redundancy technology 中文意思是什麼

redundancy technology 解釋
冗餘技術
  • redundancy : 裁員，多餘；冗餘
  • technology : n. 1. 技術，工程，工藝。2. 製造學，工藝學。3. 術語（匯編）。
  1. The method that absorb return circuit design used in power design and electromagnetic valve drive circuit, system power and operating supervision to mcu and redundancy and digital filter technology to the time interval to send wave and echo are used in system design to ensure the reliability and accuracy of measure and control system

    本系統在電源設計、電磁閥驅動電路中的吸收迴路設計、系統主電源和訛u運行監控以及採集的對發射波與回波時間間隔數據採用的冗餘技術和數字濾波措施，保證了測控系統的可靠性和精確性。
  2. The paper studies the project of improving the reliability of flight control computer by using the dual cpu hot - redundancy technology

    本文主要對利用雙機熱備份技術來提高飛控計算機可靠性這一方案進行了前期研究。
  3. The method can be used for many flight control computers easily. the dual cpu hot - redundancy technology became a method to improve the reliability of flight control computer

    該方法實施簡單，易移植和工程化，具有較好的通用性，為提高飛控計算機可靠性提供了一種途徑。
  4. We implement the dual cpu hot - redundancy technology into the common uav which used pc / 104 in our country. the reliability of flight control computer can be improved rapidly only if we increase a little hardware and software by the dual cpu hot - redundancy technology

    該技術在我國無人機普遍使用的pc 104體系結構作為平臺的飛控計算機上實施，只需增加少量的硬體資源和軟體模塊就可以大大提高飛控計算機的可靠性。
  5. Focusing on the flight control computer system of some type of airplane, this paper first analyzes the advantage and disadvantage of the structures of many kinds of fault tolerant flight control computer systems and their ability in tolerating fault, followed by summarizing the key design technology. the dual similar redundancy fault tolerant computer system is brought forward as the design scheme for the required flight control computer. also brought forward is the particular system design

    本文以某型號飛機飛控計算機系統為研究對象，首先分析了各種類型容錯飛控計算機體系結構的優缺點及容錯能力，總結了容錯計算機系統設計的關鍵技術，然後提出了二模相似余度容錯飛控計算機系統設計方案，詳細設計了以motorola公司生產的先進powerpc740微處理器為核心處理器、以高性能的國際標準化通用vme總線為內總線的交叉通道通信容錯計算機系統。
  6. Provide reliability and security. parallel servers, hardware redundancy, fail - safe technology, information encryption, and firewalls can enhance this requirement

    提供可靠性和安全。并行服務系統，硬體冗餘，故障自動保險的技術，信息加密，並且防火墻都可能會提高對這方面的要求。
  7. This paper based on the hj04a railway signal computer system which is developed by the research institute of microcomputer, hefei university of technology. according to requirement of the interlocking software " s reliability and safety. considered with the software requirement analysis, combining the uml and z, we finally design the interlocking software specification which is completeness, consistency, no redundancy, no different meanings and is consistent with the demand of the system

    本論文針對合肥工大微型計算機應用研究所研究開發的hj04a鐵路信號計算機聯鎖系統，根據計算機聯鎖系統聯鎖軟體設計可靠性和安全性要求，從軟體的需求分析著手，綜合uml統一建模語言方法和形式化描述語言z語言的方法，設計出完全的、一致的、無冗餘的、無歧義的、符合系統要求的聯鎖軟體規格說明書。
  8. The e - government architecture project will carry out two major concurrent activities. one of the activities will be the development of a architecture, toward the development of enterprise architecture, for each of the current e - government initiatives, as well as a core set of standardized technology models to facilitate technology solutions. the second activity will be the collection and analysis of business and data architecture information across the government to identify new opportunities for e - government initiatives and elimination of redundancy. including : 1

