quasi-flow 中文意思是什麼

quasi-flow 解釋
半流動
  • quasi : adv 1 在某一意義上,有點,幾乎。2 恰如,宛如,就像是。3 就是說,即〈略作 q 或 qu 尤用以作語源上的...
  • flow : vi 1 流,流動。2 (血液等)流通,循環。3 流過;川流不息;(時間)飛逝;(言語等)流暢。4 (衣服、...
  1. The air flow was regarded as quasi-laminar.

    空氣流動被視為準層流。
  2. As we know, inverse techniques make blade ' s profile well compatible with its surface velocity distribution, however, they give designers big challenges that the ideal velocity distribution is hard to obtained and sometimes the non - physical solution, such as double covering of flow field or unclosed profiles, would come out. the proposed design procedure in the paper has avoided the disadvantage mentioned above. in this paper, a quasi - irrotational equation is used to describe the flow in cascade instead of the generally used irrotational equation

    眾所周知,一般的反問題和混合問題的最大特點,是在給定的壓力面和吸力面上的壓力分佈或速度分佈條件下,直接得到葉片的幾何形狀,它可以使葉型型面與表面氣流參數有機結起來;其不足之處在於,對設計者而言,很難給定理想的葉片表面壓力分佈或速度分佈,並且有時會得到一個非物理解,如:得出的初始葉型可能會出現前緣、尾緣不封閉的現象。
  3. The sixth section gives the experimental results in the quasi - steady flow around the caudal fin and mimic the forward swimming using the caudal fin as the propulsor. and then review the speed and track of the robotic fish swimming when locomotion parameters are set in the experiment condition

    第六部分通過機器魚的自主游動實驗,初步模擬了機器魚利用尾鰭擺動推進前進,考察了實驗條件下設定魚的尾鰭擺動相關參數的情況下魚的游動速度和尾鰭的擺動軌跡情況。
  4. A quasi - counterflow plate heat exchanger with hexagonal dividing plates is proposed for indirect heat exchange and evaporative cooling. numerical simulation is used to analyze three - dimensional flow and heat transfer processes

    採用三維流動與換熱的數值計算方法對換熱器內傳熱過程的影響因素和機理進行了模擬研究。
  5. The main research outcomes were as follows : ( 1 ) the paper applied quasi - three dimensional design model and optimization design model based on si flow surface that was effected by runner ( impeller ) and guide vane jointly. the vortex flow, blade thickness limitation and runner ( impeller ) blade force functions were taken into account. the paper got the improved runners of hl240 type, which were runner hlx240d and runner hlx240e

    主要成果有: ( 1 )應用考慮轉輪來流有旋、葉片有限厚及轉輪(葉輪)葉片力作用的轉輪(葉輪)與導葉聯合作用的基於s _ 1流面的準三維設計模型和優化設計模型,研究出了hl240的改進型轉輪: hlx240d和hlx240e 。
  6. The verification of the algorithm is performed using a gauss - distributed concentration ball and a stock wave at steady flow in an open channel. the comparison with an analytical problem solution shows that the precision and the stability of quasi - consistence hexahedral element method is as good as that of consistence hexahedral element method, better than that of the linear interpolating function method

    6 、比較分析了網格布置形式對圓管流動和臺階突擴流動計算結果的影響后表明,應在物理量梯度變化較大的區域適當加密網格,才能較好地模擬這些區域的流動特性以及壁面對整個流動的影響。
  7. Firstly, based on the present research all over the world, a 3d quasi - single phase model is built together with k - equations. the special feature of this model is taking account of the influence of interaction between liquid and gas, that is to say, the influence of interphase drag force, lifting force perpendicular to the relative velocity, virtual mass force and gas or liquid volume fraction in the fluid field have been considered. a 3d two - fluid model is also built in order to describe more accurately the fluid flow on distillation trays by comparing the computational results of quasi - single phase mathematical model with of two - fluid mathematical model

    本文在國內外已有的研究基礎上,首先建立了以k - (封閉模型為基礎的三維擬單相流模型,該模型的特點在於充分考慮了氣液兩相間相互作用的影響,即計入了相間曳力、橫向升力、虛擬質量力和氣、液相含率對流場的影響;並建立了塔板三維雙流體模型,主要目的是通過對比擬單相流數學模型、雙流體數學模型的計算結果,建立能夠準確描述塔板上流體流動的數學模型。
  8. The flow equations are solved using finite difference technique. using body - fitted curvilinear coordinate system treated the boundary conditions. by iteratively solving the flow governing equation and the blade equation, the design of axial flow pump impeller in the quasi - three - dimensional rotational flow can be performed according to the angular momentum distribution, the blade which was designed in the lifting method, flow channel and the blade thickness given

    其次在流動無粘性、不可壓及考慮葉片厚度的條件下,依據葉輪內的流動特性,推導了葉輪內三維流動周向平均流動控制方程以及葉片方程;在貼體坐標系中,採用有限差分法求解流動方程和葉片方程;在採用升力法設計出的葉片作為初始葉片、給定葉片速度矩分佈、葉片厚度分佈和葉輪軸面流道幾何形狀條件下,迭代求解流動控制方程及葉片方程,實現了軸流泵葉輪的準三維方法設計。
  9. In the thesis, the design method of the diagonal flow fan impeller has detailedly researched different from the previous means borrowing and extending design methods for axial flow or centrifugal type, a complete design method has presented on the basis of quasi - three dimensional design idea. the course is mainly composed of such steps as meridional surface design, inverse problem computation in meridional surface, blade shaping on stream surface, and verifying through three dimensional computation, until the design requirement is met at last

