signal voltage generator 中文意思是什麼
signal voltage generator
解釋
信號電壓發生器-
The demodulator receives its reference voltage from the signal-generator voltage supply.
解調器的參考電壓由電信號發生器電壓電源供給。 -
We have made a full theoretical analysis of the wave property and the wave parameters of the flap - type wave generator in the towing tank of our school, and confirmed that should make the factor that the performance of the wave generator give play to normally to influence. in allusion to that the old wave generator can not simulate sea wave, upgrade and transform to this system change the control computer system and install additional d / a change card, redesign the wave control interface and transmission means of control signal, give up the disk machine that can not be used, make the wave - making control voltage signal that has translated direct input the wave controller, make wave controller to make waves through servo system
對我校船模水池原有的搖板式造波系統的性能進行了理論分析，針對水池原有造波機系統模擬海浪的不足，對該系統進行升級與改造，更換了主控計算機並加裝d a轉換卡，重新設計了造波控制信號的介面與傳輸方式，捨去了原系統中現已淘汰的磁盤機，使轉換后的造波控制電壓信號直接輸入到造波控制器中，再由造波控制器通過液壓伺服系統驅動造波板進行造波。 -
In order to improve the quality of the voltage signals, this paper has adopted the scheme of three phases and six organs in signal - generator part, which can eliminate the errors caused by the assembly warp and the zero shift of organs. this paper also has analyzed the distribution and varying rules of the magnetic field in the signal - generator part, then based on the conclusion of the analysis improved the structure of signal - generator, which could completely eliminate the noise signal caused by the roughness of the face on the magnetic steel ring. the improvement not only met the requirement of this study, but established the theory foundation for the super - high precision magnetic encoder in future research
因此，為提高原始電壓信號的質量，本文採用三相六元件的信號發生方案，通過差分處理濾除了由於裝配偏差和零點漂移帶來的信號誤差;本文對編碼器信號發生結構進行了磁場分析，依據磁場分析的結論對編碼器常用的信號發生結構進行了改進，改進后的結構利用積分原理在理論上能夠完全消除信號中由磁鋼環表面粗糙度引起的信號噪聲，進一步提高了信號質量，此結構不僅滿足了本課題的需要，而且為今後研製超高精度的磁電式編碼器奠定了理論基礎。 -
It can automatically match rotational speed generator, electromagnetic rotational speed sensor and electromagnetic turbine flowmeter. moreover it can adapted measured signal that is 1v ~ 300v voltage and 1hz ~ 2500hz frequency
能自動匹配測速發電機、電磁式測速傳感器和電磁渦輪流量計，適應電壓峰峰值從1伏以下至300多伏、頻率從1hz以下至2500hz以上的被測信號。 -
The single - chip function generator icl8038 can get synchronous sine wave of constant amplitude in pll as voltage control oscillation ( vco ), which is a basic signal source of static frequency converter
單片函數發生器icl8038在pll中作為壓控振蕩器（ vco ）產生同步等幅正弦波，可作為靜止變頻器的基準信號源。 -
In the meantime, the all sub - circuits are also designed and emulated carefully including inverter, rs type flip - flop, voltage reference circuit, error amplifier, voltage comparator, sawtooth - wave generator, pwm comparator, soft activation circuit and so on. as a result, all of the sub - circuits answer the requirements. this chip has taped out with the 0. 5um mix - signal process of csmc
本文利用cadenceeda集成電路設計工具、 spectres模擬工具，對集成電路內的各個模塊包括反相器、基本rs觸發器、基準電壓電路、誤差放大電路、電壓比較電路、鋸齒波振蕩發生電路、 pwm比較電路、軟啟動電路、驅動電路等進行了具體的設計和模擬，且達到了預先設定的指標。 -
After investigating the relationship between generator measuring speed pulse and its on - load voltage at phase a, it is proposed in the thesis that we can obtained phasor of generators through messuring dividing frequency signal of generator measuring speed pulse
我們研究了發電機測速脈沖和其a相空載電勢相位的關系，提出了只需測量與發電機同軸的測速發電機發出的測速脈沖的分頻信號，經過計算就可以得出發電機相角的測量方法。 -
Synchronizer a synchronizer is an electronic device that monitors the phase relationship between two voltage sources and provides a connection signal to an engine governor, to force the generator set to synchronize to the system bus
同步器同步器是用來監測兩個電壓源之間的相位關系的電子設備，它向發動機調速器發出信號，以促使發電機組與系統母排能夠同步。 -
The research effort offers favorable condition for future research of the shape meter closed - loop computer control system. stress signal generator which can generate the voltage signal similar with rolling tension stress signal is be designed. with the signal generator, testing shape meter control system will be very convenient and its development cycle will be significantly shorten
另外，利用微機和pcl - 812pg數據採集卡等設計並研製出了可以產生符合軋制張力要求的張力信號源，利用張力信號源為板形儀控制系統的實驗、調試提供了方便，可大大縮短板形儀的研製周期。
分享友人