reduction in strength 中文意思是什麼
reduction in strength
解釋
強度下降-
The bisection method applied in strength reduction method of bearing capacity of foundation
二分法在確定地基承載力的強度折減法中的應用 -
A layer of hot-dipped galvanizing causes a considerable reduction in the fatigue strength.
熱浸鍍鋅層引起疲勞強度的顯著降低。 -
An increase in muscle strength occurring weeks after dose reduction usually indicates steroid - induced myopathy
類固醇減量后數周肌力改善常提示類固醇肌病。 -
Having reacted with copper, paa becomes complex. the complex decomposes after heat treating and cause the increase in dielectric constant and reduction in dielectric breakdown strength. otherwise cu2o and cuo emerge from the complex, too
N與cu反應后，形成絡合物，熱處理時自身降解，擊穿強度降低，介電常數提高； cz在熱處理后從絡合物離解出來形成cllo和cuzo 。 -
Based on extensive investigation of construction technique history of chinese ancient buildings, the structure method, structure developing history and seismic behavior of chinese ancient timber structure buildings are analyzed in several respects of the structural system and form. through a series of experiments on constituent parts of chinese ancient timber building structure, including the tests on the corbels and brackets called dougong subjected to low cyclic reversed loadings, the tests on the wooden frame using the tenon - mortise joints as connections of column and beam subjected to low cyclic reversed loadings, the tests on vibration isolation effect of friction and slippage between column footing and their socle base, and a series of shaking table tests on a chinese ancient timber structure palace building mode under artificial earthquake at serving conditions, destroyed conditions and reinforced conditions, many valuable results of structures such as moment - curvature hysteretic loops of dougong structure and tenon - mortise joints under low cyckc reversed loadings, the static function, the seismic performance, energy dissipation, vibration reduction, energy - loss mechanism, nechanicalmode and failure mode were studied. aplenty of valuable parameters of the structure system were obtained, such as the natural period of structure, vibration modes, damping ratio, factor of vibration isolation, oscillate amplitude of ineitial accebration, velocity and displacement, magnitude of slippage, and the mechanism of structure failure and collapse etc. based on these research, the complete analysis of ancient timber structure under earthquake were carried out in which including mechanism analysis method, calculating mode, strength analysis of members and joints, strengthening methods for serving damaged ancient timber structure buildings were also taken into account
依照宋代《營造法式》建造了抬梁式殿堂木結構構件及結構模型，對中國古代木結構中的典型構造如：柱腳在礎石頂面平擱簡支、柱架榫卯連接、柱高不越間之廣、側腳、生起、斗拱等的構造機理及結構功能進行了量化分析和實驗研究： （一）通過木柱石礎靜摩擦試驗，測定了柱腳與石礎古鏡面間的摩擦系數及摩擦力隨上部結構荷載變化的規律； （二）通過單柱承載力試驗，測定了古建築中木柱的受力變形特徵、破壞模式、及模型材料的變形模量、極限承載力、極限變形等參量； （三）通過柱架低周反復荷載試驗，測定了柱架的抗側移剛度、柱架恢復力特性及滯回曲線、榫卯張角剛度及其變化規律、柱架及榫卯的極限承載力和極限變形、及榫卯減振參數； （四）通過斗?低周反復荷載試驗和受壓試驗，測定了古建築木構件與木構件間摩擦系數，斗?抗側移剛度，斗?恢復力特性及滯回曲線，斗?抗壓極限承載力及受力變形規律； （五）通過抬梁式殿堂間架模型振動臺試驗，測定了殿堂木構架結構自振周期，地震反應振形、阻尼特性及阻尼比；按結構分層特點對柱腳、柱頭和斗?層上的屋蓋的地震反應採用多點同步測量，對柱根滑移、榫卯變形、斗?的變形、復位、耗能減振參數等進行了定量分析。 -
According to roof safety factor of 1. 2 for the mined - out area, minimum safety roof thickness at different rock in various span mined - out area was calculated by flac software, which transfixion of plastic zone was taken as criteria of roof breakage by using strength reduction technology and dichotomy theory
摘要利用強度折減技術和二分法原理，以塑性區的貫通作為頂板破壞的標準，當采空區頂板的安全系數等於1 . 2時，利用flac軟體計算得出各種跨度空區在不同巖層中的最小安全頂板厚度。 -
The binding principle in pelletizing covers a comprehensive model of interfacial reaction among particles inside green pellets, the formation of binding film during hardening of green pellets by baking to obtain enough strength for a volumetric catalyzed reduction model for cold - bound pellets bearing composite binder and corresponding high temperature reduction system in rotary kiln
提出了含復合粘結劑的生球強度界面作用力綜合模型，冷固球團礦強度的粘結膜機理，含復合粘結劑的冷固球團礦催化還原體積反應機制及全窯高溫快速還原熱工制度。 -
Available empirical results indicate that the creep of reinforcement strongly influences the overall behavior of rs structures, which is demonstrated by excessive deformations. different creep tests are discussed and the test methods to obtain the two kinds of creep curves are compared in this thesis. the methods of how to determine the reduction factor according to long - term strength of creep or allowable strain during the services life are presented
文中介紹和研究了不同的蠕變試驗手段，比較了獲得兩種蠕變曲線的試驗方法，並給出了兩種蠕變曲線一定范圍外推的數據處理方法;給出怎樣根據設計使用年限的長期蠕變強度或容許應變來確定蠕變折減系數的方法，並用計算實例來說明。 -
Ep - red will not give complete iron reduction in 24 % or higher hydrochloric acid strength. it is likely to be ineffective in preventing iron induced sludging if 28 % acid is required