    不同於以往的軸流式或離心式延長設計方法或經驗方法,本文按照準三元設計的思路給出了一套完整的設計方法,即子午面設計?子午面反問題計算?斜流流面上葉片造型?三維計算驗證優化,直至符合設計目標。
  10. Measurement of intake flowrate of ice with quasi - steady flow method

    準定常流法測量內燃機脈動進氣的瞬時流量
  11. With this axial symmetric quasi - 3d model, the gas - flow field in such a wedge - shape air - gap is studied, the phenomena about taylor vortex in such a narrow wedge - shape air - gap is illuminated and the so caused gas - flow in axial direction is explained

    採用準三維軸對稱的計算模型,對楔形氣隙的流場進行了研究,驗證了高速旋轉情況下,環形間隙流場中充滿taylor渦流的現象及相關規律。
  12. The purpose of this paper is to present a numerical methodology for simulating the flow of shock tunnel. the numerical approach uses a maccormack scheme or s - w spiliter for the quasi - one - dimensional euler equation coupled with real gas effect. a simple method is used to track contact discontinuities

    採用maccormack格式及s - w分裂方法求解準一維euler方程,考慮高溫下分子的振動、氣體和壁面間的摩擦和傳熱,根據高壓段的氣體質量守恆的方法來跟蹤接觸間斷。
  13. Then numerical experiments on forcing dissipation and heating response of dipole ( unipole ) are carried out using global spectral model of quasi - geostrophic barotropic vorticity equation. for every experiment model integration is run for 90 days on the condition of three waves quasi - resonance. the results are given as follows : ( 1 ) under the effects of basic flow intensity and dipole ( unipole ) forcing source, there exist strong interaction among the three planetary waves, and there also exist quasi - two - week and intra - seasonal oscillation of the three planetary waves

    然後,用數值試驗的方法,應用強迫耗散準地轉正壓渦度方程的全球譜模式,並在方程中考慮了偶(單)極子的熱力強迫作用,在三個行星波準共振的條件下,模式共積分90d ,得出: ( 1 )在基本氣流強度和偶(單)極強迫熱源的共同作用下,三個行星波之間存在很強的波?波相互作用,且波動振蕩呈現準雙周和季節內振蕩。
  14. Compared with the results of quasi - static, it was found that the flow stress evidently increased under the high strain rate

    與復合材料在準靜態壓縮下的變形行為相比,復合材料高應變率流變應力有較大提高。
  15. The next large block of lectures covers quasi - one - dimensional flow, followed by a discussion of disturbances and unsteady flows

    接下主要內容介紹了準一維流動,接著討論擾動流與非穩態流。
  16. Characteristics of present land subsidence models in china were as follows : ( 1 ) flow models were quasi - three dimensional models ; ( 2 ) parameters in models were constants ; ( 3 ) subsidence models were linear elastic models ; ( 4 ) couple of flow model and subsidence model had two steps

    摘要我國現有模型有下列特點:水流模型都是準三維模型,模型中的參數都是常數,沉降模型採用線彈性模型,水流模型和沉降模型的耦合分二步進行。
  17. The gas - flow in the annular cross section is study, and it is clarified that in such a physical model when rotor is rotating at high speed, the nature - flow is restrained by rotating - flow, so the actual 3d gas - flow field in the wedge - shape air - gap can be simplified to an axial symmetric quasi - 3d gas - flow field

    通過對環形橫截面內二維氣隙流場的研究,說明在本文研究問題中,旋轉流對自然流具有強烈的抑制作用,從而將實際上的三維流場簡化為軸對稱準三維流場進行研究。
  18. Sloan 13 gave an example to explain some shortages of a single - valued storage - discharge function q asb 14 by applying this model in a river basin. the single - valued stor - age - discharge models are usually called steady or quasi - steady models. one of the most widely used models which includes a quasi - steady state represen - tation of subsurface flow is topmodel 15 19

    Sloan 13具體舉例說明一種典型的穩定狀態下的地下徑流機制q asb 14以及應用廣泛的「擬穩定」狀態下的topmodel 15 19機制在這個方面模擬的缺陷性
  19. Firstly, acoustic waves propagation in id quasi - periodic system is studied by means of the transfer matrix method. the transmission rate, reflection rate, energy flow, logarithmic energy flow, energy density and lyapunov exponent are obtained numerically. we explain all these parameters " relations with frequency and the size of system, and compare these p arameters with those o f periodic system. we find that these parameters are fractal in this quasi - period system

    通過轉移矩陣的方法,數值地得到了系統的傳播系數t _ n 、反射系數r _ n ,能流密度j _ n 、能量密度e _ n 、李雅譜諾大指數_ n ,給出了以上各量與系統大小n以及頻率之間的關系,發現這些量存在著與周期系統不同的準周期性質,其能量會出現局域化現象,能流以及能量密度都具有分形結構,給出了相應的理論解釋。
  20. To know well the behavior of three - dimensional steam flow and heat transfer in the condenser, a quasi three - dimensional program is adopted to numerically analyse the steam flow field and heat transfer performance of a two - pass power plant condenser numerically

    摘要為了掌握大型電站凝汽器的三維汽相流動與傳熱特性,採用一種準三維數值計算方法對一臺雙流程凝汽器的汽相流動與傳熱特性進行了計算與分析。
分享友人