shutoff valve 中文意思是什麼
-
Install a shutoff valve in the cold water inlet line
在冷水進水管處安裝一個關閉閥。 -
Emergency shutoff valve for lpg equipment. technical specification
液化石油氣設備用緊急切斷閥.技術條件 -
The shutoff valve with the test cock is to be mounted on the inlet side of the backflow preventer
帶測試旋塞的關閉閥應該安裝在防迴流閥的進口側。 -
Conical seating at an angle to flow is self aligning, tight and always closed in a no - flow situation. even in vertical ( flow - up ) pipe runs, this valve provides exceptionally tight shutoff
圓錐形閥座與流向具有一定的角度,能夠自行調整,在無流體狀態下能夠始終緊密關閉。甚至在垂直(流向朝上)管道上,這種閥門具有特別緊密地關閉特性。 -
Clean or replace gate valve with full port ball valves or resilient wedge shutoff valves
1用全流道球閥或彈性楔板關閉閥清洗或更換閘閥。 -
The reduced pressure detector assembly shall consist of two independent torsion spring check modules, a differential pressure relief valve located between and below the two modules, two drip tight shutoff valves, and required torsion spring check modules and relief valve shall be contained within a sleeve accessible single housing constructed from 304 ( sch 40 ) stainless steel pipe with groove end connections
這種減壓檢測器總成應該包括兩個獨立扭力彈簧止回閥模塊,一個位於兩個模塊之間的下方的差壓安全閥,兩個防滴漏關閉閥,並且要求扭力彈簧止回模塊和安全閥應該放置在一個套筒內,要易於接近帶溝槽連接的304 (目錄40 )不銹鋼管的單個外殼。 -
Close shutoff valves and open test cocks no. 2, 3 and 4 to relieve pressure from the body of the valve
關閉關閉閥,並開啟測試旋塞2號、 3號和4號,釋放閥體內壓力。 -
After closing a gate valve with sufficient force to develop shutoff, the stem should be backed off slightly ( 1 / 8 to 1 / 4 turn ) to relieve stem load
在以足夠的力量關閉閘閥后,閥桿應該稍微回轉( 1 / 8至1 / 4圈) ,以釋放閥桿負載。 -
Close shutoff no. 1. slowly loosen hose connection at tc # 2 until differential gauge rises to about 2 psi then tighten. if the differential reading does not decrease record check valve as tight
關閉1號關閉閥。慢慢松開連接在測試旋塞2號上的軟管直到壓差表上升到大約2psi ,然後緊固。如果壓差讀數沒有降低,則記錄止回閥為密封緊密。 -
The test cock is on the inlet side of the shutoff valve
測試旋塞位於關閉閥的進口一側上。 -
Remove bypass hose from test cock no. 1, open shutoff valve no. 1
從測試旋塞1號上拆卸旁路軟管,開啟1號關閉閥。 -
Remove all test equipment and open no. 2 shutoff valve of the device
拆卸所有檢測設備,開啟裝置上的2號關閉閥。 -
Psv pulse air shutoff valve
脈沖空氣切換閥 -
If the system is not flushed until after the backflow valve is installed, remove both check modules from the valve and open the inlet shutoff to allow water to flow for a sufficient time to flush debris from the water line
如果在安裝迴流閥之前系統還為沖洗,則從閥門上拆卸兩個止回閥模塊,開啟進口關閉閥,讓水流過足夠長的時間來沖洗水管內的堆積物。 -
Gate valves are the most commonly used shutoff valve in the industry today
如今行業內,閘閥最常用作關閉閥,用於要求壓降最小,能夠雙向啟閉的應用場合。 -
Note : for australia and new zealand, line strainers should be installed between the upstream shutoff valve and the inlet of the backflow preventer
注意:適用於澳大利亞和紐西蘭:管路過濾器應該安裝在上游關閉閥和防迴流閥進口之間。 -
Psov purge shutoff valve
凈化開關閥 -
Shutoff valves : if you remove the shutoff valves from the series 919, reassemble the shutoff valve with the test cock mounted on the inlet side of the unit
關閉閥:如果從系列919上拆卸關閉閥,則重新裝配關閉閥時要使得測試旋塞安裝在裝置的進口一側。 -
The national fire protection agency ( nfpa ) guidelines require a confirming flow test to be conducted whenever a " main line " valve such as the shutoff valves or a backflow assembly have been operated
美國國家防火協會( nfpa )指導原則要求對于主管線上運行的閥門,如關閉閥或防迴流閥總成,必須進行流量測試。 -
Slightly open shutoff valve no. 1 and allow water to fill the tube to the top then close no. 1 shutoff
稍微開啟關閉閥1號,將水注入管子直到頂部為止,然後關閉1號關閉閥。
分享友人