residual path 中文意思是什麼
residual path
解釋
余留通道-
In the leach - new protocol, the mainly improvement of the leach protocol exhibits as follow : for the sake of balancing the network load, the network choose the clusters based on the residual energy ; we take multi - hop communication between sensors instead of single - hop communication, which results in the reduction of energy consumption of clusters ; the new protocol finds the path to the cluster head with the minimum cost, using an algorithm similar to flooding to propagate the cost information and greedy algorithm to find the lowest cost link ; the algorithm for assigning tdma time slot reduces overall delays of network
在leach - new協議中，對leach協議的改進主要體現在以下幾個方面:根據節點剩餘能量選擇簇頭，以平衡網路負載;節點間採用多跳路由，降低簇頭能量消耗;節點根據能量消耗的代價來選擇至簇頭的路由，通過擴散演算法來廣播代價消息，採用貪婪演算法來選擇能量消耗最小的路徑;採用tdma時隙分配演算法減少網路時延。最後，利用ns2模擬軟體進行驗證。 -
The orientation path and residual network were defined, the new maximum flow algorithm in network with both node and edge capacity confined was put forward based on feasible flow decompose theorem and by way of the search in artificial intelligence
定義了有向路徑和殘量網路的概念，依據可行流分解定理，引入人工智慧中搜索的方法，以鄰接矩陣為網路數據存儲結構，提出條件約束下的網路最大流新演算法。 -
Based on the relationship between the change of the cornea thickness and optical path length, the ablation profile for the correction of wavefront aberration is presented and simulated on computer. the process of scanning - spot excimer laser is studied and simulated on computer. models for calculation of residual wavefront aberration on situations of lateral decentration and torsional misalignment are brought up
使用改變光程的方法建立起波前像差與角膜切削量之間的關系，並對像差矯正模型進行計算模擬;深入研究了小光斑準分子激光飛點掃描模型，對飛點掃描過程進行計算模擬;提出了中心偏移和旋轉情況下剩餘像差計算模型，為定量研究切削中心定位精度對像差矯正的影響提供了依據。 -
Finally, the technic route for the research of milling distortion is proposed. in chapter 4, the effect of tool path and clamping schemes on residual stresses as well as machining distortion are analyzed by using three - dimensional elastic - plastic fem ( finite element method ). the distortion variation tendency under four typical tool paths, the pressing - plate clamping and stretched fixation is obtained respectively
第四章基於上述理論基礎，利用三維彈塑性有限元技術分析了走刀路徑和裝夾方案對銑削加工殘余應力分佈和變形的影響，得到了四種典型的走刀路徑以及壓板式裝夾和拉伸裝夾對加工變形的影響趨勢。
分享友人