shear yield stress 中文意思是什麼

shear yield stress 解釋
剪切屈服應力
  • shear : vt vi （sheared 〈古語〉 shore; shorn sheared）1 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。2 ...
  • yield : vt 1 生出，產生（作物、報酬、利益等）。2 給與，讓與；讓渡；放棄（權利、地位等）；交出。3 承認。4 ...
  • stress : n 1 壓力，壓迫，緊迫，緊張。2 【語音】重音；重讀；【詩】揚音；語勢，著重點。3 重要（性），重點，...
  1. New yield equation based on geometric midline of error triangles between tresca and twin shear stress yield loci

    和雙剪應力兩軌跡間誤差三角形中線確定的屈服方程
  2. Coal slurries were found to exhibit a wide spectrum of flow behavior ranging from newtonian at low concentrations to shear - thinning and pseudoplastic with a yield stress at higher concentrations

    利用雙峰級配理論，將粗顆粒煤粉加入細顆粒中可降低煤漿體系的黏度。
  3. The triaxial shear test of the original loess is carried out and the ct scanning is ongoing at the same time. combining images and data of the ct scanning with the stress - strain curve, the course of soften dehiscence damage and harden yield damage is explained by means of damage theory

    進行了原狀黃土的三軸剪切試驗過程中的ct掃描，結合ct圖像、數據與應力應變曲線，利用損傷理論方法解釋了軟化開裂破壞和硬化屈服破壞過程。
  4. Furthermore, according to generalized plastic mechanics theory, a three yield surface model is researched basing on the experiment of other people and the shear yield surface in the stress lode angle direction is researched emphatically. by the new model, the fem program is also worked out in this paper

    再者，本文在廣義塑性力學的基本理論框架下，在前人研究的基礎上，建立了一個土體的三屈服面模型，該模型更適合於數值計算，並在此基礎上著重研究了洛德角方向上的剪切屈服面。
  5. By using a cell equivalent method, the present model can deal with the face - center square structure of erf. combining the scheme of the classical conductivity model for the single - chain structure, a new formula for the prediction of the shear yield stress of erf is set up. the influences of the separation distance of the particles, the volume fraction of the particles and the applied electric field on the shear yield stress are investigated

    在電導模型的基礎上，建立在電流變液體在外加電場的作用下，粒子之間會形成某種特定的微觀結構，利用等效胞元的方法，將這微觀結構等效成一個平板，建立了等效的微觀結構平板模型，通過計算電流變液體內部的局部電場，對電流變液體的工作機理和剪切屈服應力進行了預測，並且分別考慮了在不同的粒子間距、不同的粒子濃度、不同的外加電場的情況下，對剪切屈服應力的影響。
  6. In the case of dipole model, it gets the precision distribution of the electric field of the inside and outside of the particle by solving the laplace equation. the influences of the separation distance of the particles on the shear yield stress are investigated. and the result of the laplace is also contrasted with the result of the finite element by ansys software

    在極化的狀況下，利用求解laplace方程，求解出多粒子下粒子內部的和周圍的局部電場的表達式，求解出粒子表面的極化電荷、粒子內部的和外部的局部電場，考慮了粒子間距對局部電場的影響，還分析了，在不同外加電場下對局部電場的影響，並且與ansys有限元的數值結果模擬進行了對比。
  7. Through comparing and analyzing of bearing capacity, development of crack and strain of reinforced, the results show that the load - deflection plots f or specimens from the finite element analysis agree well with the experimental data, and choosing the rightful stress - strain relationship, utilizing ansys program, the test process can be well simulated. at the same time, making used of the program, the traditional shear wall is analyzed. it shows that comparing with the traditional shear wall, the hollow shear wall ' s cracking load drop 16 %, yield load and failure load drop 13 %, stiffness drop 13 % ~ 22 %

    其次在試驗的基礎上，將試驗手段、有限元數值模擬方法和理論分析結合起來，利用有限元程序ansys對其中的兩片墻板進行非線性有限元分析，並對前後的承載性能，裂縫發展、鋼筋應變進行了比較和分析，結果表明有限元節點模型分析的荷載-位移曲線和試驗測得數據符合良好，選用合理的材料本構模型，利用ansys可以較好的模擬試驗過程；同時利用有限元模型對比分析了普通剪力墻和空心剪力墻，空心剪力墻與普通剪力墻對比，其開裂荷載下降16 ，屈服荷載、極限荷載下降13 ，剛度下降13 22 ，開裂至屈服、屈服至極限荷載階段的剛度衰減規律與普通剪力墻基本一致，空心剪力墻的後期剛度比較穩定。
  8. Twin shear stress yield criterion

    雙剪應力屈服模型
  9. According to the characteristics of the series - base - isolation structure, the calculation formulas for the equivalent damp and equivalent stiffness of the structure were given, and the desirable equivalent damp could be obtained by rational design of multi - level yield shear stress of composite bearings

    根據串聯基礎隔震結構的特點，給出了該種隔震體系的等效阻尼、等效剛度的計算公式；將串聯隔震支座設定為多個屈服剪力水平，得到了較好的等效阻尼。
  10. Abstract : in this paper, for the brick structure with frame - shear wall in the first story, the principle of determining the parameters of a laminated rubber bearing such as stiffness, yield strength and axis press stress was discussed ; and the vibration - isolation effectiveness was tested by analyzing a representative project using nonlinear time - history analysis method. some suggestion was made to design and analyze brick structure with ground frame - shear wall on rubber vibration - isolation system

    文摘:討論了底框結構橡膠墊隔震層的剛度、屈服強度、軸向壓應力等參數的設計原則，以典型工程為例，採用彈塑性時程反應分析方法，檢驗了底框結構使用橡膠墊隔震層后的隔震效果，對底框結構基礎隔震設計與分析方法提出了一些建議。
  11. Oxygen precipitates (useful for gettering) can reduce the yield strength (critical shear stress) up to fivefole.

    氧沉澱（可用作吸雜）會使屈服強度（臨界剪應力）降低為五分之一。
  12. According to the test results of localization and shear bands formation under the consolidated undrained plane strain compression tests on soft clay in shanghai, it was found that the deviator stress of shear band beginning to form was very close to its yield point in clay soils

    摘要根據上海軟土在固結不排水平面應變壓縮試驗條件下應變局部化和剪切帶形成的實測研究結果，發現粘性土剪切帶開始形成的偏應力為其屈服點。
  13. Numerical analysis on shear yield stress of magnetorheological fluids

    磁流變液剪切屈服應力的數值分析
  14. The rapid and reversible change between fluid and solid enables erf potential applications in mechatronic devices, cars and general machines. the transmission ability of a self - made cylinder coupling with zeolite - based erf was investigated, the torque transmission of the coupling in wide ranges of driving speed and electric field was measured. the relationship between the transmission torque, the zero field viscosity of erf and shear yield stress of erf under different electric fields was obtained and compared with theoretical prediction

    本文用沸石和硅油配製的電流變液，在自製圓筒式聯軸器上研究了在一定的速度范圍和有無電場作用條件下測量了其扭矩傳遞能力，獲得了傳遞扭矩與零電場電流變液粘度以及電場中電流變液的剪切屈服應力之間的關系，並與理論值進行了比較。
分享友人
分享到 Line

分享到臉書