rising pipe 中文意思是什麼

rising pipe 解釋
出水豎管
  • rising : adj 1 上升的;漸漸上升的(坡等)。2 上漲的;騰貴的;增大的,增加的;漲水的。3 升進的;新進的,前...
  • pipe : n 1 管,導管,筒。2 煙斗,煙袋;一袋煙。3 〈古語〉笛,管樂器;【航海】(水手長的)哨子(聲);〈p...
  1. For the purpose of solving the interconnection of the heating supply between the small high - rising building and multi - storied building, this paper advances that the pressure fixing system on the by - pass pipe should be used in the secondary network system, and probes into the pressure regulating range of the water replenishing and pressure fixing system on the by - pass pipe

    為了解決小高層和多層建築的供熱並網問題,提出了將旁通管定壓系統應用於二次網系統中,並對旁通管補水定壓系統調壓幅度進行了探討。
  2. Improvement is made on evaporation and concentration technology of saponification waste alkali liquor : exterior heating inner pipe boiling rising membrane evaporator is innovated into an exterior heating boiling forcefully recycling evaporator, and an evaporation assistant is added in the saponification waste alkali liquor

    對皂化廢堿液蒸發濃縮技術進行了改進:將外加熱式管內沸騰升膜蒸發器改造為外加熱式管外沸騰強制循環蒸發器,並在皂化廢堿液中添加蒸發助劑。
  3. The simulation shows that the valve throttle area should be little as possible but must be more than 40 % of pipe section area ; when the total length of pipe is same, and the flow quantity is enough, pipe before primary valve should be thin and long, and the pipe after primary valve should be thick and short, the upriver and downriver small pressure fluctuation will badly lead to waterdrammer pressure rising, and spending more time in establishing pressure and flow quantity

    模擬表明,閥門過流面積在滿足大於管道截面積40 %的條件下應盡可能小;在管道總長一定並滿足流量要求的條件下,主閥前應採取長而細的管道,閥后則應採用短而粗的管道;上下游微小的壓力波動都會嚴重增大開關閥門引起的水擊,並使壓力、流量的建立需要更長的時間。
  4. After dipped in amino trimethylene phosphonic acid ( atmp ) solution, anodic oxide films are annealed in pipe stove. the influences of concentration and temperature of atmp solution and annealing temperature on rising time, withstanding voltage and specific capacitance of anodic oxide films are studied. after hydration, anodic oxide films treated with atmp or not are analyzed by ft - ir

    2 .將化成箔在氨基三甲叉膦酸( atmp )溶液中浸漬,取出烘乾后再進行熱處理,研究了atmp溶液濃度、浸漬溫度和熱處理溫度對氧化膜升壓時間、比容、耐電壓的影響,找到其最佳耐水合處理工藝;採用ft - ir對水合作用后的atmp處理氧化膜和未經耐水合處理氧化膜進行了分析。
分享友人