當鹽酸濃度高過24 %時， ep - red將不能發揮完全的降鐵作用。當使用28 %濃度酸時，它已對降低鐵渣失效。 -
Abstract : it is the first time to use powder damping technique in reducing the vibration and noise of cold saw clamp. through measurement and analysls of the noise reduction effects and frequency spectrum, it is found that powder damping is a simple and practical technique, and influences on the strength and natural characteristics of the clamp are small
文摘:把粉體阻尼技術首次用於冷鋸機夾盤的減振降噪，通過對其降噪效果及頻譜的測量分析，發現粉體阻尼不但是一種簡單實用的技術而且對夾盤的強度和固有特性影響小。 -
The mechanical parameters at high temperatures - reduction in area ( ra % ) and tensile strength ( o b ) are measured by means of gleeble - 2000 thermal simulating machine. fracture surfaces are analyzed by scanning electron microscopy and optical microscopy. the segregation of sn is also examined by auger electron spectroscopy
通過測定試驗鋼種的高溫力學參數（斷面收縮率ra和抗拉強度_ b ） ，觀察金相顯微組織，分析掃描斷口形貌，測試第二相析出物和俄歇能譜試驗等方法，研究了殘留元素sn及冷卻速率對高溫力學性能的影響。 -
At last, it discusses the method of designing the spandrel beams properly, including the reduction of spandrel - beam - torque and the flexural strength ratio between columns and beams. results from the tests show that the effect of secondary torque, especially the anti - symmetry, exists in the structure during the whole testing
試驗結果表明，預應力次扭矩對結構受力的影響，存在於整個受力階段，其對結構受力的反對稱效應是比較明確的，尤其對邊主梁的受扭影響。 -
The conclusions are as follows : ( 1 ) high - pressure water - atomization can be used to produce a pre - alloyed steel powder with high apparent density, high green strength, size - stability after sintering and low hydrogen - loss content ; ( 2 ) the higher smelting temperature and / or water pressure, the finer particle size of steel powders ; ( 3 ) when the atomization angle holds in a reasonable value ' s range the obtained powder will have a better particle size distribution ; ( 4 ) an optimum atomization technological parameters : liquid steel flux, water pressure and water prick angle was obtained ( 5 ) reduction variables ( temperature, holding time, material - bed ' s thickness and reducing gas flux ) have a significant effect on the particle agglomeration and properties of final powder was given ( 6 ) different alloying methods were developed to modify properties of ferrous powder materials and hence to broaden its applications in ferrous powder metallurgy industry
本文系統研究了水霧化預合金鋼粉生產工藝及合金化方法對鐵基粉末冶金材料性能影響，詳細研究了冶煉、霧化、還原工藝參數對預合金鋼粉化學成份和物理性能影響，並得出如下結論： （ 1 ）採用高壓水霧化技術可用於生產高密度、高強度、尺寸穩定性的低氫損含量的水霧化預合金鋼粉。 （ 2 ）冶煉溫度越高，高壓水壓力越大，所得生粉顆粒粒度越細。 （ 3 ）水錐角調整在一個適當角度范圍內可獲得粒度組成較好的生粉。 -
Based on the comprehensive statistical analysis of inelastic displacement ratios, the regression equations of - r - t about the strength reduction coefficient and inelastic displacement ratios are obtained. the effects of soil condition, earthquake magnitude, epicenter distance, damp ratios and hysteretic characteristics are considered in detail
通過對理想雙線性體系的均值彈塑性位移比與強度折減系數進行了統計分析與數值擬合，建立了兩大類場地土（硬土、軟土）下的- r - t回歸公式。 -
The results show that improving the rolling velocity and reducing the galvanizing time will result in reduction of strength loss after galvanizing, and increase of bend torsion valve, thus productivity is improved
結果表明：提高收線速度，減少浸鋅時間，鍍后強度損失減小，彎扭值提高，生產效率提高。 -
In this paper, a new method, numerical manifold method, is introduced, and applications of adaptive fem, incremental elastoplastic theory and shear strength reduction technique are on second thoughts
首先，基於數值流形方法和有限覆蓋技術，提出了適用於biot固結分析的三節點、四節點平面協調流形元。 -
It was also demonstrated that rosin in hybrid polymer functioned as a plasticizer to reduce glass transition temperature, which resulted in the reduction of strength and increase of elongation of polymer films
力學性能分析顯示歧化松香在雜合物中起到了增塑劑的作用，降低了聚合物的玻璃化轉變溫度，使得斷裂應力下降而斷裂伸長率有所增長。 -
The increase of zinc stearate and calaiurn strarate ' s content is propitious to the material processing, usually causes reduction material ' s mechanics performance, when the content of the latter in material exceed 2. 5, it can make the impacting strength has a tendency of ascend, but it ' s influence on other performance is not large
硬脂酸鋅和硬脂酸鈣的含量增加有利於材料的加工，通常導致材料的力學性能降低，後者在材料中的含量超過2 . 5份時會使沖擊強度呈現升高趨勢，但對其它性能的影響不大。 -
In addition to the rotation associated with the reduction in the strength of the diffraction lens there can also be an inversion between the diffraction pattern and the corresponding micrograph
除了通過衍射透鏡磁力縮減取得的旋轉，還可以有一種衍射模型和對應的顯微圖之間的倒置。 -
This mode of damage is essentially analyzed with a simple static approach by comparing post - earthquake residual strength of sand with initial stress due to gravity. the other involves limited, but often large, amount of deformation due to significant reduction in soil stiffness but without involving mechanism of failure in soil
一種為飽和砂土的強度的降低而導致的完全流動破壞；另一種為不涉及土體的破壞機理，但由於土體勁度的降低而產生有限的大變形，稱為循環活動性。
分享友人