shear rate 中文意思是什麼

shear rate 解釋
剪切程度
  • shear : vt vi （sheared 〈古語〉 shore; shorn sheared）1 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。2 ...
  • rate : n 1 比率，率；速度，進度；程度；（鐘的快慢）差率。2 價格；行市，行情；估價，評價；費，費用，運費...
  1. The results showed that the soy protein dough was a typical pseudoplastic fluid in the normal processing ranges, and the apparent viscosity decreased with the increase of shear rate and moisture content, and also decreased with the increase of temperature below 120, and increased with the reduction of temperature above 120

    實驗結果表明：大豆蛋白質面團呈現很強的非牛頓性，剪切速率、溫度和含水率對表觀黏度影響顯著；表觀黏度隨剪切速率的增大而減小，隨含水率的增大而減小，溫度低於120時，隨溫度的升高而減小，溫度高於120時，隨溫度的升高而增大。
  2. Results low shear rate and high shear rate of whole blood viscosity, plasma viscosity, haematocrit in different age stages in winter were significantly different from those in summer

    結果各年齡段的全血粘度低切、高低，血漿粘度，紅細胞壓積冬夏均有顯著性差異。
  3. Time - temperature superposition principle could bee applied to g " dependence on cd, and the dependence of shifted factor at on temperature demonstrated a linear relationship by a plot of in at vs. t - 1. the steady rheological measurements for nanocomposites melts were conducted. the results revealed that the melts of exfoliated nanocomposites with lower loading of org - mmt exhibited shear - thinning even at lower shear rate as compared with polymers filled with common particles, while the melts flow depended weakl

    研究結果表明仁復合體系g 『和動態損耗模量寧的對數關系性呀g 『一109夕， _印維乖溫動態模量滿足時溫疊加原理，頻率移動因子（ at ）的對數與塌度的倒攀即種馬與了一『有良好的線性關系?一_面，復合體系熔體的穩態剪切流變行為具有不同於普通粒子填充聚合性。
  4. Flow - mediated dilatation response normalized to peak shear rate was significantly lower in migraine patients than in controls, the report indicates

    報告指出，流量介導的肱動脈擴張與標準的高峰速度階差相比，偏頭痛病人擴張流量低於對照組。
  5. While the temperature increases the flow curves move down, and it is showed that between 180 and 190 the influence of temperature on the flow behavior is smaller, and the influence of shear rate is smaller

    而溫度的上升導致流變曲線下移，可以認為，在180和190溫度區間內的流動性能相對溫度的影響較為穩定。剪切速率對流動性能的影響變小。
  6. Test method for low temperature, low shear rate viscosity temperature dependence of lubricating oils using a temperature - scanning technique

    溫度掃描法測試潤滑油的低溫低剪切率粘性溫度關系的試驗方法
  7. Standard test method for low temperature, low shear rate, viscosity temperature dependence of lubricating oils using a temperature - scanning technique

    採用溫度掃描技術的潤滑油的低溫低剪切率粘性溫度關系的標準試驗方法
  8. 2. effect of the viscosity ratio, mterfacial adhesion, processing conditions and composition on the dispersing morphology and properties of pp / eoc blends was investigated. low viscosity ratio and high shear rate during processing were found to produce fine and uniform dispersion of eoc in pp matrix, while low viscosity ratio, high interfacial interaction, good fluidity of elastomer and high shear rate in molding process resulted in fibril dispersion, which afford a guide for controlling the morphology of pp / eoc blends

    研究了粘度比、界面相互作用、加工條件和共混比例等因素對pp eoc體系分散形態和性能的影響，發現粘度比小和加工過程中剪切強度大有利於彈性體在基體中分散均勻細化；粘度比小、界面相互作用強、彈性體本身的流動性好及成型時受到的剪切應力大，使彈性體相易變形，沿流動方向取向呈纖，闡明了各因素對形態影響的作用機制，這對pp eoc共混物的形態控制具有重要的指導作用。
  9. Standard test method for measuring apparent viscosity at high - temperature and high - shear rate by multicell capillary viscometer

    用多孔毛細管粘度計在高溫高剪切率下測量表觀粘度的標準試驗方法
  10. Standard test method for measuring viscosity at high temperature and high shear rate by tapered - plug viscometer

    高溫和高剪切速率下粘度測定法
  11. Test method for measuring viscosity at high shear rate by tapered bearing simulator viscometer at 100 c

    攝氏100下用錐形承載模擬粘度計測量高剪切速率粘度的方法
  12. Standard test method to measure viscosity by tapered bearing simulator at high temperature and high shear rate

    在高溫和高剪切率下用錐形承載模擬器測量粘度的標準試驗方法
  13. Some function assistant agents, such as mapo, t313 and home - made sh, were used in ap / htpb suspensions. the results indicate that sh is of an effective surfactant for ap, especially for superfine ap. it can not only improve the surface properties of superfine ap, but can obviously raise shear rate exponent of ap / htpb suspensions and the performance of the rheological behavior of suspensions

    2 、將mapo 、 t313 、及自製的sh等工藝助劑用於ap htpb懸浮液中進行流變學實驗研究，發現自製的sh是一種對ap尤其是細粒ap表面性質能改善的有效表面活性助劑，使ap htpb懸浮液體系的剪切速率指數明顯提高，改善了懸浮液的流變性。
  14. For sbs and sebs, especially sebs, the melt viscosity and the shear rate are inter - rated

    Sbs與sebs材料尤其是sebs材料的熔膠粘度melt viscosity與剪切率shear rate繫系相關
  15. But, the melt viscosity of the sbs and sebs elastomers is highly affected by the shear rate inside the barrel but it is not sensitive to the temperature inside the barrel

    但sbs與sebs彈體的熔膠粘度melt viscosity非常容易被炮筒內剪切率shear rate影響，反而對炮筒內的溫度不太敏感
  16. Test method for measuring apparent viscosity at high - temperature and high - shear rate by multicell capillary viscometer

    用多孔毛細管粘度計在高溫和高剪切率下測量表面粘性的試驗方法
  17. The resulting semi - solid mixture then flows homogeneously, figure 1, behaving as a thixotropic fluid with viscosity depending on fraction solid, morphology, shear rate and time

    這樣最終形成的半固態混合物會均勻地流動（圖表1 ） ，並依據固體粒度、晶形、剪切速率及時間而形成粘性觸變液體。
  18. Due to the structure difference in the molecules of soft sections between sbs and sebs elastomers, the viscosity and shear rate is of significant variation

    由於sbs與sebs彈體中間的軟質段分子結構不同，其相對剪切率的粘度特性viscosity shear rate也有顯著的差異
  19. With the content of iron carbide in carbonyl iron decreasing, and rise, and shear stress ( at ) induced by magnetic field of mrs declines, the shear rate corresponding to the maximum at ( " y max ) heightens, and the response time of a t shortens. with the content of dmf increasing, the size of carbonyl iron reduces so that a t of mrs enhances, and increases with h more rapidly and " y max heightens

    隨著羰基鐵粒子碳化物含量的減少， 、增加，而mrs的磁致剪切應力下降，最高剪切速率_ （ max ）增加，磁流變響應時間縮短；隨著dmf用量的增加，羰基鐵粒子的二次顆粒尺寸減小， mrs的增加，且隨外加磁場強度h增加的速率提高， _ （ max ）提高。
  20. The apparent viscosity of phbv will decrease quickly while the shear rate increase

    Phbv的表觀粘度隨剪切速率的上升下降很快。
分享友人
分享到 Line

分享到臉書