    本文通過對電子政務工程規劃的研究，得出電子政務工程規劃應叢兩個方面進行推進，一是建立完善政府與社會、政府部門之間系統結構，建立一套核心的技術標準來推動技術上難題的解決；二是收集分析政府政務流程，進行機構改革，減少不必要的環節，行政人員能夠更輕松、更高效完成工作。
  9. Based on infrared scanning technology ; redundancy circuit design ; high stability and reliability

    基於紅外線掃描技術，冗餘電路設計，具有高穩定性高可靠性
  10. The project originating from national high technology research development plan ( 863 plan ) is to study a control system of 270 voltages dual - redundancy rare earth permanent magnet ( repm ) brushless dc motor ( bldcm ) based on digital signals processor ( dsp ) in order to realize precise and reliable control for the control actuator of high altitude unmanned airplane

    本課題來源於國家高技術研究發展計劃（ 863計劃） ，旨在研究基於數字信號處理器（ dsp控制器）的舵機用270v高壓雙余度稀土永磁無刷直流電動機控制系統，以實現無人飛行平臺飛控系統的精確可靠控制。
  11. In order to solve such problem, the raid array that adopt redundancy technology appears

    為了解決這一問題，出現了採用冗餘技術構造的raid （ redundantarrayofindependentdisks獨立磁盤冗餘陣列）陣列。
  12. Abstract : constant components and output opened ports in the result of high - level synthesis lead to explicit redundancy in gate - level technology mapping. explicit redundancy can not improve the performance, but increases power consumption, enlarges circuit area and decreases its testability, so it should be removed. this paper proposes a queue loop optimization algorithm to remove explicit redundancy completely which decreases the circuit area and improves the testability

    文摘:高級綜合結果中常量元件和輸出懸空埠導致門級工藝映射結果中存在顯式冗餘.顯式冗餘無助於提高電路性能，反而增加功耗，降低電路的可測試性，使電路面積增大，應予消除.文中提出了顯式冗餘的隊列循環優化演算法，完全消除了此類冗餘，從而有效地減少了生成電路的基片面積，提高了電路的可測試性
  13. Parallel inverters can expand capacity and realize redundancy in power supply system, so they are now considered as one of the most important part in the field of inverter technology

    多臺逆變器並聯可實現大容量供電和冗餘供電，因而被公認為當今逆變技術發展的重要方向之一。
  14. In this thesis, can bus is used as the system bus, concentrating the research on the feasibility of using redundancy can bus technology in large - scale motor vehicle safety performance detecting & control system. this thesis first gives an overall design of the data collection and control system applied to the front end of a large - scale motor vehicle safety performance detecting & control system. regarding that the bus controller, bus driver and bus transfer medium would fail to function easily, the dual mode cold - redundancy structure is adopted in system to ensure the reliability

    本文採用can總線作為系統總線，重點研究冗餘can總線技術應用於大型機動車安全性能測控系統的可行性並進行驗證:首先對基於冗餘can總線的機動車安全性能測控系統的前端數據採集與控制系統進行了總體設計，考慮到總線控制器、總線驅動器和總線介質都是容易出故障的部件，系統採用了二模冷冗餘結構來保障can總線通訊的可靠進行;其次，根據系統需要，設計了基於c8051f021的帶冗餘can總線通道的數據採集與控制模塊，用於採集與處理檢測現場的模擬信號和數字信號，並自行開發了can總線應用層協議以及應用軟體，通過冗餘can總線實現與上位機的可靠通訊;然後，為了驗證冗餘can總線設計方案的可行性，搭建試驗平臺並進行can總線故障切換的試驗;最後對課題的研究工作進行了總結與展望。
  15. This method can use redundancy technology suitably, and also can construct a higher reliable cbs with the lower cost. at the end of this thesis, reliability and capacity - price ratio are used to evaluate every construct method

