simulation model 中文意思是什麼

simulation model 解釋
模擬摸型
  • simulation : n. 假裝；模擬；裝病，裝瘋；【生物學】擬態，擬色。
  • model : n 1 模型，雛型；原型；設計圖；模範；（畫家、雕刻家的）模特兒；樣板。2 典型，模範。3 （女服裝店僱...
  1. And the deficiencies are pointed out in present researches, such as highway capacity, level - of - service, influence factor of road alignments, etc. from these, it has confirmed that the thesis should be studied from rational analysis, quantitative analysis of level - of - service, impact on capacity of road alignments, setting - up simulation model, etc. the high - accuracy gps dynamic data acquisition appearance is proposed to be used for the first time to carry on the experiment of overtaking on two - lane highways, and experiment scheme is designed according to the driver ' s perceive to judge each overtaking course. based on the experiment data, it can get two important parameters of acceptant gap ? the critical gap of overtakable time headway and returnable time headway through data processing, which can offer the strong support to the research of two - lane highway capacity with qualitative and quantitative analysis. besides, the experiment methods is provided to observe overtaking ratio and to measure the

    研究中首次提出了運用高精度gps動態數據採集儀對雙車道公路上的超車行為進行觀測，設計了根據駕駛員感受度來衡量超車過程的實驗方案，並通過後期數據處理得到了超車過程中兩個重要的可接受間隙參數-可超車車頭時距和可回車車頭時距的臨界間隙值，為定性和定量分析雙車道公路通行能力提供有力的數據支持;同時，還提出了觀測超車率的實驗方法以及測量加速度干擾的實驗方案，統一了計算加速度干擾的時間統計間隔，為雙車道公路的服務水平量化研究奠定基礎;最後還簡單介紹了駕駛員問卷調查法和模擬程序中模型參數標定和驗證的數據採集方法。
  2. Eric m queen, ben raiszadeh. mars smart lander parachute simulation model. aiaa paper 2002 - 4616, 2002

    程文科.一般降落傘-載荷系統動力學及其動穩定性分析.長沙:國防科技大學博士論文， 2000
  3. Based on computer simulations, different programs, such as madymo and ls - dyna, were used in this paper to develop simulation model of car - barrier crash with two kinds of barriers ( concrete barrier and w - beam barrier ) and two styles of cars ( ford and santana ) respectively

    文章基於計算機模擬技術，使用不同軟體（多剛體動力學模擬軟體madymo和有限元分析軟體ls - dyna ）針對兩種護欄（混凝土護欄和波形梁護欄）和兩種不同轎車車型（ ford車和santana車）分別建立了轎車-護欄碰撞的模擬模型。
  4. Based on the simulation model theory of temperature and stress fields presented in this article, a large simulating program for high rccd has been developed, which can numerically simulate all kinds of temperature control measures, including water pipe cooling, heat insulating in winter, reducing place temperature of concrete, spraying water brume, and long interval over - watering surfaces overflowing in flood season.

    基於本文提出的溫度場和徐變應力場模擬模型理論，編制了高碾壓混凝土壩的三維有限元模擬計算程序，在程序中考慮了各種溫控措施的數值模擬，包括：水管冷卻、冬季保溫、降低混凝土的澆築溫度、夏季混凝土表面噴水霧、施工汛期壩頂面過水等。
  5. The thesis focuses on the development of the dynamic simulation model of evaporators, the accomplishment of the stable and dynamic simulation of the parameters of cryogen - side, air - side and how to carry out dynamic simulation on the refrigerating effect of evaporators under different evaporating temperature and the realization of the analyses and calculations of the main parameters, such as, the wind speed of air - side and specific humidity etc, which affect the function of evaporators

    本文重點是對蒸發器建立動態模擬模型，並對製冷劑側和空氣側參數進行穩態和動態模擬，同時對蒸發器在不同蒸發溫度下的製冷量進行了動態模擬，而且對影響蒸發器性能的主要參數（空氣側入口風速、入口含濕量等）進行了分析和計算。
  6. This section essence shrinks the proportion is 1 : 43 simulation model vehicle the east wind - 11 short distance trajectory guided missile truck which develops voluntarily by our country, may mobile launch carries the system is a prototype, the chassis and the missile are the alloy manufacture, the missile may take out from the discharger or revolves along with the discharger to each angle, all vehicle doors may open, the rubber tire may rotate, the zero number of articles approaches 200

