radius of trailing edge 中文意思是什麼

radius of trailing edge 解釋
隨邊半徑
  • radius : n (pl radii )1 半徑;半徑范圍。2 【解剖學】橈骨。3 (車輪的)輻;【物理學】輻射線;【無線電】徑...
  • of : OF =Old French 古法語。
  • trailing : 被拖動的
  • edge : n 1 刀口,(刀)刃;鋒;端;銳利。2 邊,棱,邊緣,邊界,界線,界限。3 優勢,優越條件。4 (聲調、...
  1. Abstract : the effects of airfoil geometric parameters on wing " s spacial and polarized scattering characteristics have been systematically revealed. the results of the study indicated that the calculating value of diffraction from trailing edge by using the formula of the straight wedge is very far from experimental results for vertical polarization, and the contribution of thickness of the trailing edge to scattering must be considered in the calculation. the scattering peak of leading edge depends only on radius of airfoil for horizontal polarization. but for vertical polarization, it depends on maximum thickness and the location of maximum thickness. engineering formulas for evaluating all scattering peaks were given in the paper. it is important for the design of low - rcs wing

    文摘:系統地揭示了翼形幾何參數對機翼的空間散射特性、極化散射特性的影響規律.研究發現,在垂直極化狀態下用理論尖劈公式計算機翼后緣繞射的計算結果與實驗結果相差甚遠.提出在垂直極化狀態下機翼后緣繞射的計算必須將后緣厚度考慮在內的見解.對於水平極化,前緣散射波峰只與前緣半徑有關;而對於垂直極化,前緣散射波峰與翼形最大厚度以及最大厚度位置有關.給出前後緣散射波峰的工程估算公式,為低雷達散射截面( rcs )機翼設計提供依據
  2. The experimental results show that the distribution of the radial static pressure behind the model cascade can be controlled by changing the diameter, number and distribution of the holes at different radius of the full circled backboard with the holes properly , and the experiments variable enthalpy drop in the model cascade can be realized by using out - circled backboard or in - circled backboard which are set on the different distances from the trailing edge of the model cascade

    實驗結果表明,適當選擇全環鉆孔擋板不同半徑處的鉆孔率、鉆孔直徑與分佈,可調節靜葉后徑向靜壓分佈,採用外環或內環擋板,並將其分別置於靜葉的近、中、遠下游,可實現靜葉柵的變焓降實驗。
  3. The loading of the engine will be lowed and the revolution will be raised at the same time. it is effective when the propeller trailing edge cutting is performed outer radius

    因為在0 . 5r以外作隨邊切割方式有較佳的效果,所以本文決定採用在螺旋槳外半徑處作非線性的隨邊切割方式。
分享友人