separation wall 中文意思是什麼

separation wall 解釋
分隔墻
  • separation : n 1 分離；分類；分開。2 隔開；間隔；脫離。3 （夫婦的）分居。4 分隔物。5 【化學】離析；析出；釋出...
  • wall : n 1 墻壁；（石、磚等的）圍墻；城墻。2 （形狀、用途）像墻壁的東西，障壁；土堤，堤防。3 （礦井、容...
  1. There was no difference in other biologic characteristic of mscs between the two separation method, such as cell anchorage ratio and clone formation ratio. ( 2 ) plga film presented uniformity frame with no protuberance and fissure under scanning electron microscopy ( sem ). big aperture with smooth wall and average 400 m i n size running - through each other was observed in porous plga substrate, around the big aperture there were many round micropores about 5 m size. all of the structure were equal and uniform, which satisfied the further research work. ( 3 ) mscs adhesion at earlier time was promoted by biotiegenrafter 3h, cell number was ( 1. 5 0. 18 ) 105 in the plga film coated with biotiegen group, which was significantly higher than that in plga film group ( p < 0. 01 ) and higher than that in coverslip group ( p < 0. 05 ), which cell number was ( 1. 04 0. 21 ) 105. after 6h and 12h biotiegen could not promote cell adhesion, and cell proliferation and alkaline phosphatase ( alp ) activity were not promoted dramatically during 9 days. ( 4 ) cell adhesion was promoted by fibronectin or collagen type i

    G ） i型膠原、纖維粘連蛋白促進細胞增殖，細胞接種后3 、 6 、 gd三個檢測時間點，實驗組細胞均明顯高於對照組。與1型膠原相比，纖維粘連蛋白刺激作用更強。 ） i型膠原、纖維粘連蛋白尚能誘導mscs細胞向成骨細胞分化，不僅表達成骨細胞標志物ocn 、 alp 、 opnmrna ，而且堿性磷酸酶活性明顯增高，堿性磷酸酶及鈣結節7第四軍醫大學博士學位論文一染色均強陽性， i型膠原組mscs細胞堿性磷酸酶活性較fn組更高，有顯著性差異；同時，兔疫組化染色表明，經纖維粘連蛋白作用的mscs1型膠原表達陽性。
  2. Usually, it also causes the wall heat transfer rate to decrease somewhat in the region downstream from the point of separation.

    通常，它也會使分離點下游區間內的壁熱交換率有所減少。
  3. Widely used for large area suspended ceiling and separation of steel structure workshop, suspended ceiling, wall body and air purification room

    廣泛適用於鋼結構廠房、吊頂、墻體、空氣潔凈室的大面積吊頂與隔斷。
  4. A mathematical model of flows in the substrate was established using the equivalent continuum approach, and multi - dimensional numerical simulation of the steady flows in the catalytic converters was performed. simulation results show that the separation and vortex, which cause the pressure loss and the velocity non - uniformity at the front of the first substrate, are generated near the wall of the conical pipe. in addition, the larger the inlet cones angle the more the pressure loss and maldistribution in converters, however, when the angle enlarges enough the pressure loss would be decrease

    結果顯示氣流在擴張圓錐管壁附近出現分離產生較強的擾動，造成局部流動損失和載體前氣流速度沿徑向分佈不均勻；入口擴張管結構對催化器的流動特性有很大影響，但並非擴張角越大，催化器流速武漢理工大學碩士學位論文分佈的不均勻性和壓力損失也增大，而是存在著一個最佳角度，但當擴張角增大到一定程度以後，擴張角對流速分佈和壓力損失的影響變小。
  5. The first task in separation of subcellular components is always the rupturing of the cell wall and the protoplasmic membranes.

    分離亞細胞組成的第一步總是使細胞壁和原生質膜破碎。
  6. Membrane distillation is an important branch of membrane separation technology which employees a hydrophobic microporous membrane for the separation process. during md process, feed contacts with one side of membrane, after water evaporates on hot side, vapor transfers to cold side under pressure drive, where vapor is condensed on cooling wall and then collected or removed

    膜蒸餾技術是膜分離技術中的一個重要分支，它是指利用一疏水性的多孔膜，膜熱側與待處理液直接接觸，待處理溶液中的水在膜熱側汽化后，氣體在壓強差的推動下，通過膜孔傳遞到膜冷側，冷凝后收集或除去的一種分離技術。
  7. All models can predict the attached and little separation flows. for the high angle - of - attack separated flows with distinct history effects, the j - k and k - g models perform better than b - l model. for multi - body and multi - block mesh system, model k - g, which does not need the distance normal - to - wall, performs much better adaptability for complex geometries

    所有模型都可以很好地模擬附體及和小分離流動;對于具有明顯上游歷程效應的大迎角分離流動， j一k和k - s模型的模擬能力較強;對于多體干擾和多塊網格系統， k - s模型無需計算網格單元至物面的垂直距離，具有較強的適應能力，且計算效果最佳。
  8. Realization and comparison of separation methods for wall clutter and doppler ultrasound blood signals

    剩餘活性污泥的超聲脫水及破解
分享友人
分享到 Line

分享到臉書