    該方法從軟體可靠性角度出發，合理使用冗餘技術，以較低的精力和成本來構建一個高可靠的基於組件的軟體系統。
  16. With the requirement of real - time embedded application, a series of memory management technology to improve safety and reliability for embedded system are proposed and implemented in the thesis, including memory leak detection and collection, memory redundancy allocation, memory redundancy encoding and memory protection, then the key technology of these is researched and implemented at first, a systematic survey of research in the domain of embedded real - time and memory management is given, including the concept of real - time embedded system, the research status and tendency of real - time embedded system, the characteristic of memory model and memory management in real - time embedded system

    本文面向嵌入式實時應用需求，提出並實現了一系列有助於提高系統安全性和可靠性的內存管理技術解決方法，包括:基於slab的動態內存分配、回收、內存內存寫越界判斷技術，並對其實現技術展開較為深入的研究。本文首先介紹嵌入式實時系統和內存管理技術，包括嵌入式實時系統的概念，國內外的研究現狀和研究方向，嵌入式實時系統中內存模式和內存管理的特點，並在此基礎上提出本文的研究目標和研究內容。
  17. The essay mainly researches on the technologies that composed of computer networking systems based on the stratus technology thery ; it detailedly introduces the stratus technology, the components of computer network system and fulfillment technologies for the key devices, redundancy designs, twin online backups and cluster technologies ; also particularly, it presents the building models and building processes for the computer networking system on both hardware and software hands ; it describes the designing and building procedures of its local area network by showing us the real situation of harbin red - cross blood bank

    文中詳細介紹了容錯技術的內容、計算機網路系統的組成部分和關鍵設備、冗餘設計、雙機熱備和集群技術等實現技術。重點從軟體和硬體兩方面闡述了計算機網路系統的構建模型和構建過程。描述了結合哈爾濱紅十字中心血站的實際情況，完成了其計算機局域網路的設計和實現的過程。
  18. ( 2 ) it adopts rodo model based on performance index to calculate the redundancy of instances, and this means can make tradeoff between user ' s performance and availability demands effectively. ( 3 ) form the viewpoint of system performance and availability, acms adopts mobile - agent technology to adjust system configuration in running time, improves system ' s dynamic scalability and resource utilization ratio on condition of guaranteeing the system availability

    從用戶角度出發，採用基於性能索引的rodo模型確定服務實例的冗餘度，有效地權衡了客戶對系統性能和可用性的需求；結合可用性和性能兩項指標，採用基於移動代理的配置管理策略對系統進行動態配置，在保證可用性的前提下，改善了系統性能，提高了資源利用率。
  19. In current network applications, c / s modal is the mainstream. but with the quick development of the distribute computing and new network technology, more and more people focus their attention on p2p modal in recent days. the main difference between p2p modal and c / s modal is that the former does n ' t rely on a server, thus control is distribute. some modals of p2p even do n ' t require a server. the p2p modal has excellent redundancy. no single fault point in p2p modal. p2p modal can be a good complementarity of c / s modal. and of course, as a new technology, p2p modal is not maturate. it even has n ' t a standard protocol till now

    而隨著分散式計算的深化和網路技術的進一步發展，對等式網路模型（ p2p ）開始受到重視，並成為最近的技術熱點之一。 p2p模型與c s模型相比，最大的不同是降低了對服務器的依賴及其分散控制，一些p2p模型甚至不需要服務器。 p2p系統的冗餘性很好，沒有單一的失敗點。
  20. According to the requirement of industrial network, the scheduling of real - time traffic, network management, control strategy and test method of industrial ethernet were discussed combining traditional ethernet technology and switching technology in this thesis. we analyzed the analyzed the redundancy design and provided the ideal system design of industrial ethernet. the main content of this thesis is listed as follows : 1

    本文根據工業網路的要求，結合傳統以太網技術、交換技術等，研究了工業以太網的控制策略、測試方法、實時調度、網路管理和系統設計等技術問題，分析了工業以太網的冗餘設計，提出了理想的工業以太網理想解決方案。
分享友人
分享到 Line

分享到臉書