc to ac conversion with single low input voltage source
推挽雙向電流源高頻鏈逆變電路也是由四個功率管組成， 500va的原理樣機的模擬和實驗研究結果表明，該電路元器件少、電路拓撲簡單、能夠四象限可靠運行、變換效率高，並不要求器件參數的完全對稱，適合於輸入電壓較低的場合。
分享友人