resistance-capacitance circuit 中文意思是什麼

resistance-capacitance circuit 解釋
阻容電路
  • resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
  • capacitance : n. 【電學】電容；電容器。
  • circuit : n 1 （某一范圍的）周邊一圈；巡迴，周遊；巡迴路線[區域]；迂路。2 巡迴審判（區）；巡迴律師會。3 【...
  1. Accelerometer is used widely for measuring acceleration in civil and military field. at present, there are several type of accelerometers such as piezoelectricity electric charge accelerometer, ic piezoelectricity electric accelerometer, compressive resistance accelerometer and alteration capacitance accelerometer. the main part in alteration capacitance accelerometer is capacitance measurement circuit. foreign countries have produced accelerometer that have tiny volume and high performance. however, our country is not able to produce such accelerometer due to the lack of technique

    加速度計作為一種測量加速度的儀器，在民用、軍用領域都有廣泛的應用。目前市場上的加速度計主要有壓電式電荷加速度計、集成電路式壓電加速度計、壓阻式加速度計、變電容式加速度計等幾種類型的加速度計。變電容式加速度計的設計中一個重要的環節就是電容檢測電路的設計。
  2. Then the time constant is computed through the equation set, thus the liquor resistance and conductivity is obtained. and the expression of the conductivity ' s computation is given out. the method is verified by circuit design and establishment of experimental scheme. this method eliminate effectively the effect that the distributed capacitance put on the conductivity measurement

    並推出了電導率求解過程的全部表達式。設計電路，制定實驗方案進行實驗驗證。分析實驗結果表明，該方法有效消除引線分佈電容對電導率測量的影響。
  3. First we measured s - parameter of the device and package shell. the package shell and bonding wire are expressed with equipment circuit composed of the resistance, capacitance and inductance then acquired the value of component by optimizing using microwave emulation software ( microwave office )

    首先，測量出管殼封裝器件和管殼的s參數，把管殼和鍵合線均表示為由電容、電感、電阻組成的等效電路，再用微波模擬軟體（ microwaveoffice ）優化出元件數值。
  4. Design the good - working signal processing circuit of the sensor, including the signal collecting circuit of three output polars the coupling circuit using capacitance and resistance the alternating amplify processing circuit and the stabilization voltage supply circuit

    設計了性能良好的信號處理電路（包括銻化銦磁阻三端輸出型信號採集電路、阻容耦合型交流濾波放大電路和穩壓電源電路三個部分） 。
  5. Also, we select the signal collecting circuit of three output polars, the coupling circuit using capacitance and resistance, the alternating amplify processing circuit, the positive feedback retardation comparsion, the driving circuit of output current and the stabilization voltage supply circuit

    選擇了insb磁阻三端輸出型信號採集電路，阻容耦合型交流放大電路，正反饋遲滯型電壓比較器和大電流推挽驅動電路及穩壓電源電路。
  6. Both ends of the shield are a " floating " ground in most cases, and this creates a complex circuit network consisting of the complex impedance to ground of the output circuit at one end, the complex input circuit impedance at the other end, and the resistance, capacitance, and inductance of the cable in between

    大多數情況下屏蔽線兩端是「漂移」的接地端，這就形成了復雜的電路，這個電路的一端相對輸出端的接地點有復雜的阻抗，另一端又有復雜的輸入阻抗以及連接線的電阻，電容和電感。
  7. The results that increasing of bias current and shunted resistance and lowing critical current and connected inductance can decrease the transmission time are shown ; ( 4 ) a new type of circuit, ladder shape multiplayer jtl. structure is provided by author, thus output signal of rsfq circuits can be amplified before transfer to room temperature electronics system. it has highly gain of amplify relatively and the double peak structure are avoided through decreasing parasitic capacitance

    （ 4 ）針對目前超導與室溫介面電路的電壓放大器存在的「雙峰」和放大增益效率較低的不足，提出了一種全新的階梯式多層jtl電壓放大電路結構，較好的解決了以上的問題，通過初步的模擬分析證實，該電路的構思極負有創新性。
  8. Usually the low power operational amplifier is designed with rail to rail output stage, whose signal dynamirange is small, its output driving force is not strong, here it is designed with voltage displacement stage, and the strong driving force and the low power consumption in this circuit are achieved. with 5v single power, this amplifier consumes only several a, 100khz unity - gain frequency, achieves 80db dc open gain and 55 phase margin for a 100pf load capacitance and a 1m load resistance and other advantages

    通常設計的低功耗軌對軌輸出運算放大器中，由於信號的動態范圍比較小，它的輸出驅動能力不強，這里設計的是採用電平位移電路同時實現了電路的強驅動能力與低功耗，它具有在單電源電壓5v的條件下，靜態工作電流只有幾微安，單位增益帶寬達100k ，開環增益能達80db以上，相位裕度也能達55度，輸出源沉電流達500微安以上等優點。
  9. The mathematical and circuit analyses of the converter show that the output current of the dc - dc converter tends to be saturated with the gradually increasing product of the operation frequency and the capacitor capacitance in the case of a determinate effective loop resistance

    分別用matlab和pspice從理論和電路兩個方面進行的模擬研究都表明：在等效同路電阻一定的情況下， dc - dc變換器的輸出電流隨工作頻率和電容容量乘積的增大而趨于飽和。
  10. In this dissertation, the signal integrity problem encountered in the high speed circuit design is analyzed theoretically. both pre - simulation and post - simulation instruct layouting pcb board and comfirming the values of the resistance and capacitance

    本文對高速電路設計中遇到的信號完整性（ si ）問題作了理論性分析，並且通過布線前模擬和布線后模擬指導了pcb板的布局和布線，阻容值的選取等。
分享友人
分享到 Line

分享到臉書