q axis 中文意思是什麼

q axis 解釋
q軸
  • q :
  • axis : n ( pl axes )1 軸,軸線。2 【植物;植物學】莖軸。3 【解剖學】第二頸椎,第二脊骨。4 【政治學】軸...
  1. The q - axis and d - axis reactance, in which is parallel structure with several branches, is studied by analytical method

    對具有多條並聯支路的磁路進行了分析研究,給出了其計算程序。
  2. The stability of electric power system has been being focused for a long time toprevent a power system from losing synchronism after sudden fault , researchers have done much work and got many accomplishments this paper applied the direct feedback linearization ( dfl ) technique on the power system , a strong nonlinear system simulation results by matlab proved this method efficiency main works and results are as follows : this paper compared some existing methods in excitation control , fast valve control and coordinated control respectively, analyzed the developments and actuality of nonlinear control research in brief, illustrated why ransient stability could be greatly improved by using the fast valve control in chapter 3 , indicated the importance of coordinated control farther this paper introduced the inverse system theory, based on which , discussed the dfl theory, pointed out which had consistency with the inverse theory, expanded the dfl theory combined the idiographic model equations , made which adapt to the model of a single machine - infinite bus power system this paper referenced abundance articles and educed a set of equations , which could describe the dynamical process of excitation and fast valve control for synchronous generators in the equations , there were several very important parameters of power system - - rotor angle ( ) , rotor speed ( ) , generator q axis voltage ( eq ) , transient voltage ( e ' q ) , active power ( pe ) , mechanical input power ( pm ) , valve opening ( ) , generator terminal voltage ( vt ) , based on the model , nonlinear coordinated controller and terminal voltage optimal controller have been designed by using the expanded dfl theory and lq optimal control theory the simulation results showed that the controller could keep power system transiently stable under the effects of a symmetrical 3 - phase short circuit fault , which achieved better postfault regulation compared with another two routine methods , one is the proportion excitation controller and proportion fast valve controller, the other is the proportion excitation controller and the optimal fast valve controller, which could exert good performance when met 1ittle disturbance either

    在介紹逆系統理論的基礎上,詳細介紹了dfl理論,通過比較闡明了dfl理論其本質是逆系統方法的一類,並結合具體課題推導出的模型方程將dfl理論進行了擴展,使之適應于電力系統這個強非線性對象。通過參考大量的書籍文獻推導出一套實用的可將大型汽輪發電機勵磁與汽門綜合起來進行控制的模型方程,此模型方程涵蓋了電力系統中特別引人注目的幾個量- -轉子角、轉子轉速、發電機q軸電勢eq 、暫態電勢e ' q 、有功功率pe 、機械功率pm 、汽門開度、機端電壓vt ,在此基礎上建立了實用的電力系統簡化的數學模型,並將擴展的dfl理論應用於此模型系統,結合線性二次型最優控制理論設計出大型汽輪發電機的非線性綜合控制器及機端電壓最優控制器,通過模擬實驗與採用常規的按電壓偏差進行調節的比例式勵磁控制器+汽門比例控制及採用常規的按電壓偏差進行調節的比例式勵磁調節器和基於二次型性能指標設計的最優快控汽門(考慮發電機的飽和因素)進行了對比,證實了採用此種控制器可以有效地提高電力系統的暫態穩定性,並且在電力系統遭受小干擾時同樣具有良好的調節性能。
  3. The same type of cement - soil mixing pile with concrete core, concrete pile and cement - soil pile that means they have the same pile length and pile diameter is deeply analyzed by finite element program. we get the q - s curve, the axis force of pile body curve, the stress of pile curve and the side and the end sharing load ratio of the pile curve by finite element program. with the help of the finite element program, the paper finds the relations between the pile ' s parameter and its bearing capacity and load transferring properties

    利用有限元計算分析了同比(樁長相同、樁徑相同)水泥土組合樁、水泥土攪拌樁和混凝土鉆孔灌注樁,得到了它們的荷載沉降曲線、樁身應力曲線、樁身軸力曲線、樁側樁端分擔荷載曲線等,通過這些曲線對它們的荷載傳遞規律以及變形特性進行了深入的分析。
  4. In the proposed technique the bemf waveform of bldcm need to be measured in advance at first, through computer simulation and frame transformation, the optimum q - axis current command is achieved. in order to minimize the torque ripple, the d and 0 - axis current command should be zero. furthermore, through reference frame transformation from dqo - axis to abc - axis, we can get the optimum current command in static abc reference frame

    在這種控制方法中首先測量出電機的實際反電動勢波形,然後通過計算機擬合和坐標變換,求得產生恆定電磁轉矩所需的q軸電流,令i _ d ~ * = i _ 0 ~ * = 0 ,通過坐標變換,得到三相靜止坐標系a - b - c下的參考電流i _ a ~ * , i _ b ~ * , i _ c ~ * ,利用電流滯環控制來產生pwm信號,由於這種控制方法中電流不會突變,從而可以較好的抑制轉矩脈動。
  5. According to the relationship of the angle of the maximum torque and the q axis, the reluctance torque for salient pmsm is made full use of and the sator current amplitude is reduced by a large percentage, so that the system robustness is greatly increased. at the speed loop, this paper presents a single value model algorithmic control strategy which is the simplied form of normal model algorithmic control and has less computation work than the latter, so the real - time performance is very good

    對于嵌入式pmsm ,根據在電流幅值一定的條件下最大輸出轉矩與(為等效電流矢量和q軸之間的相位角)之間的關系,將磁阻轉矩轉換為輸出轉矩從而提高了輸出轉矩,改善了系統的控制性能;在速度環採用單步模型演算法控制,其計算量比較少,提高了系統的實時性和魯棒性。
分享友人