smoke test 中文意思是什麼
smoke test
解釋
發煙試驗-
10. 02 test method for smoke obscuration caused by burning cables in a vertical configuration
在立式電纜槽中燃燒電纜引起的煙霧遮避性的試驗方法 -
Fire hazard testing - part 6 - 2 : smoke obscuration ; summary and relevance of test methods
火災試驗.第6 - 2部分:煙霧不透明度.試驗方法的概要及其相關方面 -
Test method for measurement of smoke obscuration using a conical radiant source in a single closed chamber
密閉單燃燒室中使用錐形輻射源測量煙霧昏暗度的試驗方法 -
The emission performance experiment compared with original engine were made on the modification of lr6105q lpg / diesel oil engine. the test results show that on the dual - fuel engine the exhaust smoke is greatly reduced
並將開發的系統應用於洛拖lr6105q型柴油機，對柴油機的原機排放與摻燒lpg的排放進行了對比。 -
05. 01 smoke point of aviation turbine fuels, method of test for
航空渦輪燃油煙點測試方法 -
Standard test method for smoke point of kerosine and aviation turbine fuel
煤油和航空渦輪機燃料煙點的標準試驗方法 -
Methods of test for petroleum and its products - petroleum products - determination of the smoke point of kerosine
石油和石油產品的試驗方法.石油產品.煤油發煙點測定 -
Us epa smoke emission test cycle
美國煙排放物試驗循環 -
To help improve maintenance standard, emissions testing centres will use advanced dynamometer smoke test for light duty vehicles from september this year and for heavy duty vehicles next year
在測試設備方面，輕型車輛的黑煙測試中心會在九月安裝功率機，作測試之用。 -
Wa. smoke and heat control systems - part 4 : heat exhaust systems ; test methods
煙和熱控制系統.第4部分:排熱系統 -
Standard test method for heat and visible smoke release rates for materials and products using an oxygen consumption calorimeter
利用氧消耗熱量儀測定材料和產品的熱和可見煙霧釋放速率的標準試驗方法 -
Standard test method for smoke density in flue gases from burning distillate fuels
燃料餾分燃燒產生的煙道氣中煙密度的標準測試方法 -
Standard test method for effect of air supply on smoke density in flue gases from burning distillate fuels
空氣供給對燃料餾分燃燒產生的煙道氣中煙密度影響的標準試驗方法 -
Standard test method for measurement of smoke obscuration using a conical radiant source in a single closed chamber, with the test specimen oriented horizontally
使用錐形放射源在有水平放置試樣的單一密閉室內測量煙霧蒙朧性的標準試驗方法 -
The test result shows that we got the optimum emulsified diesel oil of definite mixing ratio by variance analysis of power smoke and consume oil
以發動機功率、耗油率和煙度的綜合評價值為指標進行方差分析，優選最佳的乳化油配比方案。 -
To 2 minutes in order to smoke test your load test
將「運行持續時間」設置為2分鐘，以便對負載測試執行冒煙測試。 -
Also known as a smoke test
也稱為冒煙測試。 -
Taked ratio of joined water on emulsions, quantify on emulsification and different emulsified technics as factor, 10 %, 20 %, 30 % and 40 % ratio of joined water, 0. 5 % and 1 % quantify on emulsification, two kind of emulsified technics of diesel oil added emulsification and water added emulsification as level, emulsion of eight kind different mixing ratio that are performed through rig test and smoke test is prepared by using the method of orthogonal array
以乳化油的摻水比例、乳化劑的添加量和不同的乳化工藝方法為因素，分別選擇10 、 20 、 30和40的摻水比例， 0 . 5和1的乳化劑添加量以及油+乳化劑和水+乳化劑兩種工藝方法為水平，採用正交試驗設計方案，配製了8種不同比例的乳化油，進行發動機臺架性能試驗和煙度檢測。 -
Variety rule and influence factor of smooth operation, satisfactory performances and smoke are analyzed on the test result that the optimum emulsified diesel oil compared diesel oil through rig test and smoke test. burning the optimum emulsified diesel oil compared diesel oil, satisfactory performances of fuel are improved 21. 3 %, smoke reduced43. 48 %
以燃用最佳配比乳化油與標準輕柴油的發動機臺架性能和煙度檢測對比試驗結果，分析了發動機燃用該種乳化油的動力性、經濟性和排放性的變化規律及其影響因素。 -
Because a smoke test must focus on validating only the functional changes in updated binaries, the test must run on a clean test environment by using the debug binaries for the files being tested
由於冒煙測試必須側重於僅對更新后的二進制文件中的功能更改進行驗證，所以必須通過使用被測試文件的調試二進制文件來使測試在干凈的測試環境中運行。
分享友人