single winding transformer 中文意思是什麼

single winding transformer 解釋
單繞組變壓器
  • single : adj 1 僅只一個的，單獨的；單式的；【植物；植物學】（花等）單瓣的；【無線電】單工的，單次的。2 獨...
  • winding : adj. 1. 卷繞的；繞線的，繞組的。2. 迂迴曲折的，蜿蜒的。n. 1. 卷繞起來的一盤（繩索等）；卷繞動作；絡紗。2. 彎曲，紆曲；不正行為。3. 【采】卷揚，提升；【電學】繞組，繞法；線圈。
  • transformer : n. 使變化的人[東西]；【電學】變壓器；變換器；互感器。 polarity of transformer 變壓器繞線方向。
  1. The fourth advantage of this circuit is since the transformer has no high voltage dc on it, the transformer can be replaced with an " autoformer " ( a single tapped winding ) allowing the output autoformer to be further optimized

    第四：由於輸出變壓器不需要通直流，變壓器可以使用「自耦」式單一抽頭繞組，從而容許進一步優化輸出自耦。
  2. Two single - stage pfc converters with the negative feedback of engergy - storage capacotor voltage by transformer windings are analyzed. the two converters have similar performances, and they can be translated each other, which verified the translation rule. the analysis and simulation show that with the negative feedback of energy - storage capacitor voltage by transformer winding have good performances

    通過對兩種採用變壓器繞組實現負反饋的單級pfc變換器研究，結果顯示出它們的相近性，驗證了兩端模式和三端模式的轉換規則，同時也說明採用變壓器繞組實現負反饋的方式對抑制電容電壓有很好的效果，並對其進行了優化設計。
  3. The principles and characteristics of synchronous rectification ( sr ) are given, and advantages of self - driven sr in low power applications is detailed. review of several topologies which incorporate self - driven sr makes the constrains of conventional self - driven sr scheme apparent and thus a new scheme to drive srs is proposed. the developed single - winding self - driven synchronous rectification ( swsdsr ) scheme works properly in topologies that drive symmetrically the transformer ( push - pull, half bridge, . . ). it allows for maintaining the srs on even when the voltage in the transformer is zero, which is impossible to do in traditional self - driven approaches

    本文針對低壓/大電流輸出的小功率dc / dc變換器，圍繞著變換器的效率問題，分析了同步整流的原理和特點，重點闡述了自驅動同步整流在低功率場合的優勢，在分析比較了多種與自驅動同步整流相結合使用的電路拓撲后，指出常規的自驅動同步整流方案限制了與之結合使用的電路拓撲的范圍這一局限性，從而給出了一種新穎的單繞組自驅動同步整流方案。
  4. The main achievements of the thesis are as follows : ( 1 ) kinds of techniques to detect magnetizing inrush of traction transformers are thoroughly investigated in this paper, and their limitation are indicated and corresponding improvement techniques are proposed. ( 2 ) in this paper, flux linkage equilibriun equations are used to build " ash - box " models of some traction transformers based on system identification, such as two - winding single - phase traction transformer, impedance - matching equilibriun traction transformer and scott traction transformer

    論文的主要內容有： （ 1 ）詳盡分析了現有的針對牽引變壓器勵磁涌流演算法的保護演算法，提出了每種演算法的局限性及其改進方法； （ 2 ）提出適用於鐵道電氣化系統中各種牽引變壓器對應的三?二相轉換規則，利用該規則可將對應量的轉換置於保護軟體中，從而可大大減輕在牽引變壓器兩端外部復雜的接線。
  5. But in fact, there are many windings on each leg of a balance transformer, and the winding impedance relationships that the balance condition requires are strict, so it is difficult to design and make such transformers. if adopting the connection scheme of dual windings, the windings on single leg will increase almost doubly. it is more difficult to satisfy the balance condition and probably it will confront conflict when arranging these windings, so parameters of various phases can not be balanced

    事實上由於平衡變壓器單柱繞組數目較多，若採用雙重接線方案，則單柱繞組數目增加近一倍，滿足平衡條件十分困難，甚至使得繞組在空間上的布置產生矛盾，無法達到各相參數平衡的要求，而「四相四心柱「結構的三相變四相電力變壓器較好的解決了這一難題。
分享友人
分享到 Line

分享到臉書