    此款精縮比例為1 : 43的模擬模型車以我國自行發展、可機動發射的東風- 11短程彈道導彈車載系統為原型，車體及導彈為合金製造，導彈可以從發射架上取出或隨發射架旋轉至各個角度，所有車門均可打開，橡膠輪胎可以轉動，零件數接近200個。
  7. Then following reality constituent of engine and connecting component interface, a nonlinear signal cylinder engine model has been created, though fire interval and fire order, a control - oriented four cylinders engine is build. following dynamometer is seen as load, performance of engine is simulated and researched under the condition of constant torque and speed, validation of the math and simulation model have been confirmed by comparison result between simulation with test result of engine performance simulation software dyno

    按照發動機的實際組成，根據各部件的介面類型連接模型庫中的部件，建立了單缸發動機非線性模型，在此基礎上，依據發動機實際發火間隔和順序，建立了面向控制的四缸汽油機模型，並以測功器為負載，通過恆轉矩和恆轉速方式進行了發動機性能模擬和研究，模擬結果和發動機動力性能模擬軟體dyno測試結果的對比驗證了數學模型和模擬模型的正確性。
  8. The simulation model for traffic flow was discussed initially by analyzing the characteristic of the traffic flow in urban express highway

    在分析城市快速道路交通流特徵的基礎上，對交通流模擬模型進行了初步探討。
  9. The linearized simulation model and dsp control software are also introduced

    介紹了srm線性化模擬模型，以及dsp的控制軟體設計。
  10. Based on these, considering prepayment " influence on mbs " price, the following three pricing methods are researched on deeply. referring to the experiences of foreign countries, the pricing method based on prepayment pattern is given ; considering the influence of interest rate on prepayment, different interest rate simulation pricing methods are set up, which is on the basis of different interest rate term structure model ; in view of interest rate and different incentive threshold of mortgager, a interest rate incentive function simulation model is established to price mbs

    在此基礎上，考慮到預付對證券價格的影響，對以下三種定價方式進行了深入研究：借鑒國外經驗，提出了基於提前還款模式的定價方法；考慮利率對預付行為的影響，建立了基於利率期限結構的不同種模擬利率定價模型；考慮到利率以及抵押借款人的不同利率刺激門檻對預付的影響，建立利率刺激函數模擬模型進行定價。
  11. In this paper, a workflow model simulation environment based on object petri net is constructed. under this environment, a workflow model can be parsed and transformed to an opn - based simulation model, then the simulation parameters should be set and the simulation model can be put to use

    本文構建了一個基於面向對象petri網的工作流模型模擬環境，將建模工具生成的工作流模型解析出來后，再轉換成面向對象petri網形式的模擬模型，然後設置模擬參數，將該模型投入模擬運行。
  12. This model may be classified as either an optimizing model or simulation model.

    這個模型可分為最佳化模型或模擬模型。
  13. A life cycle cost simulation model of complex repairable equipment

    復雜可維修設備壽命周期費用模擬
  14. The main content and contribution in this dissertation are as follows : 1. the rrs wireless channel characteristic and the two - path model are described and a simulation model of the pcm / fm rss system is introduced

    本文的主要工作和貢獻之處: 1 .分析了再入遙測無線通道特性及雙徑模型，建立了pcm / fm再入遙測系統模擬模型。
  15. Application of saber ' s simulation model igbt1 in solid - state switch design

    1在固態開關設計中的應用
  16. Analysis of simulation model used for studying the output property of controllable saturable reactor

    可控飽和電抗器輸出特性建模與模擬研究
  17. The friction simulation model of the stabilized turntable is built

    建立了穩定轉臺摩擦的模擬模型。
  18. Handbook on the unctad - agricultural trade policy simulation model download

    Wto新一輪農業談判:進展與問題
  19. 2. the transonic flow field solutions of a ttcp standard waf - body combinations are computed using the software of cfd, the results are agreement with experiment dates, this verifies that the accuracy of the numerical simulation model is ensured

    2 .應用cfd軟體對某ttcp標準卷弧翼-身組合體跨聲速下流場進行數值計算，將計算結果與文獻試驗結果進行對比，驗證本文數值計算模型。
  20. In this dissertation, according to the theory of mechanical dynamics and multi - body dynamics, a simulation model of nj2046 light off - road vehicle including suspension system, steering system and tires is built with the software carsim and so the vehicle steering characteristics are analyzed with the step angle input of steering wheel. it is found that the steering characteristics are different when the velocity and load are different, and the relationship between steering characteristics and velocity and load is presented

    本文根據機械繫統動力學、多體動力學理論，運用動力學模擬軟體carsim建立了包括懸架系統、轉向系統和輪胎等模型的nj2046越野汽車整車模擬模型，在此基礎上分析了nj2046越野汽車在方向盤轉角階躍輸入時的轉向特性，通過對不同車速、不同載荷條件下的模擬計算，得出了在這些條件下該車具有的不同表現特徵，揭示了轉向特性與車速、載荷和輪胎的內在關系。
分享友人
分享到 Line

分享到臉書