radial crack 中文意思是什麼
radial crack
解釋
放射裂隙-
Scattering of sh - wave by a radial collinear crack at the edge of arbitrary - shape - cavity in isotropy media is studied. the solution of dsif at crack tips is obtained
研究了各向同性介質中任意形孔邊徑向裂紋對sh波的散射，求解了裂紋尖端的動應力強度因子。 -
The method of crack - division is used to make radial cracks at the edge of cavity. a series of integral equations for determining the dsif at tips of anti - plane crack are set up in terms of the green ' s function
按「契合」的方式和採用裂紋切割技術構造出孔邊徑向界面裂紋對sh波散射的模型，利用green函數建立直接求解m型裂紋尖端動應力強度因子的定解積分方程組。 -
Numeral results of dsif at radial crack tips of ellipse and square cavities are provided. then the influences of different shape cavities upon the dsif at the crack of their edges are discussed. 5. scattering of sh - wave by a radial interface crack at the edge of arbitrary - shape - cavity is studied
給出了橢圓孔和方孔孔邊徑向界面裂紋尖端動應力強度因子的數值結果，討論了在不同形狀孔、不同入射波數、不同入射角和不同材料常數組合情況下孔邊徑向界面裂紋尖端動應力強度因子變化的規律。 -
4. combined with the design of the three gorges prestressed concrete penstock with steel liner in the three gorges power. station, the consistence among the results of theory calculating, the analysis of plane finite element and three dimensional finite element is proved, the concrete stress distributions of the prestressed concrete penstock are analyzed with different steel liner thicknesses, different crack resistances, different concrete thicknesses and different initial radial gaps between steel liner and concrete. the feasibility of the design method of prestressed concrete penstock with steel liner is proved
結合三峽電站鋼襯預應力混凝土聯合受力壓力管道的設計方案選擇及論證分析，對比分析了鋼襯預應力混凝土壓力管道理論計算、平面有限元和管壩整體三維有限元分析結果的一致性，確定了管道結構在不同鋼襯厚度、不同抗裂度要求、不同外包混凝土厚度及不同鋼襯與管壁混凝土間初始徑向間隙等因素影響下的內力分佈規律，驗證了鋼襯預應力混凝土壓力管道的設計方法。 -
" second, jhe failure process of lpg vessel usually includes two phasest the crack formation and the crack propagation. after the temperatat field distribution and the iil. stress field distribution of lpg vessel without cracks are calculated, the stress intensity factor of lpg vessel with initial radial crack as well as surface crack are calculated and analyzed
其次，液化氣容器的失效過程通常分為裂紋形成和裂紋擴展兩個階段，本文在對無裂紋液化氣容器的瞬態溫度場和應力場進行了計算后，對含有初始表面裂紋的液化氣容器的瞬態應力強度因子進行了計算和分析。
